Showing 781 - 800 results of 1,568 for search '(( 1 1 decrease ) OR ( 5 ((((a decrease) OR (point decrease))) OR (mean decrease)) ))', query time: 0.19s Refine Results
  1. 781

    Enhanced bioelectrochemical treatment of petroleum refinery wastewater with Labaneh whey as co-substrate by Mohanakrishna, Gunda

    Published 2020
    “…Higher LW ratios in PRW lead to the production of VFA which in turn gradually decreased the anolyte pH to below 4.5 (70:30 feed). …”
    Get full text
    Get full text
  2. 782

    The impact of using produced water for plant irrigation and its effects on plants and soil characteristics by Atia, Fathy Atia Mohamed

    Published 2017
    “…The results showed that all plants could not survive except Medicago sativa which tolerated up to 10% produced water with a decrease in intensity, length and biomass. Salsola baryosma tolerated up to20% produced water without any significance differences on the morphological characteristics. …”
    Get full text
  3. 783
  4. 784
  5. 785
  6. 786

    Erratum: ITRAQ-based Quantitative Protein Expression Profiling and MRM Verification of Markers in Type 2 Diabetes (Journal of Proteome Research (2012) 11 (5527-5537) DOI: 10.1021/p... by Kaur, Prabhjit

    Published 2013
    “…As expected, the diabetic cohort showed an elevation in serum glucose, HbA1c, and insulin levels and a decrease in the serum levels of Vitamin D and HDL .Addition/Correctionpubs.acs.org/jpr © 2013 American Chemical Society 1065 dx.doi.org/10.1021/pr4000224 | J. …”
    Get full text
    Get full text
    Get full text
  7. 787

    Ultra-Low Energy CNFET-Based Ternary Combinational Circuits Designs by Jaber R.A.

    Published 2021
    “…The target of this work is to decrease energy consumption by (1) using Multiple-valued logic (MVL) that shows notable enhancements regarding energy consumption over binary circuits and (2) using carbon nanotube field-effect transistors (CNFET) that show better performance than CMOS. …”
    Get full text
    Get full text
  8. 788

    The Mechanical and Thermal Response of Shape Memory Alloy-Reinforced Aluminum Nanocomposites by Penchal, Reddy M.

    Published 2019
    “…YS], damping capacity (Q-1) and damping loss rate (L) was observed, with a concurrent decrease in the values of failure strain (?…”
    Get full text
    Get full text
  9. 789

    Using Event History Analysis in the Social Sciences by Mozahem, Najib A.

    Published 2019
    “…Since the variable of interest is how much time passes between two consecutive logins for each student, I use a statistical technique called event-history analysis or survival analysis. …”
    Get full text
    Get full text
  10. 790

    Do labor remittance outflows retard economic growth in Qatar? Evidence from nonlinear cointegration by Alsamara, Mouyad

    Published 2022
    “…A larger increase in remittance outflows would lead to a decrease in the aggregate demand and produce a deflationary pressure. …”
    Get full text
    Get full text
  11. 791

    Dairy Wastage Footprint Analysis: A Farm-to-Fork Life Cycle Approach Across Dairy Supply Chain. by Al-Obadi, Muna

    Published 2021
    “…Decarbonizing practices in the food industry act as an obstacle in achieving sustainability despite climate change concerns. Roughly one-third of all food produced globally is wasted across the value chain generating 1.6 billion tons of food waste. …”
    Get full text
  12. 792

    Kinetics and mechanism of H2O2 decomposition by Cu(II)-, Co(II)-, and Fe(III)-Amine complexes on the surface of Silica-Alumina (25% Al2O3) by Salem, Mohamed A.

    Published 1994
    “…Both of the energy and entropy of activation were found to decrease as: en > mea > tea and for one ligand (en) and different metal ions the sequence was Cu(II) > Co(II) > Fe(III). …”
    Get full text
    Get full text
  13. 793
  14. 794

    Effects of Turbulence Intensity and Biogas Composition on the Localized Forced Ignition of Turbulent Mixing Layers by d’Auzay, C. Turquand

    Published 2019
    “…The highest heat release rate (HRR) is obtained on the rich premixed branch irrespective of the turbulence intensity and biogas composition, but its magnitude decreases with increasing CO2 dilution. The most probable edge flame displacement speed decreases in time and converges to its theoretical value for laminar cases. …”
    Get full text
    Get full text
  15. 795

    Green handover with a hybrid satisfaction mechanism by Zorba, Nizar

    Published 2013
    “…Green communications have emerged as one of the most important trends in wireless communications because of its several advantages of interference reduction, battery life increase and electrical bill cut. …”
    Get full text
  16. 796

    Burden of disease attributable to suboptimal diet, metabolic risks and low physical activity in Ethiopia and comparison with Eastern sub-Saharan African countries, 1990-2015: findi... by Melaku, Yohannes Adama

    Published 2018
    “…While the age-adjusted proportion of all-cause mortality attributable to CMU decreased significantly between 1990 and 2015, it increased from 10.8% [95% UI: 8.8-13.3] to 14.5% [95% UI: 11.7-18.0] for dietary risks and from 17.0% [95% UI: 15.4-18.7] to 24.2% [95% UI: 22.2-26.1] for metabolic risks. …”
    Get full text
    Get full text
  17. 797

    Flexural Capacity of Sustainable RC Beams Manufactured with Treated Wastewater, RCA, and Fly Ash by Abushanab, Abdelrahman

    Published 2023
    “…Furthermore, FA showed a 5% to 7% improvement in the ultimate loading capacity of the beams.…”
    Get full text
    Get full text
  18. 798

    Failure mode analysis for single-phase Multi-level qZSI interfacing PV system to utility grid by Rahman, Syed

    Published 2017
    “…The power deficit due to a failure of the module is reflected as a decrease in the grid current reference. …”
    Get full text
    Get full text
  19. 799
  20. 800

    Surface Roughness Modelling of the Micromechanically Patterned CNT Forests by Mohd Razib , Mohd Asyraf

    Published 2023
    “…Methods: Experiments were conducted using a CNC machine to pattern onto CNT Forests using specific parameters, such as 1000, 1500, and 2000 rpm (spindle speed) with feed rates of 1, 5 and 10 mm/min. …”
    Get full text
    Get full text