Thermally conductive polyethylene/expanded graphite composites as heat transfer surface: Mechanical, thermo-physical and surface behavior by Sobolčiak, Patrik

“…This enhanced surface wettability was retained over a long time with only a 9% and 18% decrease in RF and corona plasma-treated samples' surface energy after two months. …”
Get full text
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites by Mittal, P.

“…Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. …”
Get full text
Get full text

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles by Chamakh, Mariem

“…The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 �C for 4 h to form the ruthenium oxide nanoparticles. …”
Get full text
Get full text

Mechanical Performance and Thermo-Physical Properties of Cement Mortar Incorporating Hybrid Slags by Baawain, Mahad

Get full text
Get full text

Thermoelectric properties of SbNCa3 and BiNCa3 for thermoelectric devices and alternative energy applications by Bilal, M.

“…The maximum values of thermal conductivity are 92×1014 W/m K s and 88×1014 W/m K s for SbNCa3 and BiNCa3 respectively at a temperature of 900 K. The peak values of 5×1020/Ω m s and 5.2×1020/Ω m s are achieved for n-type SbNCa3 and BiNCa3 respectively at a temperature of 300 K. …”
Get full text
Get full text

Impact of combined oil-in-water emulsions and particulate suspensions on ceramic membrane fouling and permeability recovery by Abdalla M.

“…The addition of 1500 mg·L−1 of bentonite to a 10 vol.% emulsion resulted in a permeability decrease of 3.5–5 times over that recorded for the emulsion, and 8–36 times lower than that of the bentonite suspension. …”
Get full text
Get full text

Evacuated tube heat pipe solar collector for Encontech engine-driven reverse osmosis solar desalination by Takalkar, Gorakshnath

“…The maximum energetic efficiency of 52.5% is obtained for h vacuum (1 W/m2 K). Obtained results further demonstrate that the energetic and exergetic performances of the ETHPSC are higher at T i = 50°C. …”
Get full text
Get full text

Short-term greenhouse emission lowering effect of biochars from solid organic municipal wastes by Rehrah D.

“…Two biochars produced from mixed materials at 300–500 °C for 2 h and used at 0.5–1% application rate performed the best in enhancing soil fertility parameters. …”
Get full text
Get full text

Global patterns and predictions of seafloor biomass using random forests by Wei, C.-L.

Get full text
Get full text

Performance assessment of inductive power transfer for railway applications by Almuhannadi, D.

“…The practical implementation has been conducted at a rated voltage of 100V DC at 50kHz and input power of 80W. …”
Get full text
Get full text

Trends in prevalence of depression and anxiety symptoms and effects of sociodemographic variables before and after the first wave of COVID-19 in Qatar by Khaled, Salma M.

“…The data for 2020/21 showed a 35.1% and 29.2% decrease in depression and anxiety symptoms scores compared to pre-pandemic years (2017/2018) after adjusting for sociodemographic factors. …”
Get full text
Get full text

Enhanced quality factor of polyvinyl formal (PVF) based nanocomposites filled with zinc oxide and carbon black nanoparticles for wireless sensing applications by Mohanapriya, M.K.

“…The incorporation of ZnO at 10% decreases Q-factor to 36.1. Incorporation of CBNP at 5% and ZnO at 5% further reduces the Q-factor to 13.7. …”
Get full text
Get full text

Development of Semitransparent UV Photodetector Based on PTB7-Th:PCBM Composite Using the Cost-effective Fabrication Method by Riaz, Muhammad

“…The variation in UV intensity (0 to 20,000 pW/cm2) and frequency (100 Hz, 1 kHz, 10 kHz, 100 kHz, and 200 kHz) was carried out, and variation of impedance and capacitance has been studied. …”
Get full text
Get full text
Get full text

Antibacterial Properties of Polysulfone Membranes Blended with Arabic Gum. by Sabri, Souhir

Get full text
Get full text

Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings by Ubaid F.

“…Various contents of the encapsulated TiO2 nanotubes (1, 3 and 5 wt%) were thoroughly dispersed into the epoxy matrix and the resulting composites were then applied on a cleaned steel substrate using doctor blade technique to develop smart coatings. …”
Get full text
Get full text

Tailoring electrocatalytic properties of Pt nanoparticles grown on Ti3C2Tx MXene surface by Filip, Jaroslav

“…Composites containing 14 wt% Pt showed HER with an onset potential of −75.9 mV and a current density of −10 mA cm−2 achieved at −226 mV. …”
Get full text
Get full text
Get full text

Yerba Maté (Illex Paraguariensis) ingestion augments fat oxidation and energy expenditure during exercise at various submaximal intensities by Alkhatib, Ahmad

“…Power output was initiated at and increased by 0.5 W.kg-1 of body weight every 3 min stage, until reaching peak oxygen uptake(V˙O2Peak). …”
Get full text
Get full text

Self-healing performance of smart coatings modified with different corrosion inhibitors. by Habib, Sehrish

“…Corrosion results in considerable materials and equipment failure. According to one survey, about 1/4 to 1/3 of the total interruption in industries is due to detrimental effects of corrosion. …”
Get full text
Get full text

Investigational Study for the efficiency of Fe3O4@SiO2 nanoparticles in the Oil Recovery Process using glass micromodel by Elhaj, Wamda

“…In contrast, the value achieved for the seawater injection was 76.5%. For the oil recovery process, the Fe3O4 was applied for the inhibition (i.e., decrease) of oil sedimentation, and the SiO2 NPs were applied for wettability alteration and IFT reduction. …”
Get full text
Get full text