Molecular dynamics of CH4/CO2 on calcite for enhancing gas recovery by Carchini, Giuliano

“…These results highlight how the CO2 geometry of adsorption is well defined and characterized by strong interaction, while methane adsorption is quite loose and depicts a very dynamic picture. Focusing on the effect of pressure, RDF peaks intensities increase, although this effect is limited to the 1-5 MPa range. …”
Get full text
Get full text

Development of Semitransparent UV Photodetector Based on PTB7-Th:PCBM Composite Using the Cost-effective Fabrication Method by Riaz, Muhammad

“…The variation in UV intensity (0 to 20,000 pW/cm2) and frequency (100 Hz, 1 kHz, 10 kHz, 100 kHz, and 200 kHz) was carried out, and variation of impedance and capacitance has been studied. …”
Get full text
Get full text
Get full text

Investigational Study for the efficiency of Fe3O4@SiO2 nanoparticles in the Oil Recovery Process using glass micromodel by Elhaj, Wamda

“…In contrast, the value achieved for the seawater injection was 76.5%. For the oil recovery process, the Fe3O4 was applied for the inhibition (i.e., decrease) of oil sedimentation, and the SiO2 NPs were applied for wettability alteration and IFT reduction. …”
Get full text
Get full text

Brine management strategies, technologies, and recovery using adsorption processes by Al-Absi R.S.

Get full text
Get full text
Get full text

Is there truly an increase in risk of cardiovascular and hematological adverse events with vascular endothelial growth factor receptor tyrosine kinase inhibitors? by Furuya-Kanamori L.

Get full text
Get full text
Get full text

Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

“…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
Get full text

Development of pH-Controlled Aluminum-Based Polymeric Gel for Conformance Control in Sour Gas Reservoirs by Shamlooh M.

“…The results reveal that aluminum acetate, among the screened salts, has a controllable gelation time at pH conditions between 3.5 and 8.5 and is the most stable in the temperature range 25–100 °C. …”
Get full text
Get full text
Get full text

Reinforcement of polyacrylamide-co-tert-butyl acrylate base gel using nanosilica for conformance control at low and high reservoir temperatures by Shamlooh M.

“…Therefore, this study introduces a new polymeric formulation that serves as a water shut-off agent for reservoirs at low and high temperatures. …”
Get full text
Get full text

Overconfident results with the bivariate random effects model for meta-analysis of diagnostic accuracy studies by Furuya-Kanamori, Luis

“…In 2001, Rutter and Gatsonis proposed the hierarchical summary receiver operating characteristic (HSROC) model,1 and in 2004 Macaskill described an empirical Bayes approach.2 Soon after, in 2005, Reitsma et al. proposed the bivariate random effects model,3 which has been widely adopted and is the most commonly used method for diagnostic meta-analysis.4 However, as pointed out by Diaz,5 the statistical performance of the bivariate model has not been scrutinized. …”
Get full text
Get full text
Get full text

Antibacterial Properties of Polysulfone Membranes Blended with Arabic Gum. by Sabri, Souhir

Get full text
Get full text

Yerba Maté (Illex Paraguariensis) ingestion augments fat oxidation and energy expenditure during exercise at various submaximal intensities by Alkhatib, Ahmad

“…These changes were combined with a trend towards a decrease in BLC (P = 0.066), and without a significant difference inV˙O2peak, peak power, peak RER, or peak BLC. …”
Get full text
Get full text

Effect Of Sand Blasting On Soda Lime Glass Properties by Bousbaa, C.

“…The average strength remains almost constant while the dispersion becomes much reduced for the glass sand blasted during 60 minutes (m = 10.4 and smoy = 64 MPa). The variation of the relative efficiency of glass protected solar panels versus sand blasting duration (seen up to 300 min) shows a slow regular decrease until 0.91 for a 90° impact angle and until 0.95 for 30°. …”
Get full text

High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling by Cabibbo, Marcello

“…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
Get full text
Get full text

Co2 Removal Using Imidazolium-Based Ionic Liquid -Aspen Plus Modelling Study by Qureshi, Tooba Ishtiaq

“…Despite the fact that ionic liquids have yet to be used on a wide scale and that the industry is still trailing behind mid-term expectations, their advantages suggest that they might one day become a commercial success. …”
Get full text

Structural analysis of missense mutations in galactokinase 1 (GALK1) leading to galactosemia type-2. by P, Sneha

“…Molecular docking analysis revealed a decrease in interaction between the protein and ATP in all the 3 mutations, and molecular dynamic simulations of 50 ns showed a loss of stability and compactness in the mutant proteins. …”
Get full text
Get full text

Barriers and Motivators of Appropriate Antibiotic Prescription at PHCC in Qatar: Perspective of Physicians and Pharmacists by Sharaf, Nahla

“…Antimicrobial resistance (AMR) is a serious public health problem of global concern. …”
Get full text

Experimental Investigation on the Flexural Capacity of Reinforced Concrete Beams with Treated Wastewater and Recycled Concrete Aggregates by Abushanab, Abdelrahman

“…In addition, the utilization of FA at a 20% replacement ratio enhanced the flexural strength by 5% to 7%.…”
Get full text
Get full text

Barriers and motivators of appropriate antibiotic prescription at PHCC in Qatar: perspective of physicians and pharmacists by Sharaf, Nahla

“…Antimicrobial resistance (AMR) is a serious public health problem of global concern. …”
Get full text
Get full text

Thermal properties of smart microencapsulated paraffin/plaster composites for the thermal regulation of buildings by Karkri M.

Get full text
Get full text
Get full text

Thermal properties of phase-change materials based on high-density polyethylene filled with micro-encapsulated paraffin wax for thermal energy storage by Karkri, M.

“…Microcapsules consisting of paraffin wax cores with a melting point of approximately 42 °C and a melamine-formaldehyde resin shell were synthesized using in situ polymerization. …”
Get full text
Get full text
Get full text