Investigation of the Effect of Imatinib and Hydroxyurea Combination Therapy on Hematological Parameters and Gene Expression in Chronic Myeloid Leukemia (CML) Patients by Al-Amleh, Esraa K.

“…Platelet counts, on the other hand, dramatically decreased in both IM and (HU + IM). (4) Conclusion: Because the studied genes (BCL2, PP2A, CIP2A, and WT1) are participating in cell proliferation and death, the findings show that the examined genes are significant to understand the efficacy of various therapies. …”
Get full text
Get full text

Electronic vs Ionic limitations to electrochemical performance in Li4Ti5O12-based organic suspensions for lithium-redox flow batteries by Madec, L.

“…Above a critical thickness in the 0.5-1 mm range, depending on the LTO content, the rate performance are significantly decreased. …”
Get full text
Get full text
Get full text

SARS-CoV-2 infection triggers more potent antibody-dependent cellular cytotoxicity (ADCC) responses than mRNA-, vector-, and inactivated virus-based COVID-19 vaccines by Zedan, Hadeel T.

“…Notably, omicron infection showed reduced overall ADCC activity compared to WT SARS-CoV-2 infection. Although post-mRNA vaccination BTI elicited high levels of binding and NAbs, ADCC activity was significantly reduced. …”
Get full text
Get full text
Get full text

Bio-Inspired Fabrication of Ultrafiltration Membranes Incorporating Polydopamine Functionalized Graphene Oxide Nanoparticles by Alkhouzaam, Abedalkader I.

“…Thus, the flux increased with the embedding of rGO-PDA without affecting the rejection properties, while it decreased with the embedding of pristine GO. The highest pure water permeability (PWP) was obtained with PSF/rGO PDA-0.1 to be approximately twice that of the pristine PSF and PSF/GO-0.1. …”
Get full text

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study by Hamza A.

“…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”
Get full text
Get full text
Get full text

ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY by MESLAM, MENTALLAH MOHAMED HASSANIN MOHAMED HASSANIN

“…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …”
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles by Chamakh, Mariem

“…The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 �C for 4 h to form the ruthenium oxide nanoparticles. …”
Get full text
Get full text

Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites by Mittal, P.

“…Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. …”
Get full text
Get full text

Modification of Pd/CeO2 catalyst by Atomic Layer Deposition of ZrO2 by Onn, Tzia Ming

“…Modification of a 1 wt% Pd/CeO2 catalyst by Atomic Layer Deposition of thin ZrO2 films was studied. …”
Get full text
Get full text

Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites by Ahamad, Naseem

“…Al-Al2O3-SiC hybrid composite has been developed through stir casting with addition of ceramics i.e. Al2O3-SiC (2.5 wt.%, 5.0 wt.%, 7.5 wt.% and 10.0 wt.%) in relative and symmetrical proportion. …”
Get full text
Get full text

Influence of nitrogen doping on the electrocatalytic activity of Ni-incorporated carbon nanofibers toward urea oxidation by Barakat, Nasser A.M.

“…However, the electrochemical measurements indicated that the content of the urea in the initial electrospun solution should be optimized as the results showed that the best nickel surface activation as well as the maximum observed current density can be achieved when the urea content is kept at 5 wt%. Typically, the observed current densities using 1.0 M urea (in 1 M KOH) were 3.15, 29.7, 13.75, 47.55, 14.13 and 9.85 mA/cm2 for the nanofibers obtained from electrospun solutions having 0, 1, 2, 5, 7 and 9 wt% urea, respectively. …”
Get full text
Get full text

Synthesis and characterisation of Co2+-incorporated ZnO nanoparticles prepared through a sol-gel method by Ba-Abbad, Muneer M.

“…The band gap of the Co2+-doped ZnO samples decreased from 3.19 to 2.66 eV as the content of dopant Co2+ increased from 0.0 to 1.0 wt.%. …”
Get full text
Get full text

Optimization of performance and emission characteristics of CI engine fueled with Jatropha biodiesel produced using a heterogeneous catalyst (CaO) by Singh, A.

“…The heterogeneous transesterification delivered a yield of 81.6% at 5 wt% catalyst concentration and 12:1 methanol to oil molar ratio. …”
Get full text
Get full text

دراسة تأثير تركيز تيترا أيزوبروبكسيد التيتانيوم (TTIP) على بعض مواصفات ألياف ثنائي أكسيد التيتانيوم النانوية المغزولة كهربائياً... by طهماز, غزل

Get full text

Morphology, nucleation, and isothermal crystallization kinetics of poly(butylene succinate) mixed with a polycarbonate/MWCNTs masterbatch by Gumede, Thandi P.

“…The nanocomposites contained 0.5, 1.0, 2.0, and 4.0 wt% MWCNTs. Differential scanning calorimetry (DSC), small angle X-ray scattering (SAXS) and wide angle X-ray scattering (WAXS) results indicate that the blends are partially miscible, hence they form two phases (i.e., PC-rich and PBS-rich phases). …”
Get full text
Get full text

Morphology, Nucleation, and Isothermal Crystallization Kinetics of Poly(ε-caprolactone) Mixed with a Polycarbonate/MWCNTs Masterbatch by Gumede, Thandi P.

“…The nanocomposites contained 0.5, 1.0, 2.0, and 4.0 wt % MWCNTs. Even though PCL and PC have been reported to be miscible, our DSC (Differential Scanning Calorimetry), SAXS (Small Angle X-ray Scattering), and WAXS (Wide Angle X-ray Scattering) results showed partial miscibility, where two phases were formed (PC-rich and PCL-rich phases). …”
Get full text
Get full text

Enhanced quality factor of polyvinyl formal (PVF) based nanocomposites filled with zinc oxide and carbon black nanoparticles for wireless sensing applications by Mohanapriya, M.K.

“…The incorporation of ZnO at 10% decreases Q-factor to 36.1. Incorporation of CBNP at 5% and ZnO at 5% further reduces the Q-factor to 13.7. …”
Get full text
Get full text

Prospects Of Amino Acids And Ionic Liquids As Natural Gas Hydrate Inhibitors For Offshore Flow Assurance by Qureshi, M. Fahed Aziz

“…The results show that the selected amino acids and ionic liquids exhibit dual functional behaviour by providing the temperature shift of around 1.5-2.3 oC and delaying the hydrate formation time from 0.5-1.5 hr. …”
Get full text

Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings by Ubaid F.

“…Various contents of the encapsulated TiO2 nanotubes (1, 3 and 5 wt%) were thoroughly dispersed into the epoxy matrix and the resulting composites were then applied on a cleaned steel substrate using doctor blade technique to develop smart coatings. …”
Get full text
Get full text