-
1
-
2
-
3
Reactive Absorption of CO2 Using Ethylaminoethanol Promoted Aqueous Potassium Carbonate Solvent
Published 2016“…The temperature dependency of k_2 for the CO2 – APCE solvent system was experimentally determined as: k_2 = (1.214 × [10]^18)√exp(( − 9822.7)/T). …”
Get full text
Get full text
-
4
Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites
Published 2020“…Aluminium matrix reinforced with aluminium oxide?titanium oxide (2.5, 5.0, 7.5 and 10 wt.%) in equal proportion were prepared by stir casting. …”
Get full text
Get full text
-
5
-
6
-
7
Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings
Published 2019“…Various contents of the encapsulated TiO2 nanotubes (1, 3 and 5 wt%) were thoroughly dispersed into the epoxy matrix and the resulting composites were then applied on a cleaned steel substrate using doctor blade technique to develop smart coatings. …”
Get full text
Get full text
-
8
-
9
Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites
Published 2020“…The aim of the present study is to investigate the structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites. Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. …”
Get full text
Get full text
-
10
Synthesis and characterisation of Co2+-incorporated ZnO nanoparticles prepared through a sol-gel method
Published 2016“…The band gap of the Co2+-doped ZnO samples decreased from 3.19 to 2.66 eV as the content of dopant Co2+ increased from 0.0 to 1.0 wt.%. …”
Get full text
Get full text
-
11
Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites
Published 2021“…Hardness of hybrid composites increases upto 5 wt.% variation of ceramic reinforcements i.e. Al2O3-SiC after that it decreases. …”
Get full text
Get full text
-
12
Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites
Published 2020“…Aluminium matrix reinforced with Al2O3–carbon (2.5, 5, 7.5 and 10 wt.%) in equal proportion was prepared by stir casting. …”
Get full text
Get full text
-
13
Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures
Published 2022“…The properties of the prepared MMCs were found to be dependent on the reinforcements content present in the MMCs. ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text
-
14
-
15
Fabrication of Fouling Resistant Ti3C2Tx(MXene) Cellulose Acetate Nanocomposite Membrane for Forward Osmosis Application
Published 2020“…It was observed that the cross-linked cellulose acetate membrane with 8 wt% MXene (CCAM-8%) showed higher resistance to fouling when compared with commercial thin-filmcomposite (TFC) FO membrane, the water flux of CCAM-8% decreased by only 10.7% using TSE as FS compared to DI, where the water flux of the TFC commercial membrane decreased by 32.2% when using TSE as FS compared to DI.…”
Get full text
-
16
-
17
-
18
-
19
Isothermal crystallization kinetics and morphology of double crystalline PCL/PBS blends mixed with a polycarbonate/MWCNTs masterbatch
Published 2019“…For the nanocomposites, there was a decrease in Tc values. This was attributed to a competition between two effects: (1) The partial miscibility of the PC-rich and the PCL-rich and PBS-rich phases, and (2) the nucleation effect of the MWCNTs. …”
Get full text
Get full text
-
20
