Magnesium-reinforced PMMA composite scaffolds: Synthesis, characterization, and 3D printing <i>via</i> stereolithography حسب Ambreen Afridi (22224310)

"…Notably, pure PMMA exhibited the highest tensile strength, 26.23 ± 0.14 MPa and an elastic modulus of 707.81 MPa, while PMMA resin/1% Mg showed the lowest strength (19.46 ± 0.25 MPa) and modulus (392.88 MPa), indicating a decrease in mechanical integrity with higher Mg content. …"

Insights Into SARS-CoV-2 S1-RBD-ACE2 Interaction Using Computational Tools and Membrane Microarray Platform حسب Angelin Mary Philip (21547421)

"…This revealed clustering of S1-RBD on membrane and more importantly, a depletion of the Omicron S1-RBD from membrane corrals, which was not seen with the WT S1-RBD. …"

Ablation of LAT2 Transporter Causes Intramuscular Glutamine Accumulation and Inhibition of Fasting‐Induced Proteolysis حسب Meritxell Espino‐Guarch (22565774)

"…To characterise the impact on muscle degradation, we tested LAT2 KO mice in cancer‐associated cachexia, streptozocin‐induced Type‐1 diabetes, and ageing models.</p><h3>Results</h3><p dir="ltr">LAT2KO mice experienced a notable reduction in body weight during fasting (WT:14% and LAT2KO:18%, <i>p</i> = 0.02), with a greater reduction in fat mass (0.5‐fold, <i>p</i> = 0.013) and a higher relative retention of muscle mass (1.3‐fold, <i>p</i> = 0.0003) compared with WT. …"

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles حسب Mariem Chamakh (14150481)

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide‐based gels: Rheological and molecular simulation study حسب Ahmed Hamza (7224470)

"…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …"

Corrosion Evaluation of 316L Stainless Steel Exposed to CNT-Water Nanofluid حسب Dana Abdeen (18147583)

"…A maximum inhibition of 61% was achieved in 0.1 wt.% CNTs nanofluid at room temperature. Further increase in the CNTs concentrations and in nanofluid’ temperature showed to decrease the corrosion performance.…"

Comprehensive thermoeconomic, exergoeconomic, and optimization analyses of direct oxy‐combustion supercritical CO₂ intercooled and reheated cycles under design and off‐d... حسب Wahib A. Al‐Ammari (18877408)

"…At off‐design conditions with a power demand (PD) of 40% of the design load (50 MW), the thermal efficiency is decreased by 21.82% in DRC, 17.71% in ICC, 22.46% in PIC, and 13.60% in RHC. …"

A lipidomic screen of hyperglycemia-treated HRECs links 12/15-Lipoxygenase to microvascular dysfunction during diabetic retinopathy via NADPH oxidase حسب Ahmed S. Ibrahim (10049522)

"…Fluorescein angiography and retinal albumin leakage showed a significant decrease in retinal hyperpermeability in streptozotocin-induced diabetic mice lacking 12/15-LOX compared with diabetic WT mice. …"

Isothermal Crystallization Kinetics and Morphology of Double Crystalline PCL/PBS Blends Mixed with a Polycarbonate/MWCNTs Masterbatch حسب Thandi P. Gumede (18112762)

"…The nanocomposites contained 1.0 and 4.0 wt% MWCNTs. The blends showed a sea-island morphology typical of immiscible blends. …"

SARS‐CoV‐2 infection triggers more potent antibody‐dependent cellular cytotoxicity (ADCC) responses than mRNA‐, vector‐, and inactivated virus‐based COVID‐19 vaccines حسب Hadeel T. Zedan (12535521)

"…We analyzed ADCC activity targeting SARS‐CoV‐2 spike (S) and nucleocapsid (N) proteins in convalescent sera following WT SARS‐CoV‐2‐infection (<i>n</i> = 91), including symptomatic and asymptomatic infections, omicron‐infection (<i>n</i> = 8), COVID‐19 vaccination with messenger RNA‐ (mRNA)‐ (BNT162b2 or mRNA‐1273, <i>n</i> = 77), adenovirus vector‐ (<i>n</i> = 41), and inactivated virus‐ (<i>n</i> = 46) based vaccines, as well as post‐mRNA vaccination BTI caused by omicron (<i>n</i> = 28). …"

Improved properties and salt rejection of polysulfone membrane by incorporation of hydrophilic cobalt-doped ZnO nanoparticles حسب Muneer M. Ba-Abbad (14151660)

"…<p dir="ltr">In this study, the nanoparticles (NPs) of ZnO and Co²⁺ ions doped ZnO (doped ZnO) were incorporated into a matrix of polysulfone (PSf) membranes to enhance their surface properties prepared using a simple wet phase inversion technique. The hybrid PSf membranes were fabricated with 0.5 wt. % of ZnO and doped ZnO NPs. …"

Investigating the Role of FOXA2 Transcription Factor in Adipogenesis Using Human-Induced Pluripotent Stem Cells حسب Hafsa Madni (22674428)

"…Therefore, in this study, we aimed to investigate the role of <i>FOXA2</i> in adipogenesis using previously established wild-type induced pluripotent stem cells (WT-iPSCs) and <i>FOXA2</i> knockout iPSCs (FOXA2 KO iPSCs). …"

Performance comparison of different flow arrangements of 4-fluid internally-cooled liquid desiccant dehumidifiers حسب Ali Pakari (14158902)

"…The approximate difference between the best and poorest performing flow arrangements in terms of the decrease in supply air humidity ratio and enthalpy is 4.3% and 10.5%, respectively. …"

Stability and thermophysical properties test of carbide-derived carbon thermal fluid; a comparison between functionalized and emulsified suspensions حسب Ismail W. Almanassra (14151321)

"…The results demonstrated that the thermal conductivity enhancement was independent of temperature, decreases with gum-Arabic concentration, and significantly enhanced with CDC loading with a maximum enhancement of 26.1% for 0.3 wt% functionalized CDC. …"

SynergyGrids: blockchain-supported distributed microgrid energy trading حسب Moayad Aloqaily (14158932)

"…The trading system shows 17.8% decrease in energy cost for consumers and 76.4% decrease in load over utility grids when compared with its counterparts.…"

An Experimental Investigation of the Effects of Dressing and Grinding Parameters on Sustainable Grinding of Inconel 738 Used for Automated Manufacturing حسب Mohammadjafar Hadad (17541345)

"…The results indicate that the MQL technique increases the grinding performance of Inconel 738 by reducing ground workpiece surface roughness and decreasing the coolant–lubricant consumption comparing to the conventional wet grinding process. …"

Engineering the Surface and Mechanical Properties of Water Desalination Membranes Using Ultralong Carbon Nanotubes حسب Yehia M. Manawi (18091207)

"…More pronounced effect on membrane’s mechanical properties was observed due to compatibility of CNTs with PS matrix when compared to other factors (i.e., changes in the CNT aspect ratio). The water contact angle for PS membranes incorporated with commercial CNT sharply decreased from 73° to 53° (membrane hydrophilization) for membranes with 0.1 and 1.0 wt. % of CNTs, while for the same loading of produced CNTs the water contact angles for the membrane samples increased from 66° to 72°. …"

A kinetic evaluation of nutrient and organic matter removal in greywater for green Walls: Assessing the performance of Mineral-Based, Organic, and Waste-Derived plant support media حسب Shaheeda Marakkar Anangadan (19239607)

"…TOC and COD kinetics were best fitted by the pseudo-first-order model across all media except COD for SCG. …"

Association between thermal responses, medical events, performance, heat acclimation and health status in male and female elite athletes during the 2019 Doha World Athletics Champi... حسب Sebastien Racinais (318896)

"…Performance (% personal best) and did not finish (DNF) were extracted from official results.…"

Effect of Surface Treatment of Halloysite Nanotubes (HNTs) on the Kinetics of Epoxy Resin Cure with Amines حسب Vahideh Akbari (18768001)

"…Nonisothermal differential scanning calorimetry (DSC) analyses were performed on epoxy nanocomposites containing 0.1 wt.% of P-HNT, A-HNT, and F-HNT. Quantitative analysis of the cure kinetics of epoxy/amine system made by isoconversional Kissinger–Akahira–Sunose (<i>KAS</i>) and <i>Friedman</i> methods made possible calculation of the activation energy (<i>E</i>_α) as a function of conversion (α). …"