-
1
Investigation of the Effect of Imatinib and Hydroxyurea Combination Therapy on Hematological Parameters and Gene Expression in Chronic Myeloid Leukemia (CML) Patients
Published 2022“…Platelet counts, on the other hand, dramatically decreased in both IM and (HU + IM). (4) Conclusion: Because the studied genes (BCL2, PP2A, CIP2A, and WT1) are participating in cell proliferation and death, the findings show that the examined genes are significant to understand the efficacy of various therapies. …”
Get full text
Get full text
-
2
Dynamic workload patterns prediction for proactive auto-scaling of web applications
Published 2018“…The framework is implemented and experimentally evaluated using historical access logs of three real web applications, each with increasing, decreasing, periodic, and randomly varying arrival rate behaviors. …”
Get full text
Get full text
-
3
-
4
-
5
Bio-Inspired Fabrication of Ultrafiltration Membranes Incorporating Polydopamine Functionalized Graphene Oxide Nanoparticles
Published 2021“…Thus, the flux increased with the embedding of rGO-PDA without affecting the rejection properties, while it decreased with the embedding of pristine GO. The highest pure water permeability (PWP) was obtained with PSF/rGO PDA-0.1 to be approximately twice that of the pristine PSF and PSF/GO-0.1. …”
Get full text
-
6
Optimization of performance and emission characteristics of CI engine fueled with Jatropha biodiesel produced using a heterogeneous catalyst (CaO)
Published 2020“…The heterogeneous transesterification delivered a yield of 81.6% at 5 wt% catalyst concentration and 12:1 methanol to oil molar ratio. …”
Get full text
Get full text
-
7
ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY
Published 2022“…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …”
Get full text
-
8
Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study
Published 2021“…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”
Get full text
Get full text
Get full text
-
9
Influence of nitrogen doping on the electrocatalytic activity of Ni-incorporated carbon nanofibers toward urea oxidation
Published 2017“…However, the electrochemical measurements indicated that the content of the urea in the initial electrospun solution should be optimized as the results showed that the best nickel surface activation as well as the maximum observed current density can be achieved when the urea content is kept at 5 wt%. Typically, the observed current densities using 1.0 M urea (in 1 M KOH) were 3.15, 29.7, 13.75, 47.55, 14.13 and 9.85 mA/cm2 for the nanofibers obtained from electrospun solutions having 0, 1, 2, 5, 7 and 9 wt% urea, respectively. …”
Get full text
Get full text
-
10
Development of pH-Controlled Aluminum-Based Polymeric Gel for Conformance Control in Sour Gas Reservoirs
Published 2020“…The results reveal that aluminum acetate, among the screened salts, has a controllable gelation time at pH conditions between 3.5 and 8.5 and is the most stable in the temperature range 25–100 °C. …”
Get full text
Get full text
Get full text
-
11
Resistive room temperature LPG sensor based on a graphene/CdO nanocomposite
Published 2019“…The sensor of type CdO/graphene (1 wt.%) exhibits a sensitivity of 600 ppm of LPG at 27 C. …”
Get full text
Get full text
-
12
-
13
The Separation of Emulsified Water/Oil Mixtures through Adsorption on Plasma-Treated Polyethylene Powder
Published 2021“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text
-
14
Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites
Published 2021“…Hardness of hybrid composites increases upto 5 wt.% variation of ceramic reinforcements i.e. Al2O3-SiC after that it decreases. …”
Get full text
Get full text
-
15
Isothermal crystallization kinetics and morphology of double crystalline PCL/PBS blends mixed with a polycarbonate/MWCNTs masterbatch
Published 2019“…The nanocomposites contained 1.0 and 4.0 wt% MWCNTs. The blends showed a sea-island morphology typical of immiscible blends. …”
Get full text
Get full text
-
16
Thermal characterization of phase change materials based on linear low-density polyethylene, paraffin wax and expanded graphite
Published 2016“…A similar decrease in sensible heat with increased loading of EG was observed for PCMs containing 50 wt.% of EG. …”
Get full text
Get full text
-
17
The separation of emulsified water/oil mixtures through adsorption on plasma-treated polyethylene powder
Published 2021“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text
-
18
Novel fluorinated surfactants for enhanced oil recovery in carbonate reservoirs
Published 2016“…Core flooding experiments showed 42 % additional oil recovery using 2.5 g/L (2500 ppm) HPAM and 0.001 g/g (0.1 mass%) amphoteric surfactant at 90 °C.…”
Get full text
Get full text
-
19
Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures
Published 2022“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text
-
20
