يعرض 1 - 20 نتائج من 448 نتيجة بحث عن '(( greater decrease ) OR ((( teer decrease ) OR ((( after decrease ) OR ( stir decrease ))))))', وقت الاستعلام: 0.16s تنقيح النتائج
  1. 1
  2. 2

    Underwater friction stir welding of Al-Mg alloy: Thermo-mechanical modeling and validation حسب Talebizadehsardari, Pouyan

    منشور في 2021
    "…To better understand the effects of the water environment, the results were compared with conventional friction stir welding (FSW) conditions. Thermal profile and surface heat flux results revealed that lower preheated area (PHA) at the leading edge (LE) decreased the total amount of frictional heat generation in the UFSWed joint. …"
    احصل على النص الكامل
    احصل على النص الكامل
  3. 3

    Simulation and experimental study of underwater dissimilar friction-stir welding between aluminium and steel حسب Eyvazian, Arameh

    منشور في 2020
    "…The volume of fluid (VOF) modeling method was implemented to simulate the underwaterfriction-stir welding (FSW) process for dissimilar joining between aluminum and steel. …"
    احصل على النص الكامل
    احصل على النص الكامل
  4. 4

    Assessment of Urban Heat Islands Based on the Relationship Between Land Surface Temperature and Land Use/Land Cover in Greater Doha حسب Siddiqui, Simil Amir

    منشور في 2020
    "…Overall there was an increase in built-up and vegetation, decrease in water and barren areas and complete loss of marsh land. …"
    احصل على النص الكامل
    احصل على النص الكامل
  5. 5
  6. 6
  7. 7
  8. 8
  9. 9
  10. 10
  11. 11

    Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites حسب Ahamad, N.

    منشور في 2020
    "…Density of composite decreases due to variation of reinforcement and it shows low density after preheating. …"
    احصل على النص الكامل
    احصل على النص الكامل
  12. 12
  13. 13
  14. 14

    Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites حسب Ahamad, Naseem

    منشور في 2021
    "…Al2O3-SiC after that it decreases. Impact strength of hybrid composite has been increased with an increase in weight percentage of ceramic. …"
    احصل على النص الكامل
    احصل على النص الكامل
  15. 15

    Quality improvement can decrease blood delivery turnaround time: Evidence from a single tertiary-care academic medical center حسب Hammad Y.A.

    منشور في 2018
    "…The transport time significantly decreased from an initial majority of > 15 mins duration, to a majority of < 15 mins transport time after the second audit; there was a 50% improvement in 30 mins response time; and the percentage of requests processed in < 10 mins were significantly higher after the second audit. …"
    احصل على النص الكامل
  16. 16

    Microstructural, tribological and compression behaviour of Copper matrix reinforced with Graphite-SiC hybrid composites حسب Jamwal, A.

    منشور في 2020
    "…Compressive strength of composites is tested using Universal testing machine and showed a decrease in value with increase in graphite content. …"
    احصل على النص الكامل
    احصل على النص الكامل
  17. 17
  18. 18

    Viscous Behavior of Dilute CMC Salt Solution Before and After Photodegradation حسب El Ashhab, F. [فتحي الأشهب]

    منشور في 2006
    "…Densities and solution viscosities of very dilute CMC salt solution before and after UV-irradiation have been measured. UV-irradiation of CMC decreases the values of density, specific, reduced and intrinsic viscosities, molar mass, hydrodynamic volume, expansion factor, real and ideal chain dimensions of CMC in solution. …"
    احصل على النص الكامل
  19. 19

    Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites حسب Mittal, P.

    منشور في 2020
    "…Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. Phase, microstructure, density, hardness, wear, compressive strength and specific heat of prepared samples have been investigated. …"
    احصل على النص الكامل
    احصل على النص الكامل
  20. 20