Magnesium-reinforced PMMA composite scaffolds: Synthesis, characterization, and 3D printing <i>via</i> stereolithography by Ambreen Afridi (22224310)

“…Notably, pure PMMA exhibited the highest tensile strength, 26.23 ± 0.14 MPa and an elastic modulus of 707.81 MPa, while PMMA resin/1% Mg showed the lowest strength (19.46 ± 0.25 MPa) and modulus (392.88 MPa), indicating a decrease in mechanical integrity with higher Mg content. …”

1,2,4-Trimethylbenzene Transformation Reaction Compared With Its Transalkylation Reaction With Toluene Over USY Zeolite by Al-Khattaf, H

“…Reaction mixtures of 50:50 wt % TMB and toluene were used for the transalkylation reaction. …”
Get full text

Ablation of LAT2 Transporter Causes Intramuscular Glutamine Accumulation and Inhibition of Fasting‐Induced Proteolysis by Meritxell Espino‐Guarch (22565774)

“…To characterise the impact on muscle degradation, we tested LAT2 KO mice in cancer‐associated cachexia, streptozocin‐induced Type‐1 diabetes, and ageing models.</p><h3>Results</h3><p dir="ltr">LAT2KO mice experienced a notable reduction in body weight during fasting (WT:14% and LAT2KO:18%, <i>p</i> = 0.02), with a greater reduction in fat mass (0.5‐fold, <i>p</i> = 0.013) and a higher relative retention of muscle mass (1.3‐fold, <i>p</i> = 0.0003) compared with WT. …”

Dynamics of Neisseria gonorrhoeae transmission among female sex workers and clients: A mathematical modeling study by Houssein H., Ayoub

“…Increasing condom use from 10 % to 50 % lowers NG prevalence among FSWs, clients, and their spouses from 12.2 % to 6.4 %, 1.2 % to 0.5 %, and 0.4 % to 0.2 %, respectively. …”
Get full text
Get full text
Get full text

Association Between Three-Months Vitamin D Supplementation and Depressive Symptomatology incidence among Saudi Arabian Adults by Khaddaj, Rashel

“…After three-months supplementation of 50,000IU, vitamin D levels increased to 51.41 ±11.27ng/ml in the supplemented group and to24.95 ±6.45ng/ml in placebo group (p=0.00). …”
Get full text
Get full text
Get full text

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide‐based gels: Rheological and molecular simulation study by Ahmed Hamza (7224470)

“…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles by Mariem Chamakh (14150481)

“…The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 °C for 4 h to form the ruthenium oxide nanoparticles. …”

Zirconium phytate-based proton conductors for high-temperature fuel cell applications by Nimir, Wessam Ahmed Mohamed

Get full text

A lipidomic screen of hyperglycemia-treated HRECs links 12/15-Lipoxygenase to microvascular dysfunction during diabetic retinopathy via NADPH oxidase by Ahmed S. Ibrahim (10049522)

“…Fluorescein angiography and retinal albumin leakage showed a significant decrease in retinal hyperpermeability in streptozotocin-induced diabetic mice lacking 12/15-LOX compared with diabetic WT mice. …”

Isothermal Crystallization Kinetics and Morphology of Double Crystalline PCL/PBS Blends Mixed with a Polycarbonate/MWCNTs Masterbatch by Thandi P. Gumede (18112762)

“…The nanocomposites contained 1.0 and 4.0 wt% MWCNTs. The blends showed a sea-island morphology typical of immiscible blends. …”

SARS‐CoV‐2 infection triggers more potent antibody‐dependent cellular cytotoxicity (ADCC) responses than mRNA‐, vector‐, and inactivated virus‐based COVID‐19 vaccines by Hadeel T. Zedan (12535521)

“…We analyzed ADCC activity targeting SARS‐CoV‐2 spike (S) and nucleocapsid (N) proteins in convalescent sera following WT SARS‐CoV‐2‐infection (<i>n</i> = 91), including symptomatic and asymptomatic infections, omicron‐infection (<i>n</i> = 8), COVID‐19 vaccination with messenger RNA‐ (mRNA)‐ (BNT162b2 or mRNA‐1273, <i>n</i> = 77), adenovirus vector‐ (<i>n</i> = 41), and inactivated virus‐ (<i>n</i> = 46) based vaccines, as well as post‐mRNA vaccination BTI caused by omicron (<i>n</i> = 28). …”

Stability and thermophysical properties test of carbide-derived carbon thermal fluid; a comparison between functionalized and emulsified suspensions by Ismail W. Almanassra (14151321)

“…The results demonstrated that the thermal conductivity enhancement was independent of temperature, decreases with gum-Arabic concentration, and significantly enhanced with CDC loading with a maximum enhancement of 26.1% for 0.3 wt% functionalized CDC. …”

Enhanced thermoelectric properties of Bi₂Te_2.55Se_0.45 nanocomposites using eco-friendly Eocene Midra Shale palygorskite nanofillers: A sustainable... by Farah M. El-Makaty (14157090)

“…Different wt% of EMS (0.025, 0.05, 0.1, 0.5, and 1) were considered. …”

Engineering the Surface and Mechanical Properties of Water Desalination Membranes Using Ultralong Carbon Nanotubes by Yehia M. Manawi (18091207)

“…More pronounced effect on membrane’s mechanical properties was observed due to compatibility of CNTs with PS matrix when compared to other factors (i.e., changes in the CNT aspect ratio). The water contact angle for PS membranes incorporated with commercial CNT sharply decreased from 73° to 53° (membrane hydrophilization) for membranes with 0.1 and 1.0 wt. % of CNTs, while for the same loading of produced CNTs the water contact angles for the membrane samples increased from 66° to 72°. …”

The Effect of Chitosan’s Addition to Resorcinol/Formaldehyde Xerogels on the Characteristics of Resultant Activated Carbon by Ahmed Awadallah-F (825837)

“…The results showed that the disorder ratio of crystal lattice decreased from 0.750 to 0.628 when increasing the concentration of chitosan from 0 to 0.037 wt%. …”

Genetic Deletion of DNAJB3 Using CRISPR-Cas9, Produced Discordant Phenotypes by Shadi Nejat (19457212)

“…Male and female KO and WT mice were fed a HF diet (45% kcal fat) for 16 weeks. …”

Thermoelectric power of (Cu0.5Tl0.5)-1223 superconducting phase added with BaSnO3 nanoparticles by Srour, A.

“…BaSnO3 nanoparticles were prepared by chemical co-precipitation method, while (BaSnO3)x/(CuT1)-1223 superconducting samples with 0.00 ≤ x ≤ 1.50 wt% were prepared using the solid-state reaction method. …”
Get full text
Get full text
Get full text
Get full text

Investigation of the Effect of Imatinib and Hydroxyurea Combination Therapy on Hematological Parameters and Gene Expression in Chronic Myeloid Leukemia (CML) Patients by Esraa K. Al-Amleh (16023071)

“…Platelet counts, on the other hand, dramatically decreased in both IM and (HU + IM).</p><h3>Conclusion</h3><p dir="ltr">Because the studied genes (BCL2, PP2A, CIP2A, and WT1) are participating in cell proliferation and death, the findings show that the examined genes are significant to understand the efficacy of various therapies. …”

Effect of surfactants on the convective heat transfer and pressure drop characteristics of ZnO/DIW nanofluids: An experimental study by Adnan Qamar (14421759)

“…Convective heat transfer (HTC) and flow characteristics (pressure drop (ΔP) and friction factor (f)) of aqueous ZnO NFs' within a circular mini tube (D i = 1.0 mm, L = 330 mm) were analyzed. Experiments were carried out under steady-state and varying flow rates using 0.012–0.048 wt % of NFs and sodium hexametaphosphate (SHMP) and acetylacetone (ACAC) as surfactants (SFs). …”

Thermally Conductive Polyethylene/Expanded Graphite Composites as Heat Transfer Surface: Mechanical, Thermo-Physical and Surface Behavior by Patrik Sobolčiak (4401364)

“…The viscoelastic moduli and the complex viscosity profiles indicated that EG content dictates the optimum processing technique. At loading below 30 wt.%, the extrusion process is preferred, while above 30 wt.% loading, injection molding is preferred. …”