Showing 641 - 660 results of 1,763 for search '(( 10 min decrease ) OR ( 10 ((per decrease) OR (((a decrease) OR (mean decrease)))) ))*', query time: 0.15s Refine Results
  1. 641
  2. 642
  3. 643

    Novel fluorinated surfactants for enhanced oil recovery in carbonate reservoirs by Al-Amodi, Adel O.

    Published 2016
    “…However, betaine‐based co‐surfactant reduced the IFT to 10−3 mN/m. An adsorption isotherm showed that the maximum adsorption of surfactant‐A was 1 mg per g of rock. …”
    Get full text
    Get full text
  4. 644
  5. 645
  6. 646
  7. 647

    Absorption of CO2 in aqueous blend of methyldiethanolamine and arginine by Talkhan, Ahmed Gomaa

    Published 2020
    “…The study was carried out at different mixing ratios of MDEA and Arg at a total concentration of 2 moles per litre. The CO2 partial pressure varied from about 10 to 100 kPa, and the temperature varied from 293 K to 323 K. …”
    Get full text
    Get full text
  8. 648
  9. 649
  10. 650
  11. 651
  12. 652
  13. 653
  14. 654
  15. 655

    Control of the antagonistic effects of heat-assisted chlorine oxidative degradation on pressure retarded osmosis thin film composite membrane surface by Ralph Rolly, Gonzales

    Published 2021
    “…After performing chlorine oxidation at the following optimized conditions: 3025 ppm Cl2·h, pH 10.72, and 3 min heating time, initial non-pressure retarded water flux of 73.2 L m−2 h−1, specific reverse solute flux of 1.17 g L−1, and power density of 18.71 W m−2 (corresponding to water flux of 56.1 L m-2 h-1) at 12 bar were obtained using 0.6 M NaCl as draw and deionized water as feed.…”
    Get full text
    Get full text
    Get full text
  16. 656
  17. 657

    Analysis of dopant diffusion in molten germanium induced by pulsed nd : yag laser by Mousa, Ali M. [علي مطشر موسى]

    Published 1995
    “…A monotonic decrease in the sheet rcsostance with increasing energy density for all values of E > 10 J/cm2. …”
    Get full text
  18. 658
  19. 659
  20. 660

    Synthesizing New Anodes From Qatalum's 1st Cut Spl by Hani Holozadah, Abdullah

    Published 2014
    “…This might result in extending the life time of the carbon anodes and decrease the number of carbon dioxide kilograms that are released per a ton of produced Al metal. …”
    Get full text
    Get full text