Showing 1 - 20 results of 168 for search '(( 50 ppm decrease ) OR ((( 50 ns decrease ) OR ((( 5 wt decrease ) OR ( 5 w decrease ))))))', query time: 0.21s Refine Results
  1. 1

    SARS-CoV-2 infection triggers more potent antibody-dependent cellular cytotoxicity (ADCC) responses than mRNA-, vector-, and inactivated virus-based COVID-19 vaccines by Zedan, Hadeel T.

    Published 2024
    “…Notably, omicron infection showed reduced overall ADCC activity compared to WT SARS-CoV-2 infection. Although post-mRNA vaccination BTI elicited high levels of binding and NAbs, ADCC activity was significantly reduced. …”
    Get full text
    Get full text
    Get full text
  2. 2
  3. 3

    Wind energy potential along the onshore and offshore Qatar by Mohammed, Aboobacker Valliyil

    Published 2020
    “…Among the select locations, the highest annual mean wind power density is obtained in the o?shore Ruwais (152 W/m2), followed by o?shore Ras La?an (134 W/m2) and land area of Al Khor (120 W/m2). …”
    Get full text
    Get full text
  4. 4
  5. 5

    Electronic vs Ionic limitations to electrochemical performance in Li4Ti5O12-based organic suspensions for lithium-redox flow batteries by Madec, L.

    Published 2014
    “…Above a critical thickness in the 0.5-1 mm range, depending on the LTO content, the rate performance are significantly decreased. …”
    Get full text
    Get full text
    Get full text
  6. 6

    Enhanced oil recovery using hyperbranched polyglycerol polymer-coated silica nanoparticles by Elmobarak W.F.

    Published 2021
    “…dem improved as the Csur and pH decreased, with maximum values of 98.8% and 98.5% achieved at Csur = 0.05 g/L and a pH = 4, respectively. …”
    Get full text
    Get full text
  7. 7
  8. 8
  9. 9

    Application of magnetic nanoparticles for the removal of oil from oil-in-water emulsion: Regeneration/reuse of spent particles by Elmobarak W.F.

    Published 2021
    “…This change is due to the decrease in the emulsion stability and the formation of fine oil droplets. …”
    Get full text
    Get full text
  10. 10

    Application of Fe3O4 magnetite nanoparticles grafted in silica (SiO2) for oil recovery from oil in water emulsions by Elmobarak W.F.

    Published 2021
    “…Using an MDdose as low as 10 mg/L attained a %ηdem in the range of 93%–94.3% for O/W mixtures with Coil < 2000 mg/L, which slightly decreased to ∼90% for higher concentrations. …”
    Get full text
    Get full text
  11. 11
  12. 12
  13. 13
  14. 14
  15. 15
  16. 16

    Functionalization of silica-coated magnetic nanoparticles as powerful demulsifier to recover oil from oil-in-water emulsion by Elmobarak W.F.

    Published 2021
    “…This study presents an innovative approach for the preparation of Fe3O4 nanoparticles covered with SiO2 shell (denoted as Fe–Si-MNP), which were used to recover oil recovery from oil-in-water emulsion (O/W-emul). The Fe–Si-MNP were prepared with differing silica layer thicknesses (5 nm [Fe–Si-1], 8 nm [Fe–Si-2], 10 nm [Fe–Si-3], and 15 nm [Fe–Si-4]) and tested for the percentage of oil separation (%Soil) under different dosages (DMNP), oil concentration (Doil), surfactant dosages (Dsur), and pH. …”
    Get full text
    Get full text
  17. 17

    Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study by Hamza A.

    Published 2021
    “…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”
    Get full text
    Get full text
    Get full text
  18. 18

    ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY by MESLAM, MENTALLAH MOHAMED HASSANIN MOHAMED HASSANIN

    Published 2022
    “…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …”
    Get full text
  19. 19

    Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

    Published 2022
    “…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
    Get full text
    Get full text
    Get full text
  20. 20

    Reinforcement of polyacrylamide-co-tert-butyl acrylate base gel using nanosilica for conformance control at low and high reservoir temperatures by Shamlooh M.

    Published 2020
    “…In this study, different ratios of polymer to crosslinker were investigated to choose the optimum combination. Then, nanosilica (NS) with different sizes (20, 50 and 85 nm) was added to the polymeric formulation with the inorganic crosslinker (CrAc3) to study the effect of silica content and size on gel strength. …”
    Get full text
    Get full text