Showing 501 - 520 results of 563 for search '(( 10 (((peer OR per) decrease) OR (((nn decrease) OR (mean decrease)))) ) OR ( 16 a decrease ))*', query time: 0.20s Refine Results
  1. 501
  2. 502
  3. 503
  4. 504
  5. 505
  6. 506
  7. 507

    Evaluation of the Mechanical Properties of AA 6063 Processed by Severe Plastic Deformation by Jafarlou, Davoud Mashhadi

    Published 2015
    “…HA of AA6063 increased the fatigue and fretting fatigue lives of SPD + HT-processed samples at low cycle by 15.5 and 18.4 pct respectively; however, at high cycle, HA had reverse effects, whereby the fatigue and fretting fatigue lives of SPD + HT-processed samples decreased by 16.7 and 30 pct, respectively.…”
    Get full text
    Get full text
  8. 508

    Mixed Solid Municipal Waste-Based Biochar for Soil Fertility and Greenhouse Gas Mitigation by Bansode, Rishipal

    Published 2016
    “…Trays were watered twice daily to maintain moisture level between 10 and 12 percent. The percentage of seed germination was calculated and the plant growth measured as dry biomass. …”
    Get full text
    Get full text
  9. 509
  10. 510
  11. 511
  12. 512

    Simulation and Optimization of an LNG Plant Cold Section by Katebah, Mary Anna

    Published 2018
    “…Using the short cut method, optimization revealed that optimized MR composition resulted in almost 10% MR compression power and 6% plant operating cost savings, whereas new intermediate propane evaporation pressures, identified using detailed simulation, and flowrates decreased the propane compression power and operating costs by around 3.6%, and 2%, respectively. …”
    Get full text
    Get full text
  13. 513
  14. 514

    Investigation of gas-liquid flow using electrical resistance tomography and wavelet analysis techniques for early kick detection by Barooah, Abinash

    Published 2021
    “…The experiments were conducted on a horizontal flow loop of 6.16 mERT with an annular diameter ratio of 1.8 for Newtonian fluid (Water) with varying pipe inclination angle (0 - 10o) and annulus eccentricity (0 - 30%), liquid flow rate (165 - 265 kg/min), and air input pressure (1 - 2 bar). …”
    Get full text
    Get full text
  15. 515

    Thermally assisted efficient electrochemical lithium extraction from simulated seawater by Yanxi, Yu

    Published 2022
    “…The integrated thermally regenerative electrochemical cycle can harvest thermal energy in heated source solutions, enabling a low electrical energy consumption (11.3–16.0 Wh mol-1 lithium). …”
    Get full text
    Get full text
    Get full text
  16. 516

    Trends in prescribing and outcomes in obese versus non-obese patients receiving rivaroxaban therapy: an observational study using real-world data by Alalawneh, Majdoleen

    Published 2023
    “…Within BMI categories, a similar increasing trend was observed in underweight, normal, and overweight patients, while from 2018 to 2020, there was a decreasing trend in rivaroxaban prescribing in all obese classes. …”
    Get full text
    Get full text
  17. 517
  18. 518

    Experimental Investigation of Foam drilling fluid using Visualization Technique by Barooah, Abinash

    Published 2021
    “…The experiments were conducted in a 6.16 m long horizontal pipe with 2.5 in. inner diameter and 4.5 in. outer diameter and annular diameter ratio of 1.8. …”
    Get full text
    Get full text
  19. 519

    Application of titanium nanoparticles containing natural compounds in cutaneous wound healing by Ahmeda, Ahmad

    Published 2020
    “…But, MIC and minimal bactericidal concentration of TiNPs@FV against all bacteria were at 2-8 mg/mL and 2-16 mg/mL ranges, respectively. In the part of cutaneous wound healing, use of TiNPs@FV ointment significantly (p ≤ 0.01) raised the wound contracture, vessel, hydroxyl proline, hexuronic acid, hexosamine, fibrocyte, and fibrocytes/fibroblast rate and significantly (p ≤ 0.01) decreased the wound area, total cells, neutrophil, and lymphocyte compared to other groups in rats. …”
    Get full text
    Get full text
    Get full text
  20. 520