Tailoring of the thermal, mechanical and dielectric properties of the polypropylene foams using gamma-irradiation by Mrl�k, Miroslav

Get full text
Get full text

Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

“…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
Get full text

Prevalence of vincristine induced-peripheral neuropathy among Sudanese cancer patients by Imam, Ethar Abdelmageed

“…Healthcare professionals need some understanding regarding medical management that may decrease occurrence of neuropathy and a better planning and implementing special care for patients at risk.…”
Get full text
Get full text

Superior photocatalytic activity of Cu doped NiWO4 for efficient degradation of benzene in air even under visible radiation by Tri N.L.M.

“…This was because Cu effectively acted as novel dopant, which not only affected valence band (VB) top and conduction band (CB) bottom of NiWO4 but also formed a medium energy level between CB and VB of the NiWO4 to decrease its energy band gap and electron-hole recombination rate. …”
Get full text
Get full text

Roadmap toward energy-positive upfront nitrogen removal process in baseload LNG plant by Mkacher, Hajer

“…The results show that UNrem of 87.5% from the NG feed can reduce the total power requirements by 0.24%, increase the production flow rate by 4.4%, and decrease the exergy losses by 0.23% compared with the base case. …”
Get full text
Get full text

Improvement of both lipid and biomass productivities of Qatar Chlorocystis isolate for biodiesel production and food security by Saadaoui, Imen

“…Most previous research evidenced that the increase of the lipid content is accompanied by a decrease of the biomass production, which increases the cost of the downstream processing. …”
Get full text
Get full text

Foamed phase change materials based on recycled polyethylene/paraffin wax blends by Sobolčiak, Patrik

“…Differential Scanning Calorimetry was used to determine the specific enthalpies of melting (22.4–25.1 J/g) what is the latent heat of materials utilized during a heat absorption. …”
Get full text
Get full text

Effect of level of relative humidity on fungi and germination capacity of paddy (oryza sativa l.) Grains in egypt by Mazen, M.B. [محمد بهي الدين مازن]

Get full text

Recycled Polypropylene Fibres for Reinforcing Cement Mortar under Arid Conditions by Bendjillali, Khadra

Get full text
Get full text

Short-term greenhouse emission lowering effect of biochars from solid organic municipal wastes by Rehrah D.

“…A significant decrease in CO2 emission was observed in vials with soil–biochar mixtures, especially for biochars produced at 500 °C compared the corresponding raw materials which exhibited an exponential increase in the CO2 emission. …”
Get full text
Get full text

Trends in prevalence of depression and anxiety symptoms and effects of sociodemographic variables before and after the first wave of COVID-19 in Qatar by Khaled, Salma M.

“…The data for 2020/21 showed a 35.1% and 29.2% decrease in depression and anxiety symptoms scores compared to pre-pandemic years (2017/2018) after adjusting for sociodemographic factors. …”
Get full text
Get full text

Influence of shelf-life duration on mechanical, thermal and shape recovery motion derivatives of shape memory polyurethane by Vasavi, Boggarapu

“…In addition, Differential scanning calorimetry (DSC)exhibited a decrease in glass transition temperature (Tg) from S1 to S10, resulting in a corresponding reduction in the rate of shape restoration. …”
Get full text
Get full text
Get full text

Combined effects of treated domestic wastewater, fly ash, and calcium nitrite toward concrete sustainability by Abushanab, Abdelrahman

“…OPC paste and mortar with TWW were first prepared and compared with the permissible limits specified in ASTM C1602/C1602M ? 18 provisions. After that, ten concrete mixes were prepared with different ratios of TWW (0%, 25%, 50%, and 100%), FA (0%, 20%, and 35%), and CN (0% and 3%) and tested for fresh slump and density, compressive and flexural strengths, electrical resistivity, porosity, and chloride permeability. …”
Get full text
Get full text

Modeling of dual-metal Schottky contacts based silicon micro and nano wire solar cells by Rabbani, M. Golam

Get full text
Get full text

Utilization of Two Microalgae Species, Synechococcus sp. and Cheatoceros sp., for Aquatic Toxicity Assessments in the Qatari Marine Environmen by Bacha, Sarah

“…Similar results were obtained at 30°C and salinity 40%. The lowest growth rates were observed at the lowest temperatures, while a decreased rate was also observed at the highest temperature. …”
Get full text
Get full text

Impact of trace noble metals on the catalytic performance of LaNiMgO towards methane dry reforming by Mohamed, Assem T.

“…In addition, the presence of noble metals at the Ni surface afforded a high density of adsorbed oxygen species, which enhanced coke gasification and consequently decreased the extent of deactivation of the catalysts by coke formation. …”
Get full text
Get full text
Get full text

Electrospun polylactic acid/date palm polyphenol extract nanofibres for tissue engineering applications by Khadija M., Zadeh

“…Increasing the polyphenol concentration caused the tensile strength and Young’s modulus to decrease. The SEM graphs indicated a decrease in fibre diameter with increasing DP content. …”
Get full text
Get full text

Undrained interface shear strength of fine-grained soils for near-shore marine pipelines by Eid, Hisham T.

“…The peak and residual interface shear strengths for a variety of normally consolidated soils were measured using a torsional ring shear apparatus modified to suit soil and interface testing under the undrained condition, which is usually prevalent at soil-marine pipeline interfaces. …”
Get full text
Get full text

Novel voltage balancing algorithm for single-phase cascaded multilevel inverter for post-module failure operation in solar photovoltaic applications by Rahman S.

Get full text
Get full text

Structural and electrochemical properties of electrodeposited Ni-P nanocomposite coatings containing mixed ceramic oxide particles by Zadeh, K.M.

Get full text
Get full text