Showing 1,261 - 1,280 results of 1,517 for search '(( ((10 i) OR (16 i)) decrease ) OR ( 5 ((step decrease) OR (((mean decrease) OR (a decrease)))) ))', query time: 0.21s Refine Results
  1. 1261

    The Association between Zinc and Copper and Cardiometabolic Risk Factors in Adults by Al Kudsi, Dana Samir

    Published 2021
    “…High Zn/Cu ratio increased the prevalence of low HDL (4.508; p?0.001) and MetS (5.570; p?0.01). These findings suggest that high Cu levels are associated with a protective effect on DBP, HDL, and MetS and that high plasma Zn/Cu ratio is associated with the risk of low HDL and MetS. …”
    Get full text
    Get full text
  2. 1262

    Electrochemical oxidation of ammonia (NH4+/NH3) ON synthesized nickel-cobalt oxide catalyst by Almomani F.

    Published 2021
    “…The reported Pgen were 0.55, 0.85, 1.1 and 0.0.93 mW/cm2 for Ni–C, Co10/Ni–C, Co20/Ni–C and Co40/Ni–C. …”
    Get full text
    Get full text
  3. 1263
  4. 1264
  5. 1265

    Persistent viral infectivity after 27 days from COVID-19 symptoms onset by Zupin, Luisa

    Published 2021
    “…The persistence of SARS-CoV- 2 in pharyngeal swabs belonging to patients affected by COVID-19 is not a rare occurrence. …”
    Get full text
    Get full text
  6. 1266

    Detailed organic characterization of process water to evaluate reverse osmosis membrane fouling in industrial wastewater treatment by Minier-Matar, Joel

    Published 2024
    “…In gas production facilities, process water typically has lower salinity (i.e., <10,000 mg/L) which present opportunities for these wastewaters to be treated for beneficial reuse applications via advanced water treatment technologies, such as reverse osmosis (RO) membranes. …”
    Get full text
    Get full text
    Get full text
    article
  7. 1267
  8. 1268
  9. 1269
  10. 1270

    Emerging clay-aryl-gold nanohybrids for efficient electrocatalytic proton reduction by Jlassi, Khouloud

    Published 2018
    “…Both nanohybrids showed efficient electrochemical activity for HER in acidic condition (0.1 M H2SO4) with high current density up to −25 mA.cm−2 at −1 V and 0.148 mV onset. Negligible decreasing in current density and slight shift in onset was observed after 1000 cycles. …”
    Get full text
    Get full text
  11. 1271

    Influence of changing casing groove parameters on the performance of centrifugal compressors near stall condition by Halawa, Taher

    Published 2016
    “…Results showed that by increasing the number of grooves, the surge margin (SM) increases and the isentropic efficiency decreases, but the stall area at the shroud surface decreases in size and its location is shifted toward the blades trailing edge.…”
    Get full text
    Get full text
  12. 1272
  13. 1273
  14. 1274
  15. 1275
  16. 1276
  17. 1277

    Thermochemical splitting of CO2 using solution combustion synthesized lanthanum-strontium-anganese perovskites by Takalkar, G.

    Published 2021
    “…Higher by each LSM perovskite, as compared to the during the first cycle. The is decreased, and the re-oxidation capacity of each LSM perovskite is improved from cycle one to three. …”
    Get full text
    Get full text
  18. 1278

    Structural performance and moment redistribution of basalt FRC continuous beams reinforced with basalt FRP bars by Abushanab, Abdelrahman

    Published 2021
    “…This study investigated the structural performance and moment redistribution of basalt fiber reinforced concrete (BFRC) continuous beams reinforced with basalt fiber reinforced polymers (BFRP) bars. A total of 10 reinforced concrete (RC) continuous beams over two equal spans of 1800 mm were tested under five-point loading until failure. …”
    Get full text
    Get full text
  19. 1279
  20. 1280

    Selective adsorption of carbon dioxide, methane and nitrogen using resorcinol-formaldehyde-xerogel activated carbon by Awadallah, Ahmed

    Published 2017
    “…Adsorption/desorption isotherms of CO2, CH4, and N2 gases onto RF-ACX adsorbent were measured gravimetrically by a magnetic suspension microbalance at five different temperatures (20, 30, 40, 50 and 60 °C) in the pressure range of 0–1 MPa. …”
    Get full text
    Get full text