Electrocoagulation treatment of reject brine effluent from Solvay process by Osman M.A.

Get full text
Get full text

Tailoring of the thermal, mechanical and dielectric properties of the polypropylene foams using gamma-irradiation by Mrl�k, Miroslav

Get full text
Get full text

Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

“…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Prevalence of vincristine induced-peripheral neuropathy among Sudanese cancer patients by Imam, Ethar Abdelmageed

“…Healthcare professionals need some understanding regarding medical management that may decrease occurrence of neuropathy and a better planning and implementing special care for patients at risk.…”
Get full text
Get full text

Superior photocatalytic activity of Cu doped NiWO4 for efficient degradation of benzene in air even under visible radiation by Tri N.L.M.

“…This was because Cu effectively acted as novel dopant, which not only affected valence band (VB) top and conduction band (CB) bottom of NiWO4 but also formed a medium energy level between CB and VB of the NiWO4 to decrease its energy band gap and electron-hole recombination rate. …”
Get full text
Get full text

Structural influence of chromium substituted magnetite ferrofluids on the optical and antibacterial characteristics by Babukutty, B.

“…As the composition of Cr increases from x = 0.2 to x = 0.8, the crystalline size decreases reaching a minimum value of 9 nm. At the same time, the magnetic moment also becomes 1.3 +- 0.08 at a saturation point of 33 +- 0.13 emu/g at the highest Cr composition. …”
Get full text
Get full text

Roadmap toward energy-positive upfront nitrogen removal process in baseload LNG plant by Mkacher, Hajer

“…The results show that UNrem of 87.5% from the NG feed can reduce the total power requirements by 0.24%, increase the production flow rate by 4.4%, and decrease the exergy losses by 0.23% compared with the base case. …”
Get full text
Get full text

Recycled Polypropylene Fibres for Reinforcing Cement Mortar under Arid Conditions by Bendjillali, Khadra

Get full text
Get full text

Short-term greenhouse emission lowering effect of biochars from solid organic municipal wastes by Rehrah D.

“…A significant decrease in CO2 emission was observed in vials with soil–biochar mixtures, especially for biochars produced at 500 °C compared the corresponding raw materials which exhibited an exponential increase in the CO2 emission. …”
Get full text
Get full text

Influence of shelf-life duration on mechanical, thermal and shape recovery motion derivatives of shape memory polyurethane by Vasavi, Boggarapu

“…In addition, Differential scanning calorimetry (DSC)exhibited a decrease in glass transition temperature (Tg) from S1 to S10, resulting in a corresponding reduction in the rate of shape restoration. …”
Get full text
Get full text
Get full text

Modeling of dual-metal Schottky contacts based silicon micro and nano wire solar cells by Rabbani, M. Golam

Get full text
Get full text

Mixed Solid Municipal Waste-Based Biochar for Soil Fertility and Greenhouse Gas Mitigation by Bansode, Rishipal

“…Municipal solid waste management is one of the major challenges facing Qatar with more than 2.5 million tons of municipal solid waste each year, a very high waste generation rate in a country with small land mass. …”
Get full text
Get full text

Electrospun polylactic acid/date palm polyphenol extract nanofibres for tissue engineering applications by Khadija M., Zadeh

“…Increasing the polyphenol concentration caused the tensile strength and Young’s modulus to decrease. The SEM graphs indicated a decrease in fibre diameter with increasing DP content. …”
Get full text
Get full text

Undrained interface shear strength of fine-grained soils for near-shore marine pipelines by Eid, Hisham T.

“…The peak and residual interface shear strengths for a variety of normally consolidated soils were measured using a torsional ring shear apparatus modified to suit soil and interface testing under the undrained condition, which is usually prevalent at soil-marine pipeline interfaces. …”
Get full text
Get full text

Novel voltage balancing algorithm for single-phase cascaded multilevel inverter for post-module failure operation in solar photovoltaic applications by Rahman S.

Get full text
Get full text

Structural and electrochemical properties of electrodeposited Ni-P nanocomposite coatings containing mixed ceramic oxide particles by Zadeh, K.M.

Get full text
Get full text

Unlocking the application potential of electrocoagulation process through hybrid processes by Almukdad, Abdulkarim

Get full text
Get full text

An Overview of Solid Waste Management and Plastic Recycling in Qatar by Al-Maaded, M.

“…The analysis showed that Qatar produced around 2,000,000 tons of solid municipal waste annually, corresponding to a daily generation rate per capita of about 2. 5 kg. …”
Get full text
Get full text

Interface modification of compatibilized polyethylene terephthalate/polypropylene blends: Effect of compatibilization on thermomechanical properties and thermal stability by Inuwa, Ibrahim M.

“…PET, PP, and SEBS-g-MAH were melt-blended in a single stLGusing the counter rotating twin screw extruder with compatibilizer concentrations of 0, 5, 10, and 15 phr, respectively. …”
Get full text
Get full text