THERMO-MECHANICAL BEHAVIOR OF METAL FOAMS IN THERMAL APPLICATIONS: A COMPUTATIONAL AND EXPERIMENTAL APPROACH

THERMO-MECHANICAL BEHAVIOR OF METAL FOAMS IN THERMAL APPLICATIONS: A COMPUTATIONAL AND EXPERIMENTAL APPROACH

محفوظ في:

التفاصيل البيبلوغرافية
المؤلف الرئيسي:	unknown (author)
التنسيق:	masterThesis
منشور في:	2020
الموضوعات:	Mechanical
الوصول للمادة أونلاين:	https://eprints.kfupm.edu.sa/id/eprint/139622/1/Thesis-g201303570.pdf
الوسوم:	إضافة وسم لا توجد وسوم, كن أول من يضع وسما على هذه التسجيلة!

مواد مشابهة

Thermo-mechanical modeling of tool and workpiece interface in metal forming process
حسب: Khan, Ovaisullah
منشور في: (2002)

Experimental investigation on the performance of a novel thermo-mechanical refrigeration system driven by an expander-compressor unit
حسب: Ahmad K. Sleiti (14778229)
منشور في: (2022)

Comparative experimental and modelling study of the thermal and thermo-mechanical properties of LLDPE/wax blends
حسب: Mafereka F. T. Mosoabisane (14151309)
منشور في: (2022)

Experimental investigations on the performance of a thermo-mechanical refrigeration system utilizing ultra-low temperature waste heat sources
حسب: Ahmad K. Sleiti (14778229)
منشور في: (2023)

Experimental investigation on the performance of a novel thermo-mechanical refrigeration system driven by an expander-compressor unit
حسب: Ahmad K., Sleiti
منشور في: (2022)

Efficient Photovoltaic Thermal Management by Thermo-Physically Enhanced Phase Change Materials
حسب: unknown
منشور في: (2020)

An Experimental Investigation on the Thermo-Rheological Behaviors of Lactic Acid-Based Natural Deep Eutectic Solvents
حسب: Yousef Elhamarnah (17869382)
منشور في: (2022)

Experimental investigations on the performance of a thermo-mechanical refrigeration system utilizing ultra-low temperature waste heat sources
حسب: Ahmad K., Sleiti
منشور في: (2023)

Thermally Conductive Polyethylene/Expanded Graphite Composites as Heat Transfer Surface: Mechanical, Thermo-Physical and Surface Behavior
حسب: Patrik Sobolčiak (4401364)
منشور في: (2020)

Advanced Thermal Management in Intermittent Electronics: Integrating Metal Foam and Phase Change Materials
حسب: Ahmad, Muhammad
منشور في: (2024)

MODELING RESIDUAL STRESS EVOLUTION IN THERMAL SPRAY COATINGS USING HYBRID COMPUTATIONAL APPROACH
حسب: unknown
منشور في: (2020)

ELECTRICAL AND THERMAL BEHAVIOR OF ALUMINA-BASED NANOCOMPOSITES
حسب: unknown
منشور في: (2020)

MECHANICAL PROPERTIES OF THERMAL SPRAY COPPER ALLOYS COATINGS
حسب: unknown
منشور في: (2020)

Thermo-mechanical Behavior of C45 Steel over a Range of Temperatures and Loading Rates
حسب: Saffarini, Mohammad Hassan
منشور في: (2016)

A thermodynamically consistent phase field model for brittle fracture in graded coatings under thermo-mechanical loading
حسب: R. Piska (18560701)
منشور في: (2024)

NUMERICAL AND EXPERIMENTAL ANALYSIS ON THERMAL STRESS MEASUREMENT OF SPIRAL WELDED PIPES
حسب: unknown
منشور في: (2020)

Experimentally validated thermo-mechanically coupled FE simulations of Al/Mg friction stir welded joints
حسب: Ammouri, A.H.
منشور في: (2017)

MODELING THE BEHAVIOR OF SULFUR MODIFIED FOAMED AND EMULSIFIED ASPHALT SOILS MIXES FOR LOCAL ROAD APPLICATIONS
حسب: unknown
منشور في: (2020)

Processing and thermal behavior of alumina hybrid nanocomposites
حسب: unknown
منشور في: (2020)

Heat transfer mechanisms governing laser metal interactions
حسب: Sami, Muhammad
منشور في: (1993)

Heat Transfer Mechanisms Governing Laser Metal Interactions
حسب: Sami, Muhammad
منشور في: (1993)

Forced vibration characteristics of embedded graphene oxide powder reinforced metal foam nanocomposite plate in thermal environment
حسب: Zheng, Jie
منشور في: (2021)

ENHANCING THE THERMAL INSULATION OF CONCRETE AND MASONRY HOLLOW CONCRETE BRICKS EXPERIMENTALLY AND ANALYTICALLY
حسب: unknown
منشور في: (2020)

Effect of bolt layout on the mechanical behavior of bolted joint
حسب: Khurshid, Hassan
منشور في: (2004)

An experimental investigation of heat transfer in the thermally developing region of a pulsating pipe flow.
حسب: Gbadebo, Semiu Adesina
منشور في: (1996)

Buckling and crushing behavior of foam-core hybrid composite sandwich columns under quasi-static edgewise compression
حسب: Arameh Eyvazian (16500978)
منشور في: (2019)

DEVELOPMENT OF THERMO-CHEMICAL MODEL AND EXERGETIC ASSESSMENT OF A BIOMASS DERIVED SYNGAS FUELED COMBINED CYCLE FOR COGENERATION OF POWER AND COOLING
حسب: unknown
منشور في: (2020)

Multi-stage Bubble Column Humidifier for Thermal Driven Mechanical Compression Humidification Dehumidification Desalination System
حسب: unknown
منشور في: (2020)

In-Vitro Degradation of Hollow Silica Reinforced Magnesium Syntactic Foams in Different Simulated Body Fluids for Biomedical Applications
حسب: Manakari, Vyasaraj
منشور في: (2020)

OPTIMIZING A COMPUTER VISION ALGORITHM OF A ROBOTIC ARM FOR PRODUCT SORTING THROUGH PICK AND PLACE MECHANISM
حسب: unknown
منشور في: (2020)

Theoretical and computational modeling of thermal properties of lightweight concrete
حسب: Ayman Karaki (14779591)
منشور في: (2021)

Computational Aspects of a Multiscale Modeling Approach for Heterogeneous Materials under Multiphysics Loadings
حسب: unknown
منشور في: (2020)

Influence of thermo-mechanical properties of coatings on friction in elastohydrodynamic lubricated contacts
حسب: Habchi, W.
منشور في: (2015)

Degradation Mechanisms of Thermal Barrier Coatings Used in Land-Based Gas Turbine Blades Exposed to Low-Grade Fuel Impurities
حسب: unknown
منشور في: (2020)

Development of Graphene Reinforced UHMWPE Nanocomposite Coatings for Mechanical Bearing Applications
حسب: unknown
منشور في: (2020)

Evaluation of the Effectiveness of Alkaline-earth metal oxides in Inhibiting Vanadium-induced Hot Corrosion of Yttria-stabilized Zirconia Thermal Barrier Coatings (TBCs)
حسب: unknown
منشور في: (2020)

Dynamics of a four-bar mechanism with clearance and springs - Modeling and experimental analysis
حسب: Ahmedalbashir, Mona Abdullah Hassan
منشور في: (2017)

Hydrothermal and irreversibility numerical analysis of helical coil energy storage tank with nano-encapsulated PCMs: A comprehensive study with magnetic filled, Soret/Dufour, and metallic foam effects
حسب: Mohammed Azeez Alomari (20482592)
منشور في: (2025)

CORROSION BEHAVIOR OF POWDER METALLURGY ALUMINUM ALLOY 6061/AL2O3 METAL MATRIX COMPOSITES
حسب: Gasem, Zuhair M.
منشور في: (2020)

THERMAL ANALYSIS OF THERMOELECTRIC POWER GENERATOR; INCLUDING THERMAL STRESSES
حسب: unknown
منشور في: (2020)