Showing 1,041 - 1,060 results of 1,762 for search '(( 10 ((peer decrease) OR (((mean decrease) OR (a decrease)))) ) OR ( a step decrease ))', query time: 0.16s Refine Results
  1. 1041
  2. 1042
  3. 1043

    Effect Of Sand Blasting On Soda Lime Glass Properties by Bousbaa, C.

    Published 2003
    “…The average strength remains almost constant while the dispersion becomes much reduced for the glass sand blasted during 60 minutes (m = 10.4 and smoy = 64 MPa). The variation of the relative efficiency of glass protected solar panels versus sand blasting duration (seen up to 300 min) shows a slow regular decrease until 0.91 for a 90° impact angle and until 0.95 for 30°. …”
    Get full text
  4. 1044
  5. 1045

    Correlation between delta-endotoxin and proteolytic activities produced by Bacillus thuringiensis var. kurstaki growing in an economic production medium by Ennouri, Karim

    Published 2013
    “…Maximal protease activity (540-2468 UI) obtained by BUPM5-1 and BUPM5-2 was 2.34-fold and 10.7-fold, respectively, more than that obtained by the wild strain BUPM5 with a drastic decrease of their delta-endotoxin production. …”
    Get full text
    Get full text
  6. 1046
  7. 1047
  8. 1048

    Simulation and Optimization of an LNG Plant Cold Section by Katebah, Mary Anna

    Published 2018
    “…Using the short cut method, optimization revealed that optimized MR composition resulted in almost 10% MR compression power and 6% plant operating cost savings, whereas new intermediate propane evaporation pressures, identified using detailed simulation, and flowrates decreased the propane compression power and operating costs by around 3.6%, and 2%, respectively. …”
    Get full text
    Get full text
  9. 1049

    Analysis of dopant diffusion in molten germanium induced by pulsed nd : yag laser by Mousa, Ali M. [علي مطشر موسى]

    Published 1995
    “…A monotonic decrease in the sheet rcsostance with increasing energy density for all values of E > 10 J/cm2. …”
    Get full text
  10. 1050
  11. 1051
  12. 1052
  13. 1053
  14. 1054
  15. 1055
  16. 1056

    High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling by Cabibbo, Marcello

    Published 2014
    “…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
    Get full text
    Get full text
  17. 1057

    Control of the antagonistic effects of heat-assisted chlorine oxidative degradation on pressure retarded osmosis thin film composite membrane surface by Ralph Rolly, Gonzales

    Published 2021
    “…The chlorine oxidative degradation is optimized in terms of chlorine exposure (a factor of both exposure time and chemical dosage), solution pH, and the subsequent heating time. …”
    Get full text
    Get full text
    Get full text
  18. 1058
  19. 1059

    Foamed phase change materials based on recycled polyethylene/paraffin wax blends by Sobolčiak, Patrik

    Published 2021
    “…Differential Scanning Calorimetry was used to determine the specific enthalpies of melting (22.4–25.1 J/g) what is the latent heat of materials utilized during a heat absorption. A stability of samples during 10 heating/cooling cycles was demonstrated. …”
    Get full text
    Get full text
  20. 1060