Effect of Construction Void Defects on Flexural and Axial Load Capacity of Reinforced Concrete Members by Al Moukdad, Mohammad Mustafa

Get full text

Effects of organic enrichment on macrofauna community structure: an experimental approach by Rodrigo Riera (10476249)

“…An experiment was conducted with three treatments (Control, 1x and 3x),in which organic load (fish pellets) was added (1x (10 g of fish pellets) and 3x (30 g)). …”

The effect of Dopamine Agonists on patients with advanced Parkinson's disease subjected to subthalamic deep brain stimulation. (c2000) by Jabre, Mazen Gerges

“…The mean levodopa dose was reduced by 90% (p < 0.01), while the mean dopamine agonist dose was increased by 15% from preoperative level. …”
Get full text
Get full text

“Enhanced Forced Convection Heat Transfer from a Cylinder using Permeable Fins, by Abu-Hijleh, Bassam

“…The use of 1–2 permeable fins resulted in much higher Nusselt number values than when using up to 18 solid fins. …”
Get full text

Two-surgeon technique of parenchymal transection contributes to reduced transfusion rate in patients undergoing major hepatectomy by Palavecino, Martin

“…In-hospital transfusions are still reported in one third of patients in major series. Data on factors affecting blood transfusions in large series of liver resection are limited. …”
Get full text
Get full text
Get full text

Effects of polyphenol‐rich traditional herbal teas on obesity and oxidative stress in rats fed a high‐fat–sugar diet by Neelam Iftikhar (14778400)

“…Three herbal teas were prepared from <i>Hibiscus rosa-sinensis</i> flowers and <i>Zingiber officinalis</i> rhizomes and their mixture (3:1, respectively). …”

Application of Zn-ferrite towards thermochemical utilization of carbon dioxide: A thermodynamic investigation by Rahul R. Bhosale (6467102)

“…At a steady gas-to-gas heat recovery effectiveness equal to 0.7, a rise in the ratio of the molar flow rate of inert sweep gas to the molar flow rate of ZnFe₂O₄ from 10 to 90 is responsible for an increase in the thermal energy required to drive the cycle above 184.9 kW by a factor of 1.45 and decrease in the solar-to-fuel energy conversion efficiency by 4%. …”

The effect of Inula Viscosa extract on inflammation, microbial growth, glycemia, and blood lipid profile. (c2005) by Zaza, Rola Mouin

Get full text
Get full text

Diabetic Sensorimotor Polyneuropathy Severity Classification Using Adaptive Neuro Fuzzy Inference System by Fahmida Haque (16896489)

“…<p dir="ltr">Diabetic sensorimotor polyneuropathy (DSPN) is an early indicator for non-healing diabetic wounds and diabetic foot ulcers, which account for one of the most common complications of diabetes, leading to increased healthcare cost, decreased quality of life, infections, amputations, and death. …”

Timing driven genetic placement by Sait, Sadiq M.

Get full text

Recovery of business intelligence systems by Haraty, Ramzi A.

“…Denial of service affects the continuity of the healthcare system which in turn threatens patients’ lives, decreases the efficiency of the healthcare system and increases the operating costs of the attacked healthcare organization. …”
Get full text
Get full text
Get full text
Get full text

Light chain amyloidosis presenting with autoimmune hepatitis-primary sclerosing cholangitis overlap syndrome by Hammad Shabir Chaudhry (20376378)

“…Magnetic resonance cholangiopancreatography was done to diagnose PSC. A kidney biopsy was done to diagnose amyloidosis. …”

An improved non-dimensional model of wet-cooling towers by QURESHI, BILAL AHMED

Get full text

Burden of disease scenarios for 204 countries and territories, 2022–2050: a forecasting analysis for the Global Burden of Disease Study 2021 by Stein Emil, Vollset

“…MethodsUsing forecasts of major drivers of health such as the Socio-demographic Index (SDI; a composite measure of lag-distributed income per capita, mean years of education, and total fertility under 25 years of age) and the full set of risk factor exposures captured by GBD, we provide cause-specific forecasts of mortality, years of life lost (YLLs), years lived with disability (YLDs), and disability-adjusted life-years (DALYs) by age and sex from 2022 to 2050 for 204 countries and territories, 21 GBD regions, seven super-regions, and the world. …”
Get full text
Get full text
Get full text

Changing life expectancy in European countries 1990–2021: a subanalysis of causes and risk factors from the Global Burden of Disease Study 2021 by Nicholas, Steel

“…In 2019–21, there was an overall decrease in mean annual life expectancy across all countries (overall mean –0·18 years [95% UI –0·22 to –0·13]), with all countries having an absolute fall in life expectancy except for Ireland, Iceland, Sweden, Norway, and Denmark, which showed marginal improvement in life expectancy, and Belgium, which showed no change in life expectancy. …”
Get full text
Get full text
Get full text

Zirconium phytate-based proton conductors for high-temperature fuel cell applications by Nimir, Wessam Ahmed Mohamed

Get full text

An adaptive load-balancing approach to XML-based network management using JPVM by Sqalli, M.H.

Get full text
Get full text

Timing driven genetic algorithm for standard-cell placement by Sait, Sadiq M.

Get full text
Get full text

Macular ultrastructural features in amblyopia using high-definition optical coherence tomography by Al-Haddad, Christiane Elias

“…Also, amblyopic eyes demonstrated a shallow foveal pit compared with normal fellow eyes. Mean foveal thickness was significantly increased in amblyopic (228.56 µm) versus fellow eyes (221.72 µm), p=0.03. …”
Get full text
Get full text
Get full text
Get full text

Experimental and Analytical Investigations of the Use of Groove-Epoxy Anchorage System for Shear Strengthening of RC Beams Using CFRP Laminates by Mohamed, Khalid Mustafa Elradi

“…The developed models predicted the experimental shear-strength of the tested RC beams with a good level of accuracy, with an average mean absolute percent error (MAPE) = 3.31% and 6.68%, normalized mean square error (NMSE) = 0.072, 0.523, and coefficient of determination R2 = 0.964, 0.691, for plates and sheets, respectively.…”
Get full text