-
1
-
2
Biocorrosion behavior of biodegradable nanocomposite fibers coated layer-by-layer on AM50 magnesium implant
Published 2016“…The results showed that the AJS 3D membrane fiber layers, particularly the hybrid membrane layers containing a small amount of nHA (3wt.%), induce a higher biocorrosion resistance and effectively decrease the initial degradation rate compared with the neat AM50 coupon samples. …”
Get full text
Get full text
-
3
The mitochondrial-related effect of the 905 nm photobiomodulation therapy on 50B11 sensory neurons
Published 2023“…In this study, a possible molecular mechanism of the 905 nm PBMT (0.25 W/cm2; 3, 6, 12, and 18 J/cm2, 5 Hz) analgesic effect was tested on 50B11 cells, by investigating its impact on mitochondria. …”
Get full text
Get full text
Get full text
-
4
Tailoring of the thermal, mechanical and dielectric properties of the polypropylene foams using gamma-irradiation
Published 2016“…This study investigate the influence of gamma-irradiation (GI) doses from 0 up to 50 kGy on the polypropylene (PP) foams, mainly the impact on their structural and physical properties. …”
Get full text
Get full text
-
5
-
6
-
7
Quality improvement can decrease blood delivery turnaround time: Evidence from a single tertiary-care academic medical center
Published 2018“…The transport time significantly decreased from an initial majority of > 15 mins duration, to a majority of < 15 mins transport time after the second audit; there was a 50% improvement in 30 mins response time; and the percentage of requests processed in < 10 mins were significantly higher after the second audit. …”
Get full text
-
8
-
9
-
10
In vitro effects of photobiomodulation therapy on 50B11 sensory neurons: evaluation of cell metabolism, oxidative stress, mitochondrial membrane potential (MMP), and capsaicin-indu...
Published 2021“…Calcium peak stimulated by capsaicin, the ligand of TRPV1 channel, was decreased in neurons pre-irradiated with the combination of the two wavelengths. …”
Get full text
Get full text
-
11
-
12
-
13
Development of pH-Controlled Aluminum-Based Polymeric Gel for Conformance Control in Sour Gas Reservoirs
Published 2020“…Moreover, the system showed good stability in saline conditions with NaCl concentration of up to 50,000 ppm. Scanning electron microscopy of freeze-dried samples proved the uniform distribution of colloidal crosslinkers and showed sheets wrapping around the colloidal particles. …”
Get full text
Get full text
Get full text
-
14
The separation of emulsified water/oil mixtures through adsorption on plasma-treated polyethylene powder
Published 2021“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text
-
15
Mechanism and kinetics of electrochemical degradation of uric acid using conductive-diamond anodes
Published 2016“…Interestingly, an almost total mineralization of 50 ppm UA was obtained when anodic oxidation was performed at low current densities (20 mA cm–2) and in the presence of NaCl. …”
Get full text
Get full text
-
16
-
17
-
18
Assessment of SnO2 nanoparticles' impact on local Pichoclorum atomus growth performance, cell morphology and metabolites content
Published 2021“…Five different concentrations (1, 5, 25, 50 and 100mg/L) were tested and the culture was followed for 72h. …”
Get full text
Get full text
-
19
Study of diesel-biodiesel blends combustion and emission characteristics in a CI engine by adding nanoparticles of Mn (II) supramolecular complex
Published 2020“…X-ray diffraction of one crystal, a spectroscopy technique and transmission electron microscopy (TEM) have been entirely examined for the structure formation of SC1. Adding 50, 100, and 150 ppm of SC1 with hydrogen peroxide (H2O2) is used to prepare the nanofluids emulsions. …”
Get full text
Get full text
-
20
