Showing 161 - 180 results of 1,314 for search '(( 10 i decrease ) OR ( 5 ((((nn decrease) OR (greater decrease))) OR (mean decrease)) ))', query time: 0.22s Refine Results
  1. 161

    On the application of arabian gulf water in irrigation: A future possibility by Abu Sharar, Taleb [طالب ابو شرار]

    Published 1987
    “…Magnesium is the predominant bivalent cation and its concentration is 5.2 times greater than that of calcium. Therefore, restriction on soil water management should be considered when applying sea water for irrigation. …”
    Get full text
  2. 162
  3. 163

    Forecast of the outbreak of COVID-19 using artificial neural network: Case study Qatar, Spain, and Italy by Shawaqfah M.

    Published 2021
    “…The model sensitivity was analyzed using the root mean square error (RMSE), the mean absolute percentage error and the regression coefficient index R2, which yielded highly accurate values of the predicted correlation for the infected and dead cases of 0.99 for the dates considered. …”
    Get full text
    Get full text
  4. 164

    Effect Of Sand Blasting On Soda Lime Glass Properties by Bousbaa, C.

    Published 2003
    “…The as received glass Weibull plot shows a large dispersion expressed by a low Weibull modulus (m = 5.41) and a relatively higher average strength value (smoy = 76 MPa). …”
    Get full text
  5. 165

    Trends and Appropriateness of Sodium-glucose Co-transporter 2 Inhibitors Use in Qatar by Zaghloul, Nancy

    Published 2023
    “…Conclusion: SGLT2is have largely replaced sulfonylureas in clinical practice in Qatar, with a greater utilization for empagliflozin over dapagliflozin. …”
    Get full text
  6. 166

    Studies on growth and chemical composition of tobacco varieties. IV - comparative effects of various combinations of fertilizers on economic potentialities of tobacco plants by Younis, M. E. [محمود الباز يونس]

    Published 1987
    “…With higher fertilizer levels used in experiment II, progressively greater reduction in stem length and number of leaves were apparent. …”
    Get full text
  7. 167

    Use and assessment of “e-plastics” as recycled aggregates in cement mortar by Makri, Chrysanthi

    Published 2019
    “…The obtained results, for all RPs, (especially those of 7.5% and 10%) exhibited an increase in the CS of the specimens by 15.4% and 7.8%, respectively, with the MoE decreased in both cases by 18.1% and 23.8%, respectively. …”
    Get full text
    Get full text
  8. 168
  9. 169
  10. 170

    Conversion of Organic Municipal Wastes into Biochars and their Effect on Fertility Parameters of Normal and Sabkha Soils of Qatar by Ahmedna, Mohamed

    Published 2016
    “…To each pot, sufficient amount of 0.25-mm sieved biochar was mixed with soil to yield carbon to soil ratios of 0, 1, and 2% (wt/wt). Box-Behnken experimental design was used instead of the full factorial to decrease the number of treatments to a manageable level (126 treatments) with three replications at the center. …”
    Get full text
    Get full text
  11. 171

    The Impact of Multiple Autoclave Cycles on the Surface Roughness of Thermally Treated Nickel-Titanium Endodontic Files by Ba-Hattab, Raidan

    Published 2022
    “…An unsterilized group was assigned as the pre-autoclaving group (Cycle 0), and the other three groups underwent various autoclave sterilization cycles (Cycles 1, 5, and 10). The roughness average (Ra), root mean square (Rq), and average maximum peak-to-valley height (Rz) values were evaluated using SEM and ImageJ software. …”
    Get full text
    Get full text
    Get full text
  12. 172
  13. 173
  14. 174

    Experimental analysis of additively manufactured thin-walled heat-treated circular tubes with slits using AlSi10Mg alloy by quasi-static axial crushing test by Mohamed A.S.

    Published 2019
    “…The bulk of the tested tubes exhibited a crushing force efficiency greater than 0.8. Overall, the presence of slits with length 15 mm and width 5 mm resulted in lower and smoother crushing forces than the straight tubes and, therefore, greater crushing force efficiency, validating them as crashworthy structures.…”
    Get full text
    Get full text
  15. 175

    Low electro-synthesis potentials improve permselectivity of polymerized natural phenols in biosensor applications by Monti, Patrizia

    Published 2017
    “…Polymers were obtained by means of constant potential amperometry, instead of cyclic voltammetry, in order to achieve multiple polymerizations, hence decreasing the time of realization and variability. …”
    Get full text
    Get full text
    Get full text
  16. 176

    Experimental study on effective placement of PCM packets in cooling vest to improve performance in warm environment by Itani, Mariam

    Published 2017
    “…It was found that the core temperature changed slightly when wearing the vest, however the local skin temperature of the back and front torso segments decreased by about 5 °C and 3 °C at the end of the exercise, respectively. …”
    Get full text
    Get full text
  17. 177
  18. 178

    Isothermal crystallization kinetics and morphology of double crystalline PCL/PBS blends mixed with a polycarbonate/MWCNTs masterbatch by Gumede T.P.

    Published 2019
    “…The nanocomposites contained 1.0 and 4.0 wt% MWCNTs. The blends showed a sea-island morphology typical of immiscible blends. …”
    Get full text
    Get full text
  19. 179

    Topiramate monotherapy for weight reduction in patients with type 2 diabetes mellitus: A systematic review and meta-analysis by Paravattil, Bridget

    Published 2016
    “…Results: Of the 284 studies identified, 5 studies fulfilled the inclusion criteria. Topiramate decreased weight by a mean difference of 3.4 kg (95% CI, -3.79 to -3.04) compared to placebo. …”
    Get full text
    Get full text
  20. 180

    Application of Fe3O4 magnetite nanoparticles grafted in silica (SiO2) for oil recovery from oil in water emulsions by Elmobarak W.F.

    Published 2021
    “…Demulsification process best fits the combined Langmuir-Freundlich (L-F) isotherm with highest adsorption capacity (Qmax) of 186.0 ± 5 mgoil/gMD compared to 86.0 ± 5 mgoil/gMD for Fe3O4, which is 1.1 folds greater than Qmax reported in the literature for other demulsifiers.…”
    Get full text
    Get full text