Structural and magnetic properties of Ni1-xZnxFe 2O4 (x=0, 0.5 and 1) nanopowders prepared by sol-gel method by Gao P.

“…As the grain size increased, the Curie temperature of NiFe 2O4 increased from 849 to 859 K. The highest saturation magnetization of 70 emu/g at 298 K and the highest specific heating rate of 1.6 K/s under radiofrequency heating at 295 kHz were observed over NiFe 2O4 calcined at 1073 K. …”
Get full text
Get full text

Correlating the rheological and magneto-optical properties of cobalt substituted magnetite ferrofluids (CoxFe1?xFe2O4) with theoretical studies by Babukutty, B.

Get full text
Get full text

Application of magnetic nanoparticles for the removal of oil from oil-in-water emulsion: Regeneration/reuse of spent particles by Elmobarak W.F.

“…A lower DMNP of 5 mg/L recovered up to 55.6% of the oil, while increasing the DMNP > 50 mg/L did not significantly affect the %ηdem nor the %Roil. …”
Get full text
Get full text

Detoxification assays of tunisian tannery wastewater under nonsterile conditions using the filamentous fungus aspergillus Niger by Boujelben, Raouia

“…11; thus experiments were carried out at initial pH values and at pH adjusted to 6. Characterization of effluents also revealed high salt levels (EC > 17 mS/cm) and high organic matter content (25 g/L for the UE and 7.2 g/L for the FE) but a low biodegradability since BOD5 did not exceed 2.5 and 1.25 g/L for the UE and the FE, respectively. …”
Get full text
Get full text

Effect of Magnetic Baffles and Magnetic Nanofluid on Thermo-Hydraulic Characteristics of Dimple Mini Channel for Thermal Energy Applications by Souayeh, Basma

“…When two sources are placed at x = 7.5 mm and 15 mm, there is an decrease of 19.02%, 31.3%, and 50.34% in the pressure drop when the magnetic fields of 1200 G, 1500 G and 2000 G are applied when the pitch = 10 mm. …”
Get full text
Get full text
Get full text

Developing pretreatment methods to promote the production of biopolymer and bioethanol from residual algal biomass (RAB) by Fares, AlMomani

“…The maximum bioethanol production (Mbio−ethP) of 0.950 ± 0.005 mL/gRAB was achieved using microalgae pretreated with Mv-H2O2-Fe-PT and incubated at pH = 5.5 and 37 °C. …”
Get full text
Get full text
Get full text

Enhanced oil recovery using hyperbranched polyglycerol polymer-coated silica nanoparticles by Elmobarak W.F.

“…dem improved as the Csur and pH decreased, with maximum values of 98.8% and 98.5% achieved at Csur = 0.05 g/L and a pH = 4, respectively. …”
Get full text
Get full text

Molecular and Structural Changes in Induced-Brain Stroke Tissue Using FTIR Imaging Spectroscopy, Scanning Electron and Atomic Force Microscopy by Ali, Mohamed H

“…1695-1637 cm-1) and small variation in the amide II band at (1543 cm-1). Figure 6b represents the loading spectra of the PC4, PC5 and PC6. …”
Get full text
Get full text