Experimental and Analytical Investigations of the Use of Groove-Epoxy Anchorage System for Shear Strengthening of RC Beams Using CFRP Laminates by Mohamed, Khalid Mustafa Elradi

“…The developed models predicted the experimental shear-strength of the tested RC beams with a good level of accuracy, with an average mean absolute percent error (MAPE) = 3.31% and 6.68%, normalized mean square error (NMSE) = 0.072, 0.523, and coefficient of determination R2 = 0.964, 0.691, for plates and sheets, respectively.…”
Get full text

Effects of polyphenol‐rich traditional herbal teas on obesity and oxidative stress in rats fed a high‐fat–sugar diet by Neelam Iftikhar (14778400)

“…Higher doses of <i>Hibiscus rosa-sinensis</i> significantly decreased the levels of AST, ALT, AP, and SC in comparison with the HFSDC group. …”

Production of self-compacting concrete using Jordanian oil shale ash by Ashteyat, Ahmed

“…The strength of the SCC concrete decreased with higher OSA replacement contents although maintaining a higher value than that of conventional concrete made at almost the same cement factor. …”
Get full text

Nanoporous graphene monolith for hydrogen storage by Romanos, J.

Get full text
Get full text
Get full text
Get full text

Confidence in Public Institutions and the Run up to the October 2019 Uprising in Lebanon by Fakih, Ali

Get full text
Get full text
Get full text

IS security menace by Balozian, Puzant

“…It is widely believed in IS security literature that enforcing IS security policy compliance on employees through various means is the solution for security effectiveness. …”
Get full text
Get full text
Get full text

Improvement Algorithm for Limited Space Scheduling by Zouein, Pierrette

“…This paper addresses the combined problem termed “space scheduling” and presents an algorithmic time-space trade-off model for adjusting activity durations and start dates to decrease the need for space over congested time periods. …”
Get full text
Get full text

Optimum sizing of steam turbines for concentrated solar power plants by Poullikkas, Andreas

“…For capacity sizes of 10kWe up to 50MWe, the steam turbine efficiency increases and the steam turbine expected specific capital cost of the power block decreases at a high rate, whereas for larger sizes they remain almost constant. …”
Get full text

Modeling the influence of daily temperature and precipitation extreme indices on vegetation dynamics in Katsina State using statistical downscaling model (SDM) by Mohammad, Hadi Ahmad

“…The results indicate that the statistical downscaling model (SDSM) is performing satisfactorily in predicting maximum and minimum temperatures, along with precipitation, for the time horizon of the simulation. Mean precipitation of 1.98 mm (RCP2.6), 2.03 mm (RCP4.5), and 2.07 mm (RCP8.5) was revealed in the study area. …”
Get full text
Get full text
Get full text

Dietary Calcium Intake of 1200 mg/d May Have Negative Correlation on Percent Body Fat by Dimassi, Hani I.

“…The high-calcium group (intake ≥1200 mg/d) had a significantly higher mean caloric intake (P ≤ .01) and significantly lower percent body fat (P ≤ .05) than the low-calcium group (intake <1200 mg/d). …”
Get full text
Get full text

A snapshot of current medical research: The notion of supply and demand by Almutairi, Adel F.

“…The primary goals of many researchers are to improve the quality of healthcare services, provide evidence to guide practice, provide better treatment regimens for some diseases, decrease the burden caused by chronic diseases, fight incurable diseases, and contain any potential emerging pathogens. …”
Get full text
Get full text
Get full text

Innovation in Public Private Partnership (PPP) in the UAE Construction Industry by ALHYARI, MUTAZ MOHAMMAD AHMAD

Get full text

Investigating the causes and drivers of food waste in the hospitality sector in Dubai-UAE. Toward implementing food waste prevention strategies.” by SADEH, REHAM ZEYAD

“…Tackling this issue needs the united efforts of the private and public sectors and is considered under goal SDG 12.3. Food loss is the decrease in food amounts before consumption, mostly in developing countries. …”
Get full text

Confinement Effectiveness in Rectangular Concrete Columns with Fiber Reinforced Polymer Wraps by Tabbara, Mazen

Get full text
Get full text
Get full text

A comprehensive design and rating study of evaporative coolers and condensers. Part I. Performance evaluation by QURESHI, BILAL AHMED

“…It is demonstrated that thermal effectiveness of the evaporative heat exchangers degrades significantly with time indicating that, for a low risk level (pZ0.01), there is about 66.7% decrease in effectiveness for the given fouling model. …”
Get full text

Barriers of Additive Manufacturing Adoption in United Arab Emirates Automotive Supply Chain by ALI, ASMA ALI ABDULLA

“…AM offers a tremendous opportunity by improving adaptability and efficiency of the supply chain such as reducing lead times, decreasing the dependence on foreign suppliers, and promoting sustainability in manufacturing processes. …”
Get full text

Developing a Framework for improving Business Continuity Management success (BCM) in UAE Construction Industry by ALFALASI, ALMUR ABDULLA

“…The main purpose of carrying out this study was to explore the concept of Business Continuity Management (BCM). …”
Get full text

A stochastic dominance test under survey nonresponse with an application to comparing trust levels in Lebanese public institutions by Fakih, Ali

Get full text
Get full text
Get full text
Get full text

Hypospadias Reconstruction Training: Development of an Ex-Vivo Model for Objective Evaluation of Surgical Skills by Abbas, Tariq

“…Additionally, the mean power spectral density of the EMG signal decreased notably post-training. …”
Get full text
Get full text
Get full text

Energy saving potential analysis applying factory scale energy audit – A case study of food production by Derar, Al Momani

“…The CO2 harmful emissions were also decreased. Additionally, it is estimated that switching from the proposed motors to energy-efficient motors will cost less overall over time, saving around 3472.314 JD/month or 0.33576/year on average. …”
Get full text
Get full text
Get full text