Showing 641 - 660 results of 1,118 for search '(( 20 10 decrease ) OR ( 5 ((point decrease) OR (((nn decrease) OR (a decrease)))) ))', query time: 0.20s Refine Results
  1. 641
  2. 642
  3. 643
  4. 644
  5. 645

    Age-Related Differences of the Athlete`s Heart by Kneffel, Zsuzsanna

    Published 2013
    “…Left ventricle muscle mass (LVMM) is higher in older endurance athletes than in age-matched non-athletes (5) but the difference between athletic and non-athletic subjects decrease continuously or disappears during the ageing. …”
    Get full text
  6. 646

    The mechanical and adhesive properties of electrically and thermally conductive polymeric composites based on high density polyethylene filled with nickel powder by Krupa, Igor

    Published 2013
    “…The stress at break of the composites behaved nonlinearly; the low filler content suppressed necking, resulting in a decrease in stress at break, whereas higher filler content (higher than 10vol.%) led to reinforcement of the composites and therefore increased the stress at break.The presence of nickel particles throughout the HDPE matrix increased the hydrophilicity of the composites. …”
    Get full text
    Get full text
    Get full text
  7. 647

    Possible evidence for the existence of a hairy layer at the surface of polymer latex particles by Said, Ziad F. M.

    Published 1998
    “…At low levels of electrolyte (NaCl in the range 0.00- 0.10M), the hydrodynamic radius (dH) was found to decrease gradually, reaching a minimum value at 0.10M, about 7-9nm smaller than the original value in the absence of electrolyte. …”
    Get full text
    Get full text
  8. 648

    Novel paclitaxel formulations solubilized by parenteral nutrition nanoemulsions for application against glioma cell lines by Najlah, Mohammad

    Published 2016
    “…The pH range for the Clinoleic formulations (7.1–7.5) was slightly higher than that of the Intralipid formulations (6.5–6.9). …”
    Get full text
    Get full text
    Get full text
    article
  9. 649

    In patients with Chronic Heart Failure Which Polypharmacy Pheno-groups are associated with adverse health outcomes? (Polypharmacy Pheno-groups and Heart failure outcomes) by Mohammed Ibn-Mas'ud, Danjuma

    Published 2023
    “…Each patient's medications for the past four months were tallied, and a definitional threshold of ≤4, ≥5, ≥10 medications was established. …”
    Get full text
    Get full text
    Get full text
  10. 650

    Removal of toxic pollutants from produced water by phytoremediation: Applications and mechanistic study by Atia, Fathy A.M.

    Published 2019
    “…Results showed that except M. sativa, tolerated up to 10% diluted PW with a 30% decrease in length and biomass compared to control treatment, all other plants could not survive. …”
    Get full text
    Get full text
    Get full text
  11. 651

    Study of voltage source converter-based HVDC system during DC side faults by Khader, H.

    Published 2013
    “…A 500MW/400kV HVDC system is simulated using Matlab/Simulink. …”
    Get full text
    Get full text
  12. 652
  13. 653

    Combined influence of temperature and flow rate of feeds on the performance of forward osmosis by Hawari, Alaa H.

    Published 2016
    “…The experimental results also showed that the membrane flux increased by 93.3% due to temperature increase from 20 to 26 °C and the flow rate from 1.2 to 3.2 L/min using a 0.5 M NaCl solution as the draw solution and distilled water as the feed solution (FS).…”
    Get full text
    Get full text
  14. 654

    Synthesis of Metallocene Catalyzed Ethylene 1,7-Octadiene Copolymer: Effect of Copolymerization on Polymer Properties by Rahaman M.

    Published 2018
    “…The tensile stress-strain plots show multiple necks. A reduction in tensile modulus, strength, and strain at break is seen for copolymers compared to homopolymer. …”
    Get full text
    Get full text
  15. 655
  16. 656

    Hydrogen Production via Ethanol Decomposition over Bimetallic Catalyst by Ashok, Anchu

    Published 2016
    “…Once it reaches the ignition temperature, the combustion reaction started locally at one point and then spread inside the beaker. The resulted powder was grinded using a mortar and pestle to get a uniform powder to be used for catalytic investigations. …”
    Get full text
    Get full text
  17. 657

    Performance assessment of inductive power transfer for railway applications by Almuhannadi, D.

    Published 2015
    “…The practical implementation has been conducted at a rated voltage of 100V DC at 50kHz and input power of 80W. …”
    Get full text
    Get full text
  18. 658

    Electrically conductive hybrid organic crystals as flexible optical waveguides by Li, Liang

    Published 2022
    “…The elements respond rapidly to temperature by curling or uncurling in about 0.2 s, which in one typical case corresponds to exceedingly fast deformation and recovery rates of 2187.5° and 1458.3° , respectively. In cyclic operation mode, their conductivity decreases less than 1% after 10,000 thermal cycles. …”
    Get full text
  19. 659

    Experimental and numerical investigation of the flexural behavior of one-way RC slabs strengthened with near-surface mounted and externally bonded systems by Aljidda, Omar

    Published 2024
    “…The experimental-to-numerical ratios of the ultimate load ranged between 1.0 and 1.08 for the NSM-strengthened slabs and between 0.98 and 1.38 for the EB-strengthened slabs. …”
    Get full text
    Get full text
  20. 660

    Removal of toxic pollutants from produced water by phytoremediation: Applications and mechanistic study by Fathy A.M., Atia

    Published 2019
    “…Results showed that except M. sativa, tolerated up to 10% diluted PW with a 30% decrease in length and biomass compared to control treatment, all other plants could not survive. …”
    Get full text
    Get full text
    Get full text