-
41
Evaluation of Workability and Structuration Rate of Locally Developed 3D Printing Concrete Using Conventional Methods
Published 2022“…Concrete 3D printing is a novel construction method that can bring new horizons to the construction industry. …”
Get full text
article -
42
-
43
Biomolecular changes and subsequent time-dependent recovery in hippocampal tissue after experimental mild traumatic brain injury
Published 2021“…This study reports the time-dependent contextual and structural effects of TBI on hippocampal brain tissue. …”
-
44
3D Concrete Printing Sustainability: A Comparative Life Cycle Assessment of Four Construction Method Scenarios
Published 2020“…The LCA analysis showed that 3DCP significantly reduced environmental effects in terms of global warming potential (GWP), acidification potential (AP), eutrophication potential (EP), smog formation potential (SFP), and fossil fuel depletion (FFD), as compared to conventional construction methods. However, these environmental improvements diminished when 3DCP was coupled with the use of conventional reinforcement elements. …”
-
45
Stochastic Programming for Hub Energy Management Considering Uncertainty Using Two-Point Estimate Method and Optimization Algorithm
Published 2023“…Additionally, the results show that TPEM approach dependability consideration decreased hub energy’s profit by 8.995% as compared to deterministic planning.…”
-
46
A new method for broad‐scale modeling and projection of plant assemblages under climatic, biotic, and environmental cofiltering
Published 2023“…Our method also increases the practicality of assisted colonization of plant species by helping to prevent ill-advised introduction of plant species with limited future survival probability.…”
-
47
Bulk passivation of perovskite films utilizing halide anion ionic liquids
Published 2023“…The decay of charge carriers within the perovskite film before and after passivation with ILs was measured by Time Resolved Photoluminescence Spectroscopy (TRPL). …”
Get full text
article -
48
-
49
On the Performance of the Node Control Volume Finite Element Method for Modeling Multi-phase Fluid Flow in Heterogeneous Porous Media
Published 2020“…Large artificial fluid smearing is observed in coarse meshes; however, it decreases with the increase in mesh resolution. These findings prompt the use of high-resolution meshes for the method and the need for development of novel numerical methods to address this unphysical flow.…”
-
50
-
51
The Effect of Experimental Recuperative and Appetitive Post-lunch Nap Opportunities, With or Without Caffeine, on Mood and Reaction Time in Highly Trained Athletes
Published 2021“…<h3>Purpose</h3><p dir="ltr">To investigate the effects of placebo (PLA), 20 min nap opportunity (N20), 5mg·kg<sup>−1</sup> of caffeine (CAF), and their combination (CAF+N20) on sleepiness, mood and reaction-time after partial sleep deprivation (PSD; 04h30 of time in bed; <i>study 1</i>) or after normal sleep night (NSN; 08h30 of time in bed; <i>study 2</i>).…”
-
52
Health in times of uncertainty in the eastern Mediterranean region, 1990–2013: a systematic analysis for the Global Burden of Disease Study 2013
Published 2016“…The objective of this study was to present the burden of diseases, injuries, and risk factors in the eastern Mediterranean region as of 2013. Methods: GBD 2013 includes an annual assessment covering 188 countries from 1990 to 2013. …”
Get full text
Get full text
Get full text
article -
53
-
54
A 28 nm CMOS 10 bit 100 MS/s Asynchronous SAR ADC with Low-Power Switching Procedure and Timing-Protection Scheme
Published 2021“…A single-side-fixed technique is utilized to reduce the number of capacitors; a parallel split capacitor array in combination with a partially thermometer coded technique can minimize the switching energy, improve speed, and decrease differential non-linearity (DNL). In addition, a compact timing-protection scheme is proposed to ensure the stability of the asynchronous SAR ADC. …”
-
55
Multilayer Reversible Data Hiding Based on the Difference Expansion Method Using Multilevel Thresholding of Host Images Based on the Slime Mould Algorithm
Published 2022“…As a result, the embedding capacity in each class can increase by reducing the value of the difference between two consecutive pixels, and the distortion of the marked image can decrease after inserting the personal data using the DE method. …”
Get full text
-
56
Wave-packet dynamics in monolayer graphene with periodic scattering potentials
Published 2025“…<p dir="ltr">We use the Dirac <u>continuum model</u> to study the propagation of electronic wave packets in monolayer graphene in the presence of periodically arranged circular potential steps. The time propagation of the wave packets is calculated using the split-operator method for different sizes, heights, and separations of the barriers. …”
-
57
A new method for improving the solar photovoltaic unit efficiency through neem oil as coolant medium for high power applications—an experimental investigation
Published 2024“…Thus, the critical outcomes of the monocrystalline and polycrystalline PV panels are to decrease the panel temperature by 2.29% and 4.34%, respectively, and enhance the efficiency of the PV panels by 15.0% and 17.8%, respectively.…”
-
58
Global time differences in road traffic injuries among children and adolescents between and 1990 and 2013: Regional and economical perspectives from global burden of diseases study
Published 2015“…To highlight changes over time in RTI mortality among children and adolescents VRU and non-VRU globally, by region, and by country income level between 1990 and 2013. …”
-
59
Accelerating Care: Enhancing Patient Satisfaction through a Quality Initiative in the Obstetrics and Gynaecology Emergency Department at Al Wakra Hospital, Qatar
Published 2023“…Notably, there was a remarkable decrease in patients who Left Without Being Seen (LWBS) and in absconded patient rates from 2020 to 2023 (Figure 2).…”
-
60
Effect of Surface Treatment of Halloysite Nanotubes (HNTs) on the Kinetics of Epoxy Resin Cure with Amines
Published 2020“…In fact, by the introduction of nanotubes the mobility of curing moieties decreased resulting in some deviation of experimental cure rate values from the predicted values obtained using KAS and Friedman methods.…”