Showing 641 - 660 results of 1,761 for search '(( 10 ((steel decrease) OR (((nn decrease) OR (a decrease)))) ) OR ( 10 μg decrease ))*', query time: 0.20s Refine Results
  1. 641

    Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

    Published 2015
    “…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
    Get full text
  2. 642

    Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings by Ubaid F.

    Published 2019
    “…Towards this direction, TiO2 nanotubes with an average size of ⁓10–15 nm (as confirmed by scanning electron microscope (SEM) and transmission electron microscope (TEM) analysis) were synthesized through a hydrothermal process and were then impregnated with DOC. …”
    Get full text
    Get full text
  3. 643

    Experimental and numerical investigation of the flexural behavior of one-way RC slabs strengthened with near-surface mounted and externally bonded systems by Aljidda, Omar

    Published 2024
    “…In contrast, the slabs reinforced with EB experienced a decrease in ductility ranging from 38 % to 50 %. …”
    Get full text
    Get full text
  4. 644

    Bromate reduction by ultraviolet light irradiation using medium pressure lamp by Bensalah, Nasr

    Published 2013
    “…The kobs increased linearly with increasing light intensity. A UV dose of 1000 mJ/cm2 was sufficient to reduce the bromate concentration to less than 10 μg/L within 10 min. …”
    Get full text
    Get full text
    Get full text
  5. 645
  6. 646
  7. 647
  8. 648
  9. 649
  10. 650

    Fatigue and Monotonic Behaviors of Corrosion-Damaged Reinforced Concrete Beams Strengthened with FRCM Composites by Elghazy M.

    Published 2018
    “…Test results showed that the corrosion of steel bars dramatically decreased the fatigue life of the beams. …”
    Get full text
    Get full text
  11. 651

    Experimental results and modelling of corrosion-damaged concrete beams strengthened with externally-bonded composites by Elghazy M.

    Published 2018
    “…The investigated parameters included the corrosion levels (10 and 20% mass loss of steel reinforcement), the type of composite (fabric-reinforced cementitious matrix (FRCM) and fiber-reinforced polymers (FRP)), and the number of composite layers (one, two, and four). …”
    Get full text
    Get full text
  12. 652

    Structural performance and moment redistribution of basalt FRC continuous beams reinforced with basalt FRP bars by Abushanab, Abdelrahman

    Published 2021
    “…Seven beams were longitudinally reinforced with BFRP bars, while the remaining three beams were reinforced with conventional steel bars and served as a control. Test results showed that BFRC-RC beams had higher crack widths, mid-span deflections, and strains than steel-RC beams. …”
    Get full text
    Get full text
  13. 653
  14. 654
  15. 655

    Mobile Epifauna Associated To Artificial Substrates In Offshore Qatari Waters by Abdulaziz Aziz, Naeem

    Published 2019
    “…Thirty plates were deployed, at depths between 10 and 44 m, in each of six offshore sites, along a transect defined between natural and artificial reefs (i.e., oil platforms). …”
    Get full text
  16. 656
  17. 657
  18. 658

    Nanocomposite Ni-TiO2 coatings produced by pulsed electroplating by Wang, Y.

    Published 2014
    “…Nanocomposite Ni-TiO2 coatings were prepared on mild steel substrate by pulse electroplating with controlled duty cycle and frequency. …”
    Get full text
    Get full text
  19. 659
  20. 660