Showing 481 - 500 results of 976 for search '(( 12 c decrease ) OR ( 5 ((((we decrease) OR (greater decrease))) OR (a decrease)) ))', query time: 0.32s Refine Results
  1. 481
  2. 482

    Application of Fe3O4 magnetite nanoparticles grafted in silica (SiO2) for oil recovery from oil in water emulsions by Elmobarak W.F.

    Published 2021
    “…Using an MDdose as low as 10 mg/L attained a %ηdem in the range of 93%–94.3% for O/W mixtures with Coil < 2000 mg/L, which slightly decreased to ∼90% for higher concentrations. …”
    Get full text
    Get full text
  3. 483

    Combined influence of temperature and flow rate of feeds on the performance of forward osmosis by Hawari, Alaa H.

    Published 2016
    “…The experimental results also showed that the membrane flux increased by 93.3% due to temperature increase from 20 to 26 °C and the flow rate from 1.2 to 3.2 L/min using a 0.5 M NaCl solution as the draw solution and distilled water as the feed solution (FS).…”
    Get full text
    Get full text
  4. 484
  5. 485

    Advantageous Effects of Sumac Usage in Meatball Preparation on Various Quality Criteria and Formation of Heterocyclic Aromatic Amines by Savaş, Adem

    Published 2023
    “…The sumac usage caused a reduction in pH (p < 0.01), cooking loss (p < 0.05), lipid oxidation level (TBARS, p < 0.01), and total HAA amount (p < 0.05) of the samples. …”
    Get full text
    Get full text
    Get full text
  6. 486

    The effects of knee joint kinematics on anterior cruciate ligament injury and articular cartilage damage by Orsi, Alexander D.

    Published 2016
    “…Femoral external rotation decreased the frontal plane angle required for ACL failure by 27.5% compared to internal rotation. …”
    Get full text
    Get full text
  7. 487

    Inter-annual variability and distribution of aerosols during winters and aerosol optical thickness over Northeastern Pakistan by Shahid, M. Z.

    Published 2020
    “…ir pollution during winters over north-eastern (NE) Pakistan (71–74.5 E, 28–34 N) is a major challenge that affects human health, climate and daily life. …”
    Get full text
    Get full text
  8. 488

    Physico-mechanical Properties of Sustainable Building Material Based Gypsum and Recycled Polyethylene Waste by Amina, Djoudi

    Published 2023
    “…Results proved the positive effect of the introducing of PET particles in the matrix of gypsum mortar, the lightening of this material but a decrease of mechanical properties was recorded comparing in to reference without polyethylene particles. …”
    Get full text
    Get full text
  9. 489

    Thermoelectric properties of SbNCa3 and BiNCa3 for thermoelectric devices and alternative energy applications by Bilal, M.

    Published 2014
    “…The maximum values of thermal conductivity are 92×1014 W/m K s and 88×1014 W/m K s for SbNCa3 and BiNCa3 respectively at a temperature of 900 K. The peak values of 5×1020/Ω m s and 5.2×1020/Ω m s are achieved for n-type SbNCa3 and BiNCa3 respectively at a temperature of 300 K. …”
    Get full text
    Get full text
  10. 490

    Synthesis and electrochemical properties of nickel oxide/carbon nanofiber composites by Al-Enizi, Abdullah M.

    Published 2014
    “…The specific capacitance (SC) was found to be highest (738 F g−1) at a calcination temperature of 400 °C. The charge transfer resistance (Rp) decreased as the calcination temperature was increased. …”
    Get full text
    Get full text
  11. 491

    Enhancing the production of biogas through anaerobic co-digestion of agricultural waste and chemical pre-treatments by Almomani F.

    Published 2020
    “…The results revealed that the highest cumulative methane production (CMP) of 297.99 NL/kgVS can be generated by co-digestion of ASWs and CD at a ratio of 60:40. Further improvement was achieved via alkalinity treatment with 1.0 g of NaHCO3/gVS leading to decrease in lignin, cellulose, and hemicellulose contents of feedstock by 3.5%, 10.5% and 15.9%, respectively, converting them to soluble fractions and improving the CMP by 11.2–29.7% based on substrate quality. …”
    Get full text
    Get full text
  12. 492

    Fabrication of Selective Sensors for Hg2+ Traces in Water Using Graphene Decorated with Metal Nanoclusters by Ayesh, Ahmad I.

    Published 2016
    “…Two batches of sensors were tested in this work: i) sensors based on graphene only, and ii) sensors based on graphene and percolating films of Au nanoclusters, each has a thickness of 5 nm. For nanocluster deposition, each graphene sample was fixed on a cryostat finger. …”
    Get full text
    Get full text
  13. 493

    Dynamic Salmonella Enteritidis biofilms development under different flow conditions and their removal using nanoencapsulated thymol by Yammine, Jina

    Published 2022
    “…ML nanocapsules decreased significantly bacterial counts during the first 0.5 h, while LBL nanocapsules eliminated the remaining bacterial cells and ensured a protection from bacterial contamination for up to 5 h by releasing THY in a sustained manner over time due to the thicker shell wall structure.…”
    Get full text
    Get full text
    Get full text
  14. 494

    Evaluation of different personalized ventilation air terminal devices: Inhalation vs. clothing-mediated exposures by Al Assaad, Douaa

    Published 2021
    “…Increasing the flow to 10 l/s led to reductions of 89% in exposure and 56.5% in deposition. A VDG delivering 5 l/s reduced exposure by 33% while deposition reduction was negligible at 3%. …”
    Get full text
    Get full text
  15. 495

    Mycoremediation of Tunisian tannery wastewater under non-sterile conditions using Trametes versicolor: live and dead biomasses by Boujelben, Raouia

    Published 2022
    “…Laccase activity reached a maximum of 7.975 U/L (pH = 8.25) and 20 U/L (pH = 5.5) after 5 days of treatment. …”
    Get full text
    Get full text
    Get full text
  16. 496

    Long-Term Variability of Aerosol Concentrations and Optical Properties over the Indo-Gangetic Plain in South Asia by Shahid, Imran

    Published 2022
    “…Emissions of atmospheric pollutants are rapidly increasing over South Asia. A greater understanding of seasonal variability in aerosol concentrations over South Asia is a scientific challenge and has consequences due to a lack of monitoring and modelling of air pollutants. …”
    Get full text
    Get full text
  17. 497
  18. 498
  19. 499
  20. 500

    Tribological studies of nanomodified mineral based multi-grade engine oil by Laad, M.

    Published 2017
    “…Wear rate for lubrication oil without nanoadditives was also found to be decreased with increase in sliding speed. Experimental results prove that nanoparticles can be used as a multifunctional additive in lubricating oil to enhance its tribological properties.…”
    Get full text
    Get full text