Showing 461 - 480 results of 974 for search '(( 12 c decrease ) OR ( 5 ((((wt decrease) OR (nn decrease))) OR (a decrease)) ))', query time: 0.26s Refine Results
  1. 461
  2. 462

    Effect of electroless bath composition on the mechanical, chemical, and electrochemical properties of new NiP-C 3 N 4 nanocomposite coatings by Fayyad E.M.

    Published 2019
    “…The corrosion performance of the NiP–C3N4 NCC prepared at the optimum conditions was studied in a 3.5wt% NaCl solution through electrochemical impedance spectroscopy (EIS) and Tafel analysis techniques. …”
    Get full text
    Get full text
  3. 463

    Combined influence of temperature and flow rate of feeds on the performance of forward osmosis by Hawari, Alaa H.

    Published 2016
    “…The experimental results also showed that the membrane flux increased by 93.3% due to temperature increase from 20 to 26 °C and the flow rate from 1.2 to 3.2 L/min using a 0.5 M NaCl solution as the draw solution and distilled water as the feed solution (FS).…”
    Get full text
    Get full text
  4. 464
  5. 465

    Advantageous Effects of Sumac Usage in Meatball Preparation on Various Quality Criteria and Formation of Heterocyclic Aromatic Amines by Savaş, Adem

    Published 2023
    “…The sumac usage caused a reduction in pH (p < 0.01), cooking loss (p < 0.05), lipid oxidation level (TBARS, p < 0.01), and total HAA amount (p < 0.05) of the samples. …”
    Get full text
    Get full text
    Get full text
  6. 466

    Inter-annual variability and distribution of aerosols during winters and aerosol optical thickness over Northeastern Pakistan by Shahid, M. Z.

    Published 2020
    “…ir pollution during winters over north-eastern (NE) Pakistan (71–74.5 E, 28–34 N) is a major challenge that affects human health, climate and daily life. …”
    Get full text
    Get full text
  7. 467

    Physico-mechanical Properties of Sustainable Building Material Based Gypsum and Recycled Polyethylene Waste by Amina, Djoudi

    Published 2023
    “…Results proved the positive effect of the introducing of PET particles in the matrix of gypsum mortar, the lightening of this material but a decrease of mechanical properties was recorded comparing in to reference without polyethylene particles. …”
    Get full text
    Get full text
  8. 468

    Thermoelectric properties of SbNCa3 and BiNCa3 for thermoelectric devices and alternative energy applications by Bilal, M.

    Published 2014
    “…The maximum values of thermal conductivity are 92×1014 W/m K s and 88×1014 W/m K s for SbNCa3 and BiNCa3 respectively at a temperature of 900 K. The peak values of 5×1020/Ω m s and 5.2×1020/Ω m s are achieved for n-type SbNCa3 and BiNCa3 respectively at a temperature of 300 K. …”
    Get full text
    Get full text
  9. 469

    Synthesis and electrochemical properties of nickel oxide/carbon nanofiber composites by Al-Enizi, Abdullah M.

    Published 2014
    “…The specific capacitance (SC) was found to be highest (738 F g−1) at a calcination temperature of 400 °C. The charge transfer resistance (Rp) decreased as the calcination temperature was increased. …”
    Get full text
    Get full text
  10. 470

    Enhancing the production of biogas through anaerobic co-digestion of agricultural waste and chemical pre-treatments by Almomani F.

    Published 2020
    “…The results revealed that the highest cumulative methane production (CMP) of 297.99 NL/kgVS can be generated by co-digestion of ASWs and CD at a ratio of 60:40. Further improvement was achieved via alkalinity treatment with 1.0 g of NaHCO3/gVS leading to decrease in lignin, cellulose, and hemicellulose contents of feedstock by 3.5%, 10.5% and 15.9%, respectively, converting them to soluble fractions and improving the CMP by 11.2–29.7% based on substrate quality. …”
    Get full text
    Get full text
  11. 471

    The effects of gas tungsten arch welding on the corrosion and mechanical properties of AA 6061 T6 by Eltai, Elsadig

    Published 2013
    “…Corrosion of welded and un-welded Aluminum Alloy 6061 T6 was investigated by immersing specimens in 3.5% (wt) NaCl solution. Potentiodynamic and open circuit potential measurements were conducted. …”
    Get full text
    Get full text
  12. 472

    Evaluation of different personalized ventilation air terminal devices: Inhalation vs. clothing-mediated exposures by Al Assaad, Douaa

    Published 2021
    “…Increasing the flow to 10 l/s led to reductions of 89% in exposure and 56.5% in deposition. A VDG delivering 5 l/s reduced exposure by 33% while deposition reduction was negligible at 3%. …”
    Get full text
    Get full text
  13. 473

    Mycoremediation of Tunisian tannery wastewater under non-sterile conditions using Trametes versicolor: live and dead biomasses by Boujelben, Raouia

    Published 2022
    “…Laccase activity reached a maximum of 7.975 U/L (pH = 8.25) and 20 U/L (pH = 5.5) after 5 days of treatment. …”
    Get full text
    Get full text
    Get full text
  14. 474
  15. 475
  16. 476
  17. 477

    Enhancement of mechanical and corrosion resistance properties of electrodeposited NiP-TiC composite coatings by Fayyaz O.

    Published 2021
    “…Vickers microhardness and nanoindentation results demonstrate the increase in the hardness with an increasing amount of TiC particles attaining its terminal value (593HV100) at the concentration of 1.5 g L−1. Further increase in the concentration of TiC particles results in a decrease in hardness, which can be ascribed to their accumulation in the Ni–P matrix. …”
    Get full text
    Get full text
  18. 478
  19. 479

    A systematic review of stability of medicines used in emergency medical service settings by Rachid, Ousama

    Published 2020
    “…Background: Temperature, among several environment conditions like humidity, is known to impact medicine stability 1,2 . In emergency medical service (EMS) settings, it is often challenging to control these conditions. …”
    Get full text
    Get full text
  20. 480

    Differentiation of human olfactory bulb-derived neural stem cells toward oligodendrocyte. by Marei, Hany E

    Published 2018
    “…The differentiation medium, containing cAMP, PDGFA, T3, and all-trans-retinoic acid (ATRA), promotes OBNSCs to generate mostly oligodendrocytes (OLs) displaying morphological changes, and appearance of long cytoplasmic processes. OBNSCs showed, after 5 days in OLs differentiation medium, a considerable decrease in the number of nestin positive cells, which was associated with a concomitant increase of NG2 immunoreactive cells and few O4(+)-OPCs. …”
    Get full text
    Get full text