Showing 721 - 740 results of 1,777 for search '(( 25 10 decrease ) OR ( 10 (((teer OR per) decrease) OR (((nn decrease) OR (a decrease)))) ))*', query time: 0.20s Refine Results
  1. 721

    Yerba Maté (Illex Paraguariensis) ingestion augments fat oxidation and energy expenditure during exercise at various submaximal intensities by Alkhatib, Ahmad

    Published 2014
    “…Results YM significantly increased FAO and EEFAO by 24% in all submaximal exercise intensities below 70% ofV˙O2peak (p < 0.001, ANOVA main effects) with post hoc tests showing a higher FAO and EEFAO (p < 0.05) at the lower exercise intensities (e.g. 0.26 ± 0.09 vs. 0.35 ± 0.10 and 0.25 ± 0.12 vs. 0.33 ± 0.11 g.min-1 at 40 and 50% ofV˙O2peak respectively). …”
    Get full text
    Get full text
  2. 722

    Analysis of dopant diffusion in molten germanium induced by pulsed nd : yag laser by Mousa, Ali M. [علي مطشر موسى]

    Published 1995
    “…A monotonic decrease in the sheet rcsostance with increasing energy density for all values of E > 10 J/cm2. …”
    Get full text
  3. 723
  4. 724
  5. 725

    Effect Of Sand Blasting On Soda Lime Glass Properties by Bousbaa, C.

    Published 2003
    “…The average strength remains almost constant while the dispersion becomes much reduced for the glass sand blasted during 60 minutes (m = 10.4 and smoy = 64 MPa). The variation of the relative efficiency of glass protected solar panels versus sand blasting duration (seen up to 300 min) shows a slow regular decrease until 0.91 for a 90° impact angle and until 0.95 for 30°. …”
    Get full text
  6. 726

    High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling by Cabibbo, Marcello

    Published 2014
    “…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
    Get full text
    Get full text
  7. 727

    Foamed phase change materials based on recycled polyethylene/paraffin wax blends by Sobolčiak, Patrik

    Published 2021
    “…A stability of samples during 10 heating/cooling cycles was demonstrated. …”
    Get full text
    Get full text
  8. 728

    Effects of Combined Calcium Hypochlorite and Chlorine Dioxide on Drinking Water Quality in Qatar and Disinfection by Products Formation by Mohamed, Elsamoul H.

    Published 2016
    “…The bottles were spiked with Ca(ClO)2 in sequence to give concentration of 0.2, 0.4, 0.6, 0.8, 1.0, and 1.2 mg/l as free chlorine. The mixtures were stored for 7 days at 25°C in the dark then heated to 45°C for two days more, and analyzed daily for physical and chemical parameters. …”
    Get full text
    Get full text
  9. 729
  10. 730

    Conversion of Organic Municipal Wastes into Biochars and their Effect on Fertility Parameters of Normal and Sabkha Soils of Qatar by Ahmedna, Mohamed

    Published 2016
    “…Box-Behnken experimental design was used instead of the full factorial to decrease the number of treatments to a manageable level (126 treatments) with three replications at the center. …”
    Get full text
    Get full text
  11. 731
  12. 732
  13. 733

    Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

    Published 2022
    “…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.01.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
    Get full text
    Get full text
    Get full text
  14. 734

    Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

    Published 2015
    “…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
    Get full text
  15. 735
  16. 736
  17. 737
  18. 738
  19. 739
  20. 740

    Pharmacoeconomic evaluation of voriconazole vs. liposomal amphotericin B in empiric treatment of invasive fungal infections in Turkey by Turner, Stuart J.

    Published 2013
    “…Univariate sensitivity analysis highlighted that increasing the duration of voriconazole by >1.2 days or decreasing LAmB by >1.0 days changes the result. Monte Carlo Simulation resulted in 69.4% of simulations favouring voriconazole per patient treated.Conclusion: There is a strong likelihood that voriconazole is economically more favourable than LAmB in the empiric treatment of IFI in Turkey.…”
    Get full text
    Get full text