-
1
-
2
-
3
Reactive Absorption of CO2 Using Ethylaminoethanol Promoted Aqueous Potassium Carbonate Solvent
Published 2016“…The temperature dependency of k_2 for the CO2 – APCE solvent system was experimentally determined as: k_2 = (1.214 × [10]^18)√exp(( − 9822.7)/T). …”
Get full text
Get full text
-
4
Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites
Published 2020“…Aluminium matrix reinforced with aluminium oxide?titanium oxide (2.5, 5.0, 7.5 and 10 wt.%) in equal proportion were prepared by stir casting. …”
Get full text
Get full text
-
5
Experimental investigation on the compressibility of Al/Al2O3 nanocomposites
Published 2016“…The results showed that the grain size of milled powders was about 43 nm with a noticeable presence of agglomerates at 10 wt.% of Al2O3. By increasing Al2O3 weight fraction to 12% the decrease in grain size was very. …”
Get full text
Get full text
-
6
-
7
Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles
Published 2021“…Electrospinning technique was employed to fabricate composite nanofibers/nanoparticles of sulfonated polyether ether ketone, polyvinylpyrrolidone, and ruthenium oxide (sPEEK/PVP/RuO2). The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 �C for 4 h to form the ruthenium oxide nanoparticles. …”
Get full text
Get full text
-
8
-
9
Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings
Published 2019“…Towards this direction, TiO2 nanotubes with an average size of ⁓10–15 nm (as confirmed by scanning electron microscope (SEM) and transmission electron microscope (TEM) analysis) were synthesized through a hydrothermal process and were then impregnated with DOC. …”
Get full text
Get full text
-
10
Tailoring electrocatalytic properties of Pt nanoparticles grown on Ti3C2Tx MXene surface
Published 2019“…Composites containing 14 wt% Pt showed HER with an onset potential of −75.9 mV and a current density of −10 mA cm−2 achieved at −226 mV. …”
Get full text
Get full text
Get full text
-
11
Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites
Published 2020“…The aim of the present study is to investigate the structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites. Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. …”
Get full text
Get full text
-
12
Synthesis and characterisation of Co2+-incorporated ZnO nanoparticles prepared through a sol-gel method
Published 2016“…The band gap of the Co2+-doped ZnO samples decreased from 3.19 to 2.66 eV as the content of dopant Co2+ increased from 0.0 to 1.0 wt.%. …”
Get full text
Get full text
-
13
Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites
Published 2020“…Aluminium matrix reinforced with Al2O3–carbon (2.5, 5, 7.5 and 10 wt.%) in equal proportion was prepared by stir casting. …”
Get full text
Get full text
-
14
Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites
Published 2021“…Al2O3-SiC (2.5 wt.%, 5.0 wt.%, 7.5 wt.% and 10.0 wt.%) in relative and symmetrical proportion. …”
Get full text
Get full text
-
15
Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures
Published 2022“…The properties of the prepared MMCs were found to be dependent on the reinforcements content present in the MMCs. ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text
-
16
-
17
Fabrication of fouling resistant Ti3C2Tx (MXene)/cellulose acetate nanocomposite membrane for forward osmosis application
Published 2020“…It was found that the cross-linked cellulose acetate membrane with 8 wt% MXene (CCAM-8%) showed higher resistance to fouling when compared with commercial thin-film composite (TFC) FO membrane, the water flux of CCAM-8% decreased by only 10.7% using TSE as FS compared to DW, where the water flux of the TFC commercial membrane decreased by 32.2% when using TSE as FS compared to DW.…”
Get full text
Get full text
-
18
Fabrication of Fouling Resistant Ti3C2Tx(MXene) Cellulose Acetate Nanocomposite Membrane for Forward Osmosis Application
Published 2020“…It was observed that the cross-linked cellulose acetate membrane with 8 wt% MXene (CCAM-8%) showed higher resistance to fouling when compared with commercial thin-filmcomposite (TFC) FO membrane, the water flux of CCAM-8% decreased by only 10.7% using TSE as FS compared to DI, where the water flux of the TFC commercial membrane decreased by 32.2% when using TSE as FS compared to DI.…”
Get full text
-
19
Preparation and characterization of wollastonite/titanium oxide nanofiber bioceramic composite as a future implant material
Published 2016“…The influence of densification temperature and TiO2 content was investigated. Typically, TiO2/wollastonite composites having 0, 10, 20 and 30wt% metal oxide nanofibers were sintered at 900, 1100 and 1250°C. …”
Get full text
Get full text
Get full text
-
20
