Electronic vs Ionic limitations to electrochemical performance in Li4Ti5O12-based organic suspensions for lithium-redox flow batteries by Madec, L.

“…Here, we report the electrochemical response of the LTO/KB anolytes vs. lithium as function of the cycling rate in static mode (i.e. no flow) and using a home-made cell. The KB content was fixed at 3 wt% while the LTO content was varied between 15 and 25 wt%. …”
Get full text
Get full text
Get full text

Effect of electroless bath composition on the mechanical, chemical, and electrochemical properties of new NiP-C 3 N 4 nanocomposite coatings by Fayyad E.M.

Get full text
Get full text

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study by Hamza A.

Get full text
Get full text
Get full text

Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites by Ahamad, Naseem

“…Al-Al2O3-SiC hybrid composite has been developed through stir casting with addition of ceramics i.e. Al2O3-SiC (2.5 wt.%, 5.0 wt.%, 7.5 wt.% and 10.0 wt.%) in relative and symmetrical proportion. …”
Get full text
Get full text

Synthesis and characterisation of Co2+-incorporated ZnO nanoparticles prepared through a sol-gel method by Ba-Abbad, Muneer M.

“…The band gap of the Co2+-doped ZnO samples decreased from 3.19 to 2.66 eV as the content of dopant Co2+ increased from 0.0 to 1.0 wt.%. …”
Get full text
Get full text

Morphology, nucleation, and isothermal crystallization kinetics of poly(butylene succinate) mixed with a polycarbonate/MWCNTs masterbatch by Gumede, Thandi P.

“…The nanocomposites contained 0.5, 1.0, 2.0, and 4.0 wt% MWCNTs. Differential scanning calorimetry (DSC), small angle X-ray scattering (SAXS) and wide angle X-ray scattering (WAXS) results indicate that the blends are partially miscible, hence they form two phases (i.e., PC-rich and PBS-rich phases). …”
Get full text
Get full text

Morphology, Nucleation, and Isothermal Crystallization Kinetics of Poly(ε-caprolactone) Mixed with a Polycarbonate/MWCNTs Masterbatch by Gumede, Thandi P.

“…The thermal conductivities (i.e., 4 wt % MWCNTs) were enhanced by 20% in comparison to the neat material. …”
Get full text
Get full text

Synthesis and properties of HA/ZnO/CNT nanocomposite by Ding M.

Get full text
Get full text

Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites by Ahamad, N.

“…Scanning electron microscopy shows that Al matrix has uniform distribution of reinforcement particles, i.e. Al2O3 and carbon. Density decreases due to variation of reinforcement because ceramic reinforcement has low density. …”
Get full text
Get full text

Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites by Ahamad, N.

“…Scanning electron microscopy shows that aluminium matrix has uniform distribution of reinforcement particle i.e. aluminium oxide and titanium oxide. Density of composite decreases due to variation of reinforcement and it shows low density after preheating. …”
Get full text
Get full text

Improved mechanical properties of recycled linear low-density polyethylene composites filled with date palm wood powder by AlMaadeed, Mariam A.

“…A maximum value of 1989MPa was observed for the composite filled with 70wt.% filler, which was approximately 6.5times higher than that observed for neat RLLDPE. …”
Get full text
Get full text
Get full text

PROFILE OF OXIDATIVE STRESS GENES IN RESPONSE TO OBESITY TREATMENT by AHMED, AMIRA

“…Results: Significant reduction in body weight in SFN treated WT mice, while no change in KO mice. Plasma glucose, leptin, and leptin gene expression (eWAT) were significantly reduced in the WT-DIO SFN treated group, while no changes were detected in KO mice. …”
Get full text
Get full text

Tribological studies of nanomodified mineral based multi-grade engine oil by Laad, M.

Get full text
Get full text

Enhancing the corrosion resistance of reinforcing steel under aggressive operational conditions using behentrimonium chloride by Radwan A.B.

“…Using only a 50 ?mol L?1 of BTC, we are able to measure an inhibition efficiency of 91, 79, and 71% in SCP solution with 3.5% NaCl at pH of 12.5, 10 and 7, respectively without showing any effect on the mechanical properties on the cured mortars. …”
Get full text
Get full text

Role of TiO2 and carbon nanotubes on polyethylene, and effect of accelerated weathering on photo oxidation and mechanical properties by Zagho M.M.

“…Addition of CNTs had negligible effect on the tensile strength but it kept the same approximate value of the original before the accelerated weathering (e.g., 23.2 MPa for 1 wt% of CNTs). CNTs also protected the samples even with the presence of TONPs because of the absorbance and antioxidants effects. …”
Get full text
Get full text

The effects of gas tungsten arch welding on the corrosion and mechanical properties of AA 6061 T6 by Eltai, Elsadig

Get full text
Get full text

Synthesis and characterization of Sm3+-doped ZnO nanoparticles via a sol–gel method and their photocatalytic application by Ba-Abbad, Muneer M.

“…It was noticed that in the presence of samarium ions, the band gap slightly changed from the 3.198 eV of ZnO to 3.288 eV for samarium-doped ZnO with enhanced absorption in the UV region. …”
Get full text
Get full text
Get full text

Self-healing performance of smart coatings modified with different corrosion inhibitors. by Habib, Sehrish

Get full text
Get full text

Arabic gum as green agent for ZnO nanoparticles synthesis: properties, mechanism and antibacterial activity by Ba-Abbad, Muneer M.

“…The size of the spherically shaped ZnO NPs decreased with an increase in the amount of Arabic gum, up to an optimal 1.50 wt%. …”
Get full text
Get full text

Biodegradable polysaccharide grafted polyacrylamide inhibitor for corrosion in CO2- saturated saline solution by Jalab, Rem

Get full text
Get full text