Corrosion behavior of API X100 steel material in a hydrogen sulfide environment by Okonkwo, Paul C.

“…The results indicate that the corrosion rate of API X100 steel decreases with increasing H2S bubbling time due to the increase in H2S concentration in 3.5% NaCl solutions. …”
Get full text
Get full text

Oral PTCTS (Particulated Transialidase) Removes Serum Microparticles and Decreases Inflammation in Atherosclerotic Plaques of Rabbits by Garavelo, Sherrira M.

Get full text
Get full text

SARS-CoV-2 infection triggers more potent antibody-dependent cellular cytotoxicity (ADCC) responses than mRNA-, vector-, and inactivated virus-based COVID-19 vaccines by Zedan, Hadeel T.

“…Notably, omicron infection showed reduced overall ADCC activity compared to WT SARS-CoV-2 infection. Although post-mRNA vaccination BTI elicited high levels of binding and NAbs, ADCC activity was significantly reduced. …”
Get full text
Get full text
Get full text

Tailoring the defects of sub-100 nm multipodal titanium nitride/oxynitride nanotubes for efficient water splitting performance by Eid, Kamel

“…The water-splitting performance of sub-100 nm TiON6NT multipodal nanotubes was superior to the long compacted TiONxNTs with different lengths and TiO2 nanoparticles. …”
Get full text
Get full text
Get full text

Effect of temperature and erosion on pitting corrosion of X100 steel in aqueous silica slurries containing bicarbonate and chloride content by Mahdi, E.

“…During zero and low erosion rates, the OCP decreases with increase of temperature. In contrast, during high erosion rate, the OCP first decrease and then increases. …”
Get full text
Get full text

Investigation of the Effect of Imatinib and Hydroxyurea Combination Therapy on Hematological Parameters and Gene Expression in Chronic Myeloid Leukemia (CML) Patients by Al-Amleh, Esraa K.

“…Platelet counts, on the other hand, dramatically decreased in both IM and (HU + IM). (4) Conclusion: Because the studied genes (BCL2, PP2A, CIP2A, and WT1) are participating in cell proliferation and death, the findings show that the examined genes are significant to understand the efficacy of various therapies. …”
Get full text
Get full text

Electronic vs Ionic limitations to electrochemical performance in Li4Ti5O12-based organic suspensions for lithium-redox flow batteries by Madec, L.

“…Above a critical thickness in the 0.5-1 mm range, depending on the LTO content, the rate performance are significantly decreased. …”
Get full text
Get full text
Get full text

A study on stability of active layer of polymer solar cells: effect of UV–visible light with different conditions by Mehmood U.

Get full text
Get full text
Get full text

Evaluation of antibody response in symptomatic and asymptomatic covid-19 patients and diagnostic assessment of new IgM/IgG elisa kits by Al-Jighefee, Hadeel T.

Get full text
Get full text
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Mechanical Performance and Thermo-Physical Properties of Cement Mortar Incorporating Hybrid Slags by Baawain, Mahad

“…Ferrochrome (FeCr) slag aggregate was used as a replacement for sand at the ratios of 25, 50, 75 and 100 wt. %. Ground granulated blast furnace slag (GGBS) has been used as a partial replacement of cement at the ratio of 25 wt. %. …”
Get full text
Get full text

ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY by MESLAM, MENTALLAH MOHAMED HASSANIN MOHAMED HASSANIN

“…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …”
Get full text

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study by Hamza A.

“…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”
Get full text
Get full text
Get full text

Microstructure, wear and corrosion characteristics of Cu matrix reinforced SiC–graphite hybrid composites by Jamwal A.

“…Copper matrix composites with SiC-graphite reinforcement (0, 2.5,5, 7.5 and 10 wt.%) were prepared by stir casting process. …”
Get full text
Get full text

Thermally conductive polyethylene/expanded graphite composites as heat transfer surface: Mechanical, thermo-physical and surface behavior by Sobolčiak, Patrik

“…Composites of high-density polyethylene (HDPE) and expanded graphite (EG) are prepared for heat exchangers in multi-effect distillation (MED) desalination. At 50 wt.% EG loading, the thermal conductivity of HDPE was increased by 372%. …”
Get full text
Get full text

Development of value-added polyethylene grades with extended service lifetime: Weathering resistant flame retarded materials for outdoor applications by Porfyris, A. D.

“…Subsequently, the compounds were subjected to separate artificial UV and heat aging at 100 C for 1500 h; the formulations showed good flame retardance, even after prolonged artificial weathering, but there was an observable, although acceptable, decrease in the mechanical properties. …”
Get full text
Get full text

Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites by Ahamad, Naseem

“…Al-Al2O3-SiC hybrid composite has been developed through stir casting with addition of ceramics i.e. Al2O3-SiC (2.5 wt.%, 5.0 wt.%, 7.5 wt.% and 10.0 wt.%) in relative and symmetrical proportion. …”
Get full text
Get full text

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles by Chamakh, Mariem

“…The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 �C for 4 h to form the ruthenium oxide nanoparticles. …”
Get full text
Get full text

Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites by Mittal, P.

“…Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. …”
Get full text
Get full text

Modification of Pd/CeO2 catalyst by Atomic Layer Deposition of ZrO2 by Onn, Tzia Ming

“…Methane-oxidation rates in 0.5% CH4 and 5% O2 were slightly lower on the ZrO2-covered catalyst when both materials were calcined at 673 K but the activity of the ZrO2-modified catalyst did not decrease with catalyst calcination temperature. …”
Get full text
Get full text