Showing 741 - 760 results of 1,777 for search '(( 20 10 decrease ) OR ( 10 ((steer decrease) OR (((mean decrease) OR (a decrease)))) ))*', query time: 0.16s Refine Results
  1. 741
  2. 742
  3. 743
  4. 744

    Yerba Maté (Illex Paraguariensis) ingestion augments fat oxidation and energy expenditure during exercise at various submaximal intensities by Alkhatib, Ahmad

    Published 2014
    “…These changes were combined with a trend towards a decrease in BLC (P = 0.066), and without a significant difference inV˙O2peak, peak power, peak RER, or peak BLC. …”
    Get full text
    Get full text
  5. 745

    Analysis of dopant diffusion in molten germanium induced by pulsed nd : yag laser by Mousa, Ali M. [علي مطشر موسى]

    Published 1995
    “…A monotonic decrease in the sheet rcsostance with increasing energy density for all values of E > 10 J/cm2. …”
    Get full text
  6. 746
  7. 747
  8. 748
  9. 749

    Effect Of Sand Blasting On Soda Lime Glass Properties by Bousbaa, C.

    Published 2003
    “…The average strength remains almost constant while the dispersion becomes much reduced for the glass sand blasted during 60 minutes (m = 10.4 and smoy = 64 MPa). The variation of the relative efficiency of glass protected solar panels versus sand blasting duration (seen up to 300 min) shows a slow regular decrease until 0.91 for a 90° impact angle and until 0.95 for 30°. …”
    Get full text
  10. 750
  11. 751

    High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling by Cabibbo, Marcello

    Published 2014
    “…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
    Get full text
    Get full text
  12. 752
  13. 753
  14. 754
  15. 755
  16. 756
  17. 757
  18. 758

    Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

    Published 2015
    “…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
    Get full text
  19. 759

    CLINICAL AND ECONOMIC IMPACT OF GENETIC AND NON-GENETIC FACTORS ON INR NORMALIZATION IN PRE-OPERATIVE MANAGEMENT OF WARFARIN PATIENTS by ELJILANY, ISLAM AHMED SAYED AHMED

    Published 2021
    “…To optimize the period of preprocedural warfarin interruption to decrease the incidence of bleeding in case of bridging and the incidence of thromboembolism in case of non-bridging, a study was conducted to determine the influence of CYP2C9, VKORC1, CYP4F2, FII, and FVII genetic polymorphisms and non-genetic factors on INR decline in a cohort of Arabs undergoing a procedure that requires warfarin interruption and developing an algorithm to tailor the duration of warfarin interruption before the procedure. …”
    Get full text
  20. 760

    Fabrication of Selective Sensors for Hg2+ Traces in Water Using Graphene Decorated with Metal Nanoclusters by Ayesh, Ahmad I.

    Published 2016
    “…The system consists of three main chambers (source, mass filter, and deposition chambers) that were pumped initially to a base pressure of 10-8 mbar using two turbo pumps. …”
    Get full text
    Get full text