Electronic vs Ionic limitations to electrochemical performance in Li4Ti5O12-based organic suspensions for lithium-redox flow batteries by Madec, L.

“…Above a critical thickness in the 0.5-1 mm range, depending on the LTO content, the rate performance are significantly decreased. …”
Get full text
Get full text
Get full text

SARS-CoV-2 infection triggers more potent antibody-dependent cellular cytotoxicity (ADCC) responses than mRNA-, vector-, and inactivated virus-based COVID-19 vaccines by Zedan, Hadeel T.

“…Notably, omicron infection showed reduced overall ADCC activity compared to WT SARS-CoV-2 infection. Although post-mRNA vaccination BTI elicited high levels of binding and NAbs, ADCC activity was significantly reduced. …”
Get full text
Get full text
Get full text

ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY by MESLAM, MENTALLAH MOHAMED HASSANIN MOHAMED HASSANIN

“…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …”
Get full text

Modification of Pd/CeO2 catalyst by Atomic Layer Deposition of ZrO2 by Onn, Tzia Ming

“…Methane-oxidation rates in 0.5% CH4 and 5% O2 were slightly lower on the ZrO2-covered catalyst when both materials were calcined at 673 K but the activity of the ZrO2-modified catalyst did not decrease with catalyst calcination temperature. …”
Get full text
Get full text

Microstructure, wear and corrosion characteristics of Cu matrix reinforced SiC–graphite hybrid composites by Jamwal A.

“…Copper matrix composites with SiC-graphite reinforcement (0, 2.5,5, 7.5 and 10 wt.%) were prepared by stir casting process. …”
Get full text
Get full text

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study by Hamza A.

“…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”
Get full text
Get full text
Get full text

Thermally conductive polyethylene/expanded graphite composites as heat transfer surface: Mechanical, thermo-physical and surface behavior by Sobolčiak, Patrik

“…Moreover, the surface wettability of the HDPE/EG composite was enhanced by corona and RF plasma treatment as demonstrated by the increase in surface free energy from 28.5 mJ/m2 for untreated HDPE/EG to 55.5 and 54.5 mJ/m2 for HDPE/EG treated by corona and RF plasma, respectively. …”
Get full text
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Date palm wood flour/glass fibre reinforced hybrid composites of recycled polypropylene: Mechanical and thermal properties by AlMaadeed, Mariam A.

“…Morphological studies indicated that glass fiber has good adhesion with recycled PP supporting the improvement of the mechanical properties of hybrid composites with glass fiber addition. Addition of as little 5wt% glass fibre to wood flour reinforced RPP increases the tensile strength by about 18% relative to the wood flour reinforcement alone. …”
Get full text
Get full text
Get full text

Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites by Mittal, P.

“…Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. …”
Get full text
Get full text

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles by Chamakh, Mariem

“…The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 �C for 4 h to form the ruthenium oxide nanoparticles. …”
Get full text
Get full text

Mechanical Performance and Thermo-Physical Properties of Cement Mortar Incorporating Hybrid Slags by Baawain, Mahad

Get full text
Get full text

Influence of nitrogen doping on the electrocatalytic activity of Ni-incorporated carbon nanofibers toward urea oxidation by Barakat, Nasser A.M.

“…However, the electrochemical measurements indicated that the content of the urea in the initial electrospun solution should be optimized as the results showed that the best nickel surface activation as well as the maximum observed current density can be achieved when the urea content is kept at 5 wt%. Typically, the observed current densities using 1.0 M urea (in 1 M KOH) were 3.15, 29.7, 13.75, 47.55, 14.13 and 9.85 mA/cm2 for the nanofibers obtained from electrospun solutions having 0, 1, 2, 5, 7 and 9 wt% urea, respectively. …”
Get full text
Get full text

Optimization of performance and emission characteristics of CI engine fueled with Jatropha biodiesel produced using a heterogeneous catalyst (CaO) by Singh, A.

“…The heterogeneous transesterification delivered a yield of 81.6% at 5 wt% catalyst concentration and 12:1 methanol to oil molar ratio. …”
Get full text
Get full text

Synthesis and characterisation of Co2+-incorporated ZnO nanoparticles prepared through a sol-gel method by Ba-Abbad, Muneer M.

“…The band gap of the Co2+-doped ZnO samples decreased from 3.19 to 2.66 eV as the content of dopant Co2+ increased from 0.0 to 1.0 wt.%. …”
Get full text
Get full text

A lipidomic screen of hyperglycemia-treated HRECs links 12/15-Lipoxygenase to microvascular dysfunction during diabetic retinopathy via NADPH oxidase by Ibrahim, Ahmed S.

Get full text
Get full text

Enhanced quality factor of polyvinyl formal (PVF) based nanocomposites filled with zinc oxide and carbon black nanoparticles for wireless sensing applications by Mohanapriya, M.K.

“…The incorporation of ZnO at 10% decreases Q-factor to 36.1. Incorporation of CBNP at 5% and ZnO at 5% further reduces the Q-factor to 13.7. …”
Get full text
Get full text

Antibacterial Properties of Polysulfone Membranes Blended with Arabic Gum. by Sabri, Souhir

Get full text
Get full text

Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings by Ubaid F.

“…Various contents of the encapsulated TiO2 nanotubes (1, 3 and 5 wt%) were thoroughly dispersed into the epoxy matrix and the resulting composites were then applied on a cleaned steel substrate using doctor blade technique to develop smart coatings. …”
Get full text
Get full text

Tailoring electrocatalytic properties of Pt nanoparticles grown on Ti3C2Tx MXene surface by Filip, Jaroslav

“…Composites containing 14 wt% Pt showed HER with an onset potential of −75.9 mV and a current density of −10 mA cm−2 achieved at −226 mV. …”
Get full text
Get full text
Get full text