DEVELPMENT OF A NEW COST-EFFECTIVE POLYMER GEL FOR WATER CONTROL IN OIL AND GAS WELLS

DEVELPMENT OF A NEW COST-EFFECTIVE POLYMER GEL FOR WATER CONTROL IN OIL AND GAS WELLS

محفوظ في:

التفاصيل البيبلوغرافية
المؤلف الرئيسي:	unknown (author)
التنسيق:	masterThesis
منشور في:	2020
الموضوعات:	Chemical Engineering Petroleum
الوصول للمادة أونلاين:	https://eprints.kfupm.edu.sa/id/eprint/139088/1/Khalid_Elkarsani-PhD_Thesis.pdf
الوسوم:	إضافة وسم لا توجد وسوم, كن أول من يضع وسما على هذه التسجيلة!

مواد مشابهة

DEVELOPMENT OF EMULSIFIED GELS FOR WATER CONTROL IN OIL AND GAS WELLS
حسب: unknown
منشور في: (2020)

Improving standstone matrix stimulation for oil wells by gas preconditioning.
حسب: Al-Muhareb, Mohammed Ahmed
منشور في: (1999)

Study of Cross-linked Polymer Gel Systems for potential use as Loss Prevention Agents
حسب: unknown
منشور في: (2020)

The Effect of multiple fractures on the performance of gas wells
حسب: Mimoune, Kissami
منشور في: (1990)

STUDY OF POLYMER-SURFACTANT INTERACTIONS FOR CHEMICAL ENHANCED OIL RECOVERY IN CARBONATE RESERVOIRS
حسب: unknown
منشور في: (2020)

EFFECT OF NANO CLAY ON OIL WELL CEMENT PROPERTIES FOR HIGH PRESSURE AND TEMPERATURE APPLICATIONS
حسب: unknown
منشور في: (2020)

Evaluation of Nano Zeolite as an Additive for Oil-Well Cementing
حسب: unknown
منشور في: (2020)

The Effect of retarder on gelation time and stability of polyacrylamide chromium (III) gel system.
حسب: Al-Nashmi, Muhammad Hasan Muhammad.
منشور في: (1997)

The Effect of injected water salinity on oil recovery
حسب: Al-Mumen, Adib Aabdul-Muhsen
منشور في: (1990)

OIL WELL CEMENT WITH CARBON NANOTUBE FOR HIGH PRESSURE HIGH TEMPERATURE APPLICATIONS
حسب: unknown
منشور في: (2020)

A Parametric study of water-coning in horizontal wells
حسب: Hakim, Ali Abbas
منشور في: (1994)

SIMULATION OF GAS FLOW, SAND TRANSPORT AND WELLBORE EROSION IN HORIZONTAL WELLS
حسب: unknown
منشور في: (2020)

CHARACTERIZATION OF OIL WATER FLOW IN HORIZANATAL PIPES
حسب: unknown
منشور في: (2020)

INVESTIGATION OF POOR CEMENTING BEHIND OIL WELL CASING BETWEEN ARAB-C AND D FORMATIONS IN UTHMANYIA
حسب: unknown
منشور في: (2020)

Corrosivity of water-base drilling fluids in deep, hot wells
حسب: Shokoya, Olawale Surajudeen
منشور في: (1994)

Effect of formation damage on horizontal well performance.
حسب: Hasan, Syed Sajid
منشور في: (1999)

Investigation of the production performance of horizontal wells in fractured bottom water drive reservoirs
حسب: Kandil, Ahmed A.
منشور في: (1993)

DEVELOPMENT OF A POLYMER FOR GREEN ENHANCED OIL RECOVERY
حسب: unknown
منشور في: (2020)

Synthesis and characterization of cost-effective Chabazite (CHA) zeolite catalysts for the conversion of methanol to olefins (MTO) process
حسب: unknown
منشور في: (2020)

A New dewpoint pressure correlation for gas-condensate systems
حسب: Humoud, Abdrabbalamir Abdallah
منشور في: (2001)

Maximizing Light Olefins Yield from the fluid catalytic cracking of whole crude oil
حسب: unknown
منشور في: (2020)

Abdulla F. AL-Dossary (2011) INVESTIGATION OF POOR CEMENTING BEHIND OIL WELL CASING BETWEEN ARAB-C AND D FORMATIONS IN UTHMANYIA
حسب: unknown
منشور في: (2020)

Design of an Alkaline/Surfactant/Polymer enhanced oil recovery scheme for a Saudi Arabian limestone reservoir
حسب: Eme, Vincent Obiora
منشور في: (1994)

Development of empirical equations for water-oil relative permeability
حسب: Al-Fattah, Saud Mohammed A.
منشور في: (1994)

THERMAL AND CATALYTIC CRACKING OF ARABIAN LIGHT CRUDE OIL TO LIGHT OLEFINS
حسب: unknown
منشور في: (2020)

Experimental investigation of various physical factors affecting the stability of water-in-oil emulsions in oil production
حسب: Al-Jaziri, Abdul Karim Mohammad
منشور في: (1995)

Application of neural network to the determination of well-test interpretation model for horizontal wells
حسب: Sultan, Mir Asif
منشور في: (2001)

Effect of drilling fluid particle sizes on formation damage: application to horizontal well
حسب: Mohammed, Aman Hassen
منشور في: (2001)

A PARETO FRONTIER WELL PLACEMENT AND RATE OPTIMIZATION
حسب: unknown
منشور في: (2020)

EFFECT OF INCLINATION, WATER CUT, BETA RATIO AND VISCOSITY ON VENTURI PRESSURE DROP MEASUREMENTS FOR OIL-WATER FLOW EXPERIMENTS
حسب: unknown
منشور في: (2020)

Hydrogen and Value-Added Chemicals from Catalytic Pyrolysis of Crude Oil using Microwave Heating
حسب: unknown
منشور في: (2020)

Identification of Discontinuous Oil Bearing Sandstone Bodies by Direct Modeling: Risk Analysis for Well Planning
حسب: unknown
منشور في: (2020)

Evaluation of Drilling Designs for Smart MRC Wells Applied in Saudi Aramco
حسب: unknown
منشور في: (2020)

DEVELOPMENT OF AN ENVIRONMENT-FRIENDLY OIL-BASED MUD USING CANOLA OIL
حسب: unknown
منشور في: (2020)

An experimental study of oil recovery from tarmat reservoirs using hot water and solvent flooding
حسب: Okasha, Taha Moustafa Hamed
منشور في: (1995)

Interference testing using horizontal wells in anisotropic reservoirs
حسب: Adebowale, Awotunde Abeeb
منشور في: (2006)

Investigation of horizontal well performance using Hele-Shaw model.
حسب: Khan, Irfan Sami
منشور في: (1998)

Optimization of horizontal well completion : (position, length and perforation scenarios).
حسب: Al-Gahtani, Abdallah M.
منشور في: (1997)

Effect of a hydraulic fracture on the performance of a layered gas condensate reservoir.
حسب: Hashmi, Syed Shariq
منشور في: (2000)

Effect of liquid rop-out on the productivity of a rich gas condensate reservoir.
حسب: Fawumi, Olalekan Kayode
منشور في: (1999)

Cannot write session to /tmp/vufind_sessions/sess_3c9a9o1ujdok0t479c8osptulq