Biocorrosion behavior of biodegradable nanocomposite fibers coated layer-by-layer on AM50 magnesium implant by Abdal-hay, Abdalla

“…The corrosion performance of coated and uncoated coupon samples was investigated by means of electrochemical measurements. The results showed that the AJS 3D membrane fiber layers, particularly the hybrid membrane layers containing a small amount of nHA (3wt.%), induce a higher biocorrosion resistance and effectively decrease the initial degradation rate compared with the neat AM50 coupon samples. …”
Get full text
Get full text

Electronic vs Ionic limitations to electrochemical performance in Li4Ti5O12-based organic suspensions for lithium-redox flow batteries by Madec, L.

“…Above a critical thickness in the 0.5-1 mm range, depending on the LTO content, the rate performance are significantly decreased. …”
Get full text
Get full text
Get full text

SARS-CoV-2 infection triggers more potent antibody-dependent cellular cytotoxicity (ADCC) responses than mRNA-, vector-, and inactivated virus-based COVID-19 vaccines by Zedan, Hadeel T.

“…Notably, omicron infection showed reduced overall ADCC activity compared to WT SARS-CoV-2 infection. Although post-mRNA vaccination BTI elicited high levels of binding and NAbs, ADCC activity was significantly reduced. …”
Get full text
Get full text
Get full text

Optimization of performance and emission characteristics of CI engine fueled with Jatropha biodiesel produced using a heterogeneous catalyst (CaO) by Singh, A.

“…The heterogeneous transesterification delivered a yield of 81.6% at 5 wt% catalyst concentration and 12:1 methanol to oil molar ratio. …”
Get full text
Get full text

Resistive room temperature LPG sensor based on a graphene/CdO nanocomposite by Goutham S.

“…The CdO/graphene composite was deposited as a film on interdigitated electrodes (IDEs) which then were used for chemiresistive sensing of liquid petroleum gas (LPG) by using a four probe technique. A Resistivity decreases significantly upon exposure to a LPG. The electrical resistance measurement at a constant bias voltage of 0.5 V. …”
Get full text
Get full text

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study by Hamza A.

“…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”
Get full text
Get full text
Get full text

ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY by MESLAM, MENTALLAH MOHAMED HASSANIN MOHAMED HASSANIN

“…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …”
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Microstructure, wear and corrosion characteristics of Cu matrix reinforced SiC–graphite hybrid composites by Jamwal A.

“…Copper matrix composites with SiC-graphite reinforcement (0, 2.5,5, 7.5 and 10 wt.%) were prepared by stir casting process. …”
Get full text
Get full text

Thermally conductive polyethylene/expanded graphite composites as heat transfer surface: Mechanical, thermo-physical and surface behavior by Sobolčiak, Patrik

“…Moreover, the surface wettability of the HDPE/EG composite was enhanced by corona and RF plasma treatment as demonstrated by the increase in surface free energy from 28.5 mJ/m2 for untreated HDPE/EG to 55.5 and 54.5 mJ/m2 for HDPE/EG treated by corona and RF plasma, respectively. …”
Get full text
Get full text

Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites by Mittal, P.

“…Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. …”
Get full text
Get full text

Comparison of performance and health indicators between perimenopausal and postmenopausal obese women: the effect of high-intensity interval training (HIIT). by Jabbour, Georges

“…Anthropometric parameters, mechanical efficiency (ME in %), lipid oxidation (LO in %), and low and high spectral frequencies (LF[ms2] and HF[ms2]) were computed pre- and postintervention. …”
Get full text
Get full text

Modification of Pd/CeO2 catalyst by Atomic Layer Deposition of ZrO2 by Onn, Tzia Ming

“…Methane-oxidation rates in 0.5% CH4 and 5% O2 were slightly lower on the ZrO2-covered catalyst when both materials were calcined at 673 K but the activity of the ZrO2-modified catalyst did not decrease with catalyst calcination temperature. …”
Get full text
Get full text

Mechanical Performance and Thermo-Physical Properties of Cement Mortar Incorporating Hybrid Slags by Baawain, Mahad

Get full text
Get full text

The Separation of Emulsified Water/Oil Mixtures through Adsorption on Plasma-Treated Polyethylene Powder by Abdulkareem, Asma

“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles by Chamakh, Mariem

“…The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 �C for 4 h to form the ruthenium oxide nanoparticles. …”
Get full text
Get full text

Influence of nitrogen doping on the electrocatalytic activity of Ni-incorporated carbon nanofibers toward urea oxidation by Barakat, Nasser A.M.

“…However, the electrochemical measurements indicated that the content of the urea in the initial electrospun solution should be optimized as the results showed that the best nickel surface activation as well as the maximum observed current density can be achieved when the urea content is kept at 5 wt%. Typically, the observed current densities using 1.0 M urea (in 1 M KOH) were 3.15, 29.7, 13.75, 47.55, 14.13 and 9.85 mA/cm2 for the nanofibers obtained from electrospun solutions having 0, 1, 2, 5, 7 and 9 wt% urea, respectively. …”
Get full text
Get full text

The separation of emulsified water/oil mixtures through adsorption on plasma-treated polyethylene powder by Abdulkareem A.

“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text

Novel fluorinated surfactants for enhanced oil recovery in carbonate reservoirs by Al-Amodi, Adel O.

“…Core flooding experiments showed 42 % additional oil recovery using 2.5 g/L (2500 ppm) HPAM and 0.001 g/g (0.1 mass%) amphoteric surfactant at 90 °C.…”
Get full text
Get full text

Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites by Ahamad, Naseem

“…Al-Al2O3-SiC hybrid composite has been developed through stir casting with addition of ceramics i.e. Al2O3-SiC (2.5 wt.%, 5.0 wt.%, 7.5 wt.% and 10.0 wt.%) in relative and symmetrical proportion. …”
Get full text
Get full text