Evaluation of 3D Concrete Printing in the United Arab Emirates by Alchaar, Aktham S.

Get full text

Experimental Investigation of FRP-Reinforced Concrete Columns Under Concentric and Eccentric Loading by Elmesalami, Nouran Zinelabdin Ahmed

Get full text

Driving simulation sickness and the sense of presence: Correlation and contributing factors by Mustafa Almallah (17280568)

“…Importantly, designing buildings that replicate a real-world environment could increase SP and decrease SS. Moreover, designing high quality and resolution scenarios could also increase SP, thus decreasing the severity of SS symptoms. …”

A control algorithm to increase the efficient operation of wind energy conversion systems under extreme wind conditions by Nyam Jargalsaikhan (17380429)

“…<p dir="ltr">This paper aims to increase the power production of gearless permanent magnet synchronous generator (PMSG) based wind energy conversion systems (WECS) in strong (greater than 25 m/s) wind speed regions. In general, most wind turbines cut off when wind speed is over the cut-out rate; as a result, the power generation of the wind farm decreases. …”

Impact of Exclusive Bus Lanes on Traffic Performance in Urban Areas by Abdulwahid, Amro Riyadh

Get full text

Numerical Investigation of the Fetal Left Heart Hemodynamics During Gestational Stages by Huseyin Enes Salman (18131794)

“…This maximum WSS decreases to 11 Pa at the gestational week of 27, indicating nearly three-times reduction in the peak shear stress. …”

Effect of Crude Oil Products on the Geotechnical Properties of Sandy Soil by Shaheen, Ehab Taher

Get full text

Effects of ethanol addition to diesel–biodiesel blends on the CI engine characteristics by Fakher Hamdi (21225134)

“…Biodiesel addition significantly increases carbon monoxide (CO) emissions, reaching an average of 190% across all speeds. However, adding ethanol helps mitigate this increase, especially at low and medium speeds, with an average decrease of 32% for a 2.5% ethanol blend compared to B0. …”

A numerical study of friction in isothermal EHD rolling-sliding sphere-plane contacts with spinning by Dormois, H.

“…They are expected to further decrease friction in real situations due to shear heating.…”
Get full text
Get full text
Get full text

Battery Energy Management Techniques for Electric Vehicle Traction System by AbdelAziz, Ahmed Sayed AbdelAal

Get full text

Effect of temperature on the rheological properties of neat aqueous Wyoming sodium bentonite dispersions by Vryzas, Zisis

“…The Bingham yield stress, from the low shear rate data, increased linearly with temperature, while the plastic viscosity decreased with temperature, in a manner very similar to the decrease of water viscosity with temperature. …”
Get full text
Get full text
Get full text
Get full text

Lateral Confinement of RC Columns by Internal Structural Steel Strip Bands by Towaiq, Ahmad

Get full text

Effect of Bentonite Permeation on the Fabric and Strength of Ottawa Sand by Mourtada, Dani Imad

“…However, resonant column tests on bentonite-treated dry mixed Ottawa Sand samples showed a decrease of the small strain stiffness modulus (Gmax) and thus a decrease in the shear strength of the treated soil compared to that of clean Ottawa Sand samples. …”
Get full text
Get full text
Get full text

1787 evaluation of transperineal prostatic administration of a PSA-activasted protoxin (PRX302) in men with luts secondary to BPH by Elhilali, Mostafa

“…In the Phase I study, mean IPSS showed a decrease of 6.5 points (34%), mean QoL a decrease of 2 points (44%) and mean prostate volume a decrease of 5.5 cc (13%) at 12-months compared to screening. …”
Get full text
Get full text
Get full text
Get full text

Cryomyolysis, a new procedure for the conservative treatment of uterine fibroids by Zreik, Tony

“…Normal uterine volume ranged from 35.6 to 548.7 ml preoperatively and 45.1 to 729.6 ml postoperatively (mean increase 40%); however, myoma volume showed a mean decrease of 6% (range-87-28%). …”
Get full text
Get full text
Get full text

Evaluation of the Surface Integrity and Recast Layer in Electrical Discharge Turning of WC-Co Composites by Mehdi Soleymani (3347741)

“…The results indicated that increasing the rotational speed led to a 10% to 17% decrease in the recast layer thickness and a 14% to 54% reduction in the surface roughness (Ra).…”

Improving the Performance Measurement Using Overall Equipment Effectiveness (OEE) in Borouge by ALMUTAWA, MUBARAK

“…The findings show there is no set up/adjustment and speed losses. Moreover, breakdown losses were 2.2% for first extruder and 6.06% for second extruder, and decreased quality losses were 1.28% for first extruder and 2.8% for second extruder for the study of six significant losses (which became three big losses due to speed losses and set up/adjustment do not exist).…”
Get full text

Exploring urban growth–climate change–flood risk nexus in fast growing cities by Salah Basem Ajjur (14150967)

“…Surveying showed that, between 1984 and 2020, urban areas grew by 777%, and bare lands decreased by 54.7%. In addition, Doha witnessed various climatic changes with a notable increase in air temperature (+ 8.7%), a decrease in surface wind speed (− 19.5%), and a decrease in potential evapotranspiration losses (− 33.5%). …”

Effect of Girder Damage on the Structural Behavior of Slab-on-Girder Bridges by Elozn, Ahmed E.

Get full text

Empirical evaluation of change in crash risk due to lane marking reallocation: A case study in Kochi City, Japan by Hiroaki, Nishiuchi

“…In addition, the results indicate that the PICUD value tends to decrease (i.e., the crash risk tends to increase) with increasing speed of the following vehicle relative to the leading vehicle. …”
Get full text
Get full text
Get full text