يعرض 1 - 20 نتائج من 113 نتيجة بحث عن '(( 5 ppm decrease ) OR ((( 50 ns decrease ) OR ((( 5 w decrease ) OR ( 5 nn decrease ))))))', وقت الاستعلام: 0.21s تنقيح النتائج
  1. 1
  2. 2
  3. 3

    Wind energy potential along the onshore and offshore Qatar حسب Mohammed, Aboobacker Valliyil

    منشور في 2020
    "…Among the select locations, the highest annual mean wind power density is obtained in the o?shore Ruwais (152 W/m2), followed by o?shore Ras La?an (134 W/m2) and land area of Al Khor (120 W/m2). …"
    احصل على النص الكامل
    احصل على النص الكامل
  4. 4
  5. 5

    Enhanced oil recovery using hyperbranched polyglycerol polymer-coated silica nanoparticles حسب Elmobarak W.F.

    منشور في 2021
    "…dem improved as the Csur and pH decreased, with maximum values of 98.8% and 98.5% achieved at Csur = 0.05 g/L and a pH = 4, respectively. …"
    احصل على النص الكامل
    احصل على النص الكامل
  6. 6
  7. 7
  8. 8
  9. 9
  10. 10

    Application of Fe3O4 magnetite nanoparticles grafted in silica (SiO2) for oil recovery from oil in water emulsions حسب Elmobarak W.F.

    منشور في 2021
    "…Using an MDdose as low as 10 mg/L attained a %ηdem in the range of 93%–94.3% for O/W mixtures with Coil < 2000 mg/L, which slightly decreased to ∼90% for higher concentrations. …"
    احصل على النص الكامل
    احصل على النص الكامل
  11. 11
  12. 12
  13. 13
  14. 14
  15. 15
  16. 16

    Functionalization of silica-coated magnetic nanoparticles as powerful demulsifier to recover oil from oil-in-water emulsion حسب Elmobarak W.F.

    منشور في 2021
    "…This study presents an innovative approach for the preparation of Fe3O4 nanoparticles covered with SiO2 shell (denoted as Fe–Si-MNP), which were used to recover oil recovery from oil-in-water emulsion (O/W-emul). The Fe–Si-MNP were prepared with differing silica layer thicknesses (5 nm [Fe–Si-1], 8 nm [Fe–Si-2], 10 nm [Fe–Si-3], and 15 nm [Fe–Si-4]) and tested for the percentage of oil separation (%Soil) under different dosages (DMNP), oil concentration (Doil), surfactant dosages (Dsur), and pH. …"
    احصل على النص الكامل
    احصل على النص الكامل
  17. 17

    Optimization of performance and emission characteristics of CI engine fueled with Jatropha biodiesel produced using a heterogeneous catalyst (CaO) حسب Singh, A.

    منشور في 2020
    "…The optimum performance and emission characteristics (BP, BTHE, HC and NOx) are found to be 2.258 KW, 29.05%, 6.31 ppm, and 159.5 ppm respectively. The performance of B20 fueled engine was almost comparable to that of diesel fuel. …"
    احصل على النص الكامل
    احصل على النص الكامل
  18. 18

    Reinforcement of polyacrylamide-co-tert-butyl acrylate base gel using nanosilica for conformance control at low and high reservoir temperatures حسب Shamlooh M.

    منشور في 2020
    "…In this study, different ratios of polymer to crosslinker were investigated to choose the optimum combination. Then, nanosilica (NS) with different sizes (20, 50 and 85 nm) was added to the polymeric formulation with the inorganic crosslinker (CrAc3) to study the effect of silica content and size on gel strength. …"
    احصل على النص الكامل
    احصل على النص الكامل
  19. 19

    The Separation of Emulsified Water/Oil Mixtures through Adsorption on Plasma-Treated Polyethylene Powder حسب Abdulkareem, Asma

    منشور في 2021
    "…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …"
    احصل على النص الكامل
    احصل على النص الكامل
  20. 20

    Effect of outdoor temperature on the power-conversion efficiency of newly synthesized organic photosensitizer based dye-sensitized solar cells حسب Mehmood U.

    منشور في 2018
    "…The results indicate that DSSC shows power conversion efficiency of 2.58% at 25 °C under air mass (AM) 1.5 G illumination at 100 mW/cm2. It has also been found out that the efficiency of DSSCs drops with the rise of temperature. …"
    احصل على النص الكامل
    احصل على النص الكامل