Magnesium-reinforced PMMA composite scaffolds: Synthesis, characterization, and 3D printing <i>via</i> stereolithography حسب Ambreen Afridi (22224310)

"…Notably, pure PMMA exhibited the highest tensile strength, 26.23 ± 0.14 MPa and an elastic modulus of 707.81 MPa, while PMMA resin/1% Mg showed the lowest strength (19.46 ± 0.25 MPa) and modulus (392.88 MPa), indicating a decrease in mechanical integrity with higher Mg content. …"

Enhancing the corrosion resistance of reinforcing steel under aggressive operational conditions using behentrimonium chloride حسب A. Bahgat Radwan (9631720)

"…Herein, the inhibition efficiency of a new corrosion inhibitor, behentrimonium chloride (BTC, C25H54ClN), is explored in a simulated-concrete pore solution (SCP) with 3.5 wt.% NaCl at different pH using electrochemical impedance spectroscopy (EIS) and polarization methods. …"

Stability and thermophysical properties test of carbide-derived carbon thermal fluid; a comparison between functionalized and emulsified suspensions حسب Ismail W. Almanassra (14151321)

Enhanced thermoelectric properties of Bi₂Te_2.55Se_0.45 nanocomposites using eco-friendly Eocene Midra Shale palygorskite nanofillers: A sustainable... حسب Farah M. El-Makaty (14157090)

"…The distinct effects of the present minerals were evident in the thermoelectric properties of the EMS-Bi₂Te_2.55Se_0.45 composites. Incorporating a small quantity of EMS (0.05 wt%) has enhanced the electrical conductivity of the samples relative to the pristine ones, demonstrating the effectiveness of palygorskite nanofibers in facilitating charge carrier transport. …"

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide‐based gels: Rheological and molecular simulation study حسب Ahmed Hamza (7224470)

"…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …"

Corrosion Evaluation of 316L Stainless Steel Exposed to CNT-Water Nanofluid حسب Dana Abdeen (18147583)

"…A maximum inhibition of 61% was achieved in 0.1 wt.% CNTs nanofluid at room temperature. …"

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles حسب Mariem Chamakh (14150481)

Biodegradable polysaccharide grafted polyacrylamide inhibitor for corrosion in CO₂- saturated saline solution حسب Rem Jalab (11715205)

"…Kinetics study at a temperature of 50 °C revealed a deteriorated AGGPAM inhibition attributed to electrolyte diffusion through the weakly adsorbed AGGPAM film. …"