Development of CuAg/Cu2O nanoparticles on carbon nitride surface for methanol oxidation and selective conversion of carbon dioxide into formate by Nazir, Roshan

“…In a two-step process, the Cu NPs are synthesized first on CN surface by adsorbing Cu2+ precursors and reducing them by NaBH4. …”
Get full text
Get full text

Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

“…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
Get full text

Fabrication and characterization of flexible ruthenium oxide-loaded polyaniline/poly(vinyl alcohol) nanofibers by Chamakh, M.

“…The tests revealed the decrease of electrical resistivity and activation energy with increasing RuO2 concentration for the as-prepared samples, while the annealed samples showed lower activation energy values of ~0.1 eV with increasing the concentration of RuO2. …”
Get full text
Get full text
Get full text

High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling by Cabibbo, Marcello

“…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
Get full text
Get full text

Structural analysis of missense mutations in galactokinase 1 (GALK1) leading to galactosemia type-2. by P, Sneha

“…Molecular docking analysis revealed a decrease in interaction between the protein and ATP in all the 3 mutations, and molecular dynamic simulations of 50 ns showed a loss of stability and compactness in the mutant proteins. …”
Get full text
Get full text

Pd nanocrystals encapsulated in MOF-derived Ni/N-doped hollow carbon nanosheets for efficient thermal CO oxidation: unveiling the effect of porosity by Ipadeola, Adewale K.

“…The obtained Pd/Ni-MOF-HNC possesses hollow carbon sheets with a great surface area (153.05 m2 g−1), pore volume (0.12 cm3 g−1), rich Pd/Ni-Nx active sites, Ni-metal defects, rich N-content (7.53 at%), mixed Pd/Ni-oxide phases, and uniformly distributed ultra-small Pd nanocrystals (7.03 ± 1.10 nm); meanwhile, Pd/Ni-MOF-NC formed without etching had no porosity and less Ni-metal defects. …”
Get full text
Get full text
Get full text

Functionalization of silica-coated magnetic nanoparticles as powerful demulsifier to recover oil from oil-in-water emulsion by Elmobarak W.F.

“…The %Soil slightly decreased to ∼92% with an alkaline pH or when the thickness of the silica layer increased to ≥10 nm. …”
Get full text
Get full text

Association between Insulin and Nitric Oxide in Human Retinal Microvascular Endothelial Cells in vitro by Rizk, Nasser Moustafa

“…In the current study in order to examine the effect of insulin on NO production, HRECs cells were cultured and grown in high glucose (30 mM) and normal (5 mM) glucose for 24 hours. Subsequently, the cells were treated with 100 nM insulin for 10 minutes, 1, 2, and 4 hours. …”
Get full text
Get full text

Experimental investigation on the compressibility of Al/Al2O3 nanocomposites by Wagih, Ahmed

“…The results showed that the grain size of milled powders was about 43 nm with a noticeable presence of agglomerates at 10 wt.% of Al2O3. …”
Get full text
Get full text

دراسة تأثير تركيز تيترا أيزوبروبكسيد التيتانيوم (TTIP) على بعض مواصفات ألياف ثنائي أكسيد التيتانيوم النانوية المغزولة كهربائياً... by طهماز, غزل

Get full text

Cold Plasma as Effective Tool for Aluminum Surface Cleaning by Popelka, Anton

“…A continuous amorphous oxide layer is formed immediately after rolling process due to the reaction of oxygen and air humidity and therefore new metal surface is produced [5]. …”
Get full text
Get full text

Fabrication of Selective Sensors for Hg2+ Traces in Water Using Graphene Decorated with Metal Nanoclusters by Ayesh, Ahmad I.

“…Two batches of sensors were tested in this work: i) sensors based on graphene only, and ii) sensors based on graphene and percolating films of Au nanoclusters, each has a thickness of 5 nm. For nanocluster deposition, each graphene sample was fixed on a cryostat finger. …”
Get full text
Get full text

Combustion-Free Synthesis of Lithium Manganese Oxide Composites with CNTs/GNPs by Chemical Coprecipitation for Energy Storage Devices by Tariq, Hanan Abdurehman

Get full text
Get full text

Novel paclitaxel formulations solubilized by parenteral nutrition nanoemulsions for application against glioma cell lines by Najlah, Mohammad

“…The pH range for the Clinoleic formulations (7.1–7.5) was slightly higher than that of the Intralipid formulations (6.5–6.9). …”
Get full text
Get full text
Get full text

Silymarin-albumin nanoplex: Preparation and its potential application as an antioxidant in nervous system in vitro and in vivo by Sohrabi M.J.

“…The formulation of silymarin-HSA nanoplex showed a spherical shape with an average diameter between 50 nm and 150 nm, hydrodynamic radius of 188.3 nm, zeta potential of −26.6 mV, and a drug loading of 97.3%. …”
Get full text
Get full text

Investigating the effect of polymer-modified graphene oxide coating on RO membrane fouling by Ashfaq, Mohammad Y.

“…The membrane surface characterization showed a decrease in membrane surface roughness from 74.7 nm to 69.0 nm and an increase in membrane hydrophilicity as the contact angle decreased from 41.7 ± 4.50 to 22.0 ± 1.10. …”
Get full text
Get full text

Novel paclitaxel formulations solubilized by parenteral nutrition nanoemulsions for application against glioma cell lines by Najlah, Mohammad

“…The pH range for the Clinoleic formulations (7.1–7.5) was slightly higher than that of the Intralipid formulations (6.5–6.9). …”
Get full text
Get full text
Get full text

The Separation of Emulsified Water/Oil Mixtures through Adsorption on Plasma-Treated Polyethylene Powder by Abdulkareem, Asma

“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text

The mechanical and adhesive properties of electrically and thermally conductive polymeric composites based on high density polyethylene filled with nickel powder by Krupa, Igor

“…The stress at break of the composites behaved nonlinearly; the low filler content suppressed necking, resulting in a decrease in stress at break, whereas higher filler content (higher than 10vol.%) led to reinforcement of the composites and therefore increased the stress at break.The presence of nickel particles throughout the HDPE matrix increased the hydrophilicity of the composites. …”
Get full text
Get full text
Get full text

Possible evidence for the existence of a hairy layer at the surface of polymer latex particles by Said, Ziad F. M.

“…At low levels of electrolyte (NaCl in the range 0.00- 0.10M), the hydrodynamic radius (dH) was found to decrease gradually, reaching a minimum value at 0.10M, about 7-9nm smaller than the original value in the absence of electrolyte. …”
Get full text
Get full text