Underwater friction stir welding of Al-Mg alloy: Thermo-mechanical modeling and validation by Talebizadehsardari, Pouyan

“…To better understand the effects of the water environment, the results were compared with conventional friction stir welding (FSW) conditions. Thermal profile and surface heat flux results revealed that lower preheated area (PHA) at the leading edge (LE) decreased the total amount of frictional heat generation in the UFSWed joint. …”
Get full text
Get full text

Simulation and experimental study of underwater dissimilar friction-stir welding between aluminium and steel by Eyvazian, Arameh

“…The volume of fluid (VOF) modeling method was implemented to simulate the underwaterfriction-stir welding (FSW) process for dissimilar joining between aluminum and steel. …”
Get full text
Get full text

Study on the effects of tool tile angle, offset and plunge depth on friction stir welding of poly(methyl methacrylate) T-joint by Eyvazian, Arameh

“…These holes and degradation of poly(methyl methacrylate) during friction stir welding process decrease strength and hardness of the joint. - IMechE 2019.…”
Get full text
Get full text

Microstructure, wear and corrosion characteristics of Cu matrix reinforced SiC–graphite hybrid composites by Jamwal A.

“…Hardness was found to decrease with the addition of graphite due to its soft nature. …”
Get full text
Get full text

Optimum design of n continuous stirred-tank bioreactors in series for fermentation processes based on simultaneous substrate and product inhibition by Abu Reesh, I.M.

Get full text
Get full text
Get full text

Hyperhydration-induced decrease in urinary luteinizing hormone concentrations of Male athletes in doping control analysis by Athanasiadou, Ioanna

“…Baseline urinary LH concentrations, expressed as the mean � SD for each individual, were within the acceptable physiological range (7.11 � 5.42 IU/L). …”
Get full text
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…The MMCs were prepared using stir casting technique. The composite material was developed for its application in thermal management structures. …”
Get full text
Get full text
Get full text

Biochar of spent coffee grounds as per se and impregnated with tio2: Promising waste-derived adsorbents for balofloxacin by El-Azazy, Marwa

Get full text
Get full text
Get full text

Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites by Ahamad, N.

“…Hardness decreases due to variation of carbon since it has soft nature. …”
Get full text
Get full text

Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites by Ahamad, N.

“…Hardness decreases due to the amalgamation of reinforcements. …”
Get full text
Get full text

Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites by Ahamad, Naseem

“…Al-Al2O3-SiC hybrid composite has been developed through stir casting with addition of ceramics i.e. Al2O3-SiC (2.5 wt.%, 5.0 wt.%, 7.5 wt.% and 10.0 wt.%) in relative and symmetrical proportion. …”
Get full text
Get full text

Microstructural, tribological and compression behaviour of Copper matrix reinforced with Graphite-SiC hybrid composites by Jamwal, A.

“…Compressive strength of composites is tested using Universal testing machine and showed a decrease in value with increase in graphite content. …”
Get full text
Get full text

Adaptive thermal comfort in the different buildings of Darjeeling Hills in eastern India – Effect of difference in elevation by Thapa, Samar

“…Whereas, the mean comfort temperature decreased with the elevation of the location and this difference was also statistically significant, t = −92.34 (df = 2607, p < 0.001). …”
Get full text
Get full text

Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites by Mittal, P.

“…Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. Phase, microstructure, density, hardness, wear, compressive strength and specific heat of prepared samples have been investigated. …”
Get full text
Get full text

Influence of temperature on tire-pavement noise in hot climates: Qatar case by Okan, Sirin

“…There is an apparent trend of decreasing temperature coefficient with increasing mean texture depth of dense graded asphalt pavements. …”
Get full text
Get full text
Get full text

Influence of temperature on tire-pavement noise in hot climates: Qatar case by Okan, Sirin

“…There is an apparent trend of decreasing temperature coefficient with increasing mean texture depth of dense graded asphalt pavements. …”
Get full text
Get full text
Get full text

Maximum Likelihood Estimation in the Inverse Weibull Distribution with Type II Censored Data by Alshaikh, Fatima A.

“…We found that the parameter estimators are almost unbiased, while the MRL and TVaR estimators are asymptotically unbiased. Moreover, the mean squared error of all estimators decreased for larger sample sizes and it increased when the censoring proportion is increased for a fixed sample size. …”
Get full text
Get full text
Get full text

Understanding the mechanisms mediating cardio-renal benefit of empagliflozin in type 2 diabetes mellitus by Dimitrios, Patoulias

“…They have demonstrated1 that empagliflozin treatment resulted in a significant decrease in pulse pressure (PP), mean arterial pressure (MAP) and cardiac workload, compared with placebo; at week 12, placebo-adjusted mean changes from baseline were − 2.5 mmHg for PP, − 2.2 mmHg for MAP and − 315 mmHg x beats per minute (bpm) for cardiac workload (p < 0.0001 for all). …”
Get full text
Get full text
Get full text

CLINICAL AND ECONOMIC IMPACT OF GENETIC AND NON-GENETIC FACTORS ON INR NORMALIZATION IN PRE-OPERATIVE MANAGEMENT OF WARFARIN PATIENTS by ELJILANY, ISLAM AHMED SAYED AHMED

“…The economic evaluation of the above practice demonstrated that the mean overall cost of peri-procedural warfarin management per patient was USD 3,260 (QAR 11,900), associated with an overall success rate of 0.752. …”
Get full text

Do labor remittance outflows retard economic growth in Qatar? Evidence from nonlinear cointegration by Alsamara, Mouyad

“…This study fills this gap by examining the asymmetric impacts of remittance outflows on real GDP per capita and non-oil real GDP per capita in Qatar over the period 2000:Q1-2019:Q4. …”
Get full text
Get full text