Modification of Pd/CeO2 catalyst by Atomic Layer Deposition of ZrO2 حسب Onn, Tzia Ming

"…Modification of a 1 wt% Pd/CeO2 catalyst by Atomic Layer Deposition of thin ZrO2 films was studied. …"
احصل على النص الكامل
احصل على النص الكامل

Reactive Absorption of CO2 Using Ethylaminoethanol Promoted Aqueous Potassium Carbonate Solvent حسب Bhosale, Rahul Rambhau

"…The H_(CO2) was observed to be decreased by 5 and 31% due to the increase in the EAE concentration from 0.6 to 2 kmol/m3 and reaction temperature from 303 to 318 K, respectively. …"
احصل على النص الكامل
احصل على النص الكامل

Electronic vs Ionic limitations to electrochemical performance in Li4Ti5O12-based organic suspensions for lithium-redox flow batteries حسب Madec, L.

احصل على النص الكامل
احصل على النص الكامل
احصل على النص الكامل

Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites حسب Ahamad, N.

"…Aluminium matrix reinforced with aluminium oxide?titanium oxide (2.5, 5.0, 7.5 and 10 wt.%) in equal proportion were prepared by stir casting. …"
احصل على النص الكامل
احصل على النص الكامل

Role of TiO2 and carbon nanotubes on polyethylene, and effect of accelerated weathering on photo oxidation and mechanical properties حسب Zagho M.M.

"…Addition of CNTs had negligible effect on the tensile strength but it kept the same approximate value of the original before the accelerated weathering (e.g., 23.2 MPa for 1 wt% of CNTs). CNTs also protected the samples even with the presence of TONPs because of the absorbance and antioxidants effects. …"
احصل على النص الكامل
احصل على النص الكامل

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles حسب Chamakh, Mariem

احصل على النص الكامل
احصل على النص الكامل

Biodegradable polysaccharide grafted polyacrylamide inhibitor for corrosion in CO2- saturated saline solution حسب Jalab, Rem

"…Electrochemical tests of Tafel and AC impedance, were used to determine the corrosion rate of carbon steel (C-steel) and protection efficiency in CO2-saturated 3.5 wt% NaCl solution. The surface morphology was characterized using FESEM coupled with EDX. …"
احصل على النص الكامل
احصل على النص الكامل

Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings حسب Ubaid F.

"…Various contents of the encapsulated TiO2 nanotubes (1, 3 and 5 wt%) were thoroughly dispersed into the epoxy matrix and the resulting composites were then applied on a cleaned steel substrate using doctor blade technique to develop smart coatings. …"
احصل على النص الكامل
احصل على النص الكامل

Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites حسب Mittal, P.

"…The aim of the present study is to investigate the structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites. Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. …"
احصل على النص الكامل
احصل على النص الكامل

Synthesis and characterisation of Co2+-incorporated ZnO nanoparticles prepared through a sol-gel method حسب Ba-Abbad, Muneer M.

"…The band gap of the Co2+-doped ZnO samples decreased from 3.19 to 2.66 eV as the content of dopant Co2+ increased from 0.0 to 1.0 wt.%. …"
احصل على النص الكامل
احصل على النص الكامل

Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites حسب Ahamad, N.

"…Aluminium matrix reinforced with Al2O3–carbon (2.5, 5, 7.5 and 10 wt.%) in equal proportion was prepared by stir casting. …"
احصل على النص الكامل
احصل على النص الكامل

Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites حسب Ahamad, Naseem

"…Al2O3-SiC (2.5 wt.%, 5.0 wt.%, 7.5 wt.% and 10.0 wt.%) in relative and symmetrical proportion. …"
احصل على النص الكامل
احصل على النص الكامل

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures حسب Mittal, Prateek

"…The properties of the prepared MMCs were found to be dependent on the reinforcements content present in the MMCs. ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …"
احصل على النص الكامل
احصل على النص الكامل
احصل على النص الكامل

دراسة تأثير تركيز تيترا أيزوبروبكسيد التيتانيوم (TTIP) على بعض مواصفات ألياف ثنائي أكسيد التيتانيوم النانوية المغزولة كهربائياً... حسب طهماز, غزل

احصل على النص الكامل

ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY حسب MESLAM, MENTALLAH MOHAMED HASSANIN MOHAMED HASSANIN

"…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …"
احصل على النص الكامل

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study حسب Hamza A.

احصل على النص الكامل
احصل على النص الكامل
احصل على النص الكامل

Influence of nitrogen doping on the electrocatalytic activity of Ni-incorporated carbon nanofibers toward urea oxidation حسب Barakat, Nasser A.M.

"…However, the electrochemical measurements indicated that the content of the urea in the initial electrospun solution should be optimized as the results showed that the best nickel surface activation as well as the maximum observed current density can be achieved when the urea content is kept at 5 wt%. Typically, the observed current densities using 1.0 M urea (in 1 M KOH) were 3.15, 29.7, 13.75, 47.55, 14.13 and 9.85 mA/cm2 for the nanofibers obtained from electrospun solutions having 0, 1, 2, 5, 7 and 9 wt% urea, respectively. …"
احصل على النص الكامل
احصل على النص الكامل

Optimization of performance and emission characteristics of CI engine fueled with Jatropha biodiesel produced using a heterogeneous catalyst (CaO) حسب Singh, A.

"…The heterogeneous transesterification delivered a yield of 81.6% at 5 wt% catalyst concentration and 12:1 methanol to oil molar ratio. …"
احصل على النص الكامل
احصل على النص الكامل

Morphology, nucleation, and isothermal crystallization kinetics of poly(butylene succinate) mixed with a polycarbonate/MWCNTs masterbatch حسب Gumede, Thandi P.

"…The nanocomposites contained 0.5, 1.0, 2.0, and 4.0 wt% MWCNTs. Differential scanning calorimetry (DSC), small angle X-ray scattering (SAXS) and wide angle X-ray scattering (WAXS) results indicate that the blends are partially miscible, hence they form two phases (i.e., PC-rich and PBS-rich phases). …"
احصل على النص الكامل
احصل على النص الكامل

Morphology, Nucleation, and Isothermal Crystallization Kinetics of Poly(ε-caprolactone) Mixed with a Polycarbonate/MWCNTs Masterbatch حسب Gumede, Thandi P.

"…The nanocomposites contained 0.5, 1.0, 2.0, and 4.0 wt % MWCNTs. Even though PCL and PC have been reported to be miscible, our DSC (Differential Scanning Calorimetry), SAXS (Small Angle X-ray Scattering), and WAXS (Wide Angle X-ray Scattering) results showed partial miscibility, where two phases were formed (PC-rich and PCL-rich phases). …"
احصل على النص الكامل
احصل على النص الكامل