Search alternatives:
ppm decrease » _ decrease (Expand Search)
ms decrease » _ decrease (Expand Search)
nn decrease » _ decrease (Expand Search)
w decrease » _ decrease (Expand Search), _ decreased (Expand Search), _ decreases (Expand Search)
ppm decrease » _ decrease (Expand Search)
ms decrease » _ decrease (Expand Search)
nn decrease » _ decrease (Expand Search)
w decrease » _ decrease (Expand Search), _ decreased (Expand Search), _ decreases (Expand Search)
-
1
-
2
Wind energy potential along the onshore and offshore Qatar
Published 2020“…Among the select locations, the highest annual mean wind power density is obtained in the o?shore Ruwais (152 W/m2), followed by o?shore Ras La?an (134 W/m2) and land area of Al Khor (120 W/m2). …”
Get full text
Get full text
-
3
An Improved Fault Tolerant Five-Phase Induction Machine Using A Combined Star/Pentagon Single Layer Stator Winding Connection
Published 2015“…A 1kW prototype machine is used for experimental verification.…”
Get full text
Get full text
-
4
Enhanced oil recovery using hyperbranched polyglycerol polymer-coated silica nanoparticles
Published 2021“…dem improved as the Csur and pH decreased, with maximum values of 98.8% and 98.5% achieved at Csur = 0.05 g/L and a pH = 4, respectively. …”
Get full text
Get full text
-
5
-
6
-
7
-
8
Application of magnetic nanoparticles for the removal of oil from oil-in-water emulsion: Regeneration/reuse of spent particles
Published 2021“…This change is due to the decrease in the emulsion stability and the formation of fine oil droplets. …”
Get full text
Get full text
-
9
Application of Fe3O4 magnetite nanoparticles grafted in silica (SiO2) for oil recovery from oil in water emulsions
Published 2021“…Using an MDdose as low as 10 mg/L attained a %ηdem in the range of 93%–94.3% for O/W mixtures with Coil < 2000 mg/L, which slightly decreased to ∼90% for higher concentrations. …”
Get full text
Get full text
-
10
-
11
-
12
-
13
-
14
-
15
Functionalization of silica-coated magnetic nanoparticles as powerful demulsifier to recover oil from oil-in-water emulsion
Published 2021“…This study presents an innovative approach for the preparation of Fe3O4 nanoparticles covered with SiO2 shell (denoted as Fe–Si-MNP), which were used to recover oil recovery from oil-in-water emulsion (O/W-emul). The Fe–Si-MNP were prepared with differing silica layer thicknesses (5 nm [Fe–Si-1], 8 nm [Fe–Si-2], 10 nm [Fe–Si-3], and 15 nm [Fe–Si-4]) and tested for the percentage of oil separation (%Soil) under different dosages (DMNP), oil concentration (Doil), surfactant dosages (Dsur), and pH. …”
Get full text
Get full text
-
16
Optimization of performance and emission characteristics of CI engine fueled with Jatropha biodiesel produced using a heterogeneous catalyst (CaO)
Published 2020“…The optimum performance and emission characteristics (BP, BTHE, HC and NOx) are found to be 2.258 KW, 29.05%, 6.31 ppm, and 159.5 ppm respectively. The performance of B20 fueled engine was almost comparable to that of diesel fuel. …”
Get full text
Get full text
-
17
Comparison of performance and health indicators between perimenopausal and postmenopausal obese women: the effect of high-intensity interval training (HIIT).
Published 2020“…Anthropometric parameters, mechanical efficiency (ME in %), lipid oxidation (LO in %), and low and high spectral frequencies (LF[ms2] and HF[ms2]) were computed pre- and postintervention. …”
Get full text
Get full text
-
18
The Separation of Emulsified Water/Oil Mixtures through Adsorption on Plasma-Treated Polyethylene Powder
Published 2021“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text
-
19
Effect of outdoor temperature on the power-conversion efficiency of newly synthesized organic photosensitizer based dye-sensitized solar cells
Published 2018“…The results indicate that DSSC shows power conversion efficiency of 2.58% at 25 °C under air mass (AM) 1.5 G illumination at 100 mW/cm2. It has also been found out that the efficiency of DSSCs drops with the rise of temperature. …”
Get full text
Get full text
-
20
The separation of emulsified water/oil mixtures through adsorption on plasma-treated polyethylene powder
Published 2021“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text