Showing 1,081 - 1,100 results of 1,765 for search '(( 27 10 decrease ) OR ( 10 (((meter OR peter) decrease) OR (((nn decrease) OR (a decrease)))) ))*', query time: 0.18s Refine Results
  1. 1081
  2. 1082
  3. 1083
  4. 1084
  5. 1085

    Continuous adsorptive removal of glimepiride using multi-walled carbon nanotubes in fixed-bed column. by Badran, ismail

    Published 2021
    “…The maximum adsorption capacity (q) was 275.3 mg/g, and the axial dispersion coefficients were ranged between 3.5 and 9.0 × 10 m/s. The spent adsorbent was successfully regenerated at high pH by flushing with NaOH.…”
    Get full text
    Get full text
  6. 1086
  7. 1087
  8. 1088
  9. 1089
  10. 1090

    Nanoclay compatibilization of phase separated polysulfone/polyimide films for oxygen barrier by Ammar, Ali

    Published 2017
    “…Thermal decomposition (TGA) measurements of PSF/PI films showed a decrease in thermal stability upon adding C30B due to its surfactant modification, while film mechanical tensile modulus properties improved slightly by adding low concentration of C30B (~ 1 mass%), but higher nanoclay loading decreased tensile strength and elongation at break. …”
    Get full text
    Get full text
  11. 1091
  12. 1092

    Fluctuations in cardiac stroke volume during rowing by Sejersen, Casper

    Published 2021
    “…Also, SV fluctuated markedly during the stroke with deviations being largest at the higher work rate. Thus, SV decreased by 27 ± 10% (31 ± 11 mL) at the beginning of the stroke and increased by 25 ± 9% (28 ± 10 mL) in the recovery (P =.013), while breathing was entrained with one breath during the drive of the stroke and one prior to the next stroke. …”
    Get full text
    Get full text
    Get full text
  13. 1093

    Development of an Air-Cooled Induction Manifold for Diesel Engines in Hot and Humid Climate by Elrentisy, Mohamed H.

    Published 2022
    “…Moreover, the air-to-fuel (A/F) ratio has increased by 27.5% with 20 °C compared with 45 °C, while a minor effect was observed on the specific fuel consumption. …”
    Get full text
    Get full text
    Get full text
  14. 1094

    Changes in air quality during the first-level response to the COVID-19 pandemic in Shanghai Municipality, China by Bai, Yang

    Published 2020
    “…The results showed that air quality improved significantly During-FLR compared with Pre-FLR, with the concentrations of PM2.5, PM10, SO2, NO2, and CO all decreasing significantly. …”
    Get full text
    Get full text
    Get full text
  15. 1095

    Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

    Published 2015
    “…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
    Get full text
  16. 1096
  17. 1097
  18. 1098

    Relationship between Asymmetry Indices, Anthropometric Parameters, and Physical Fitness in Obese and Non-Obese High School Students by Haddad, Monoem

    Published 2022
    “…Twenty-six male students (15 ± 1.0 years) were randomly selected. Body composition, measurements of vertical jump height using a countermovement jump test (CMJ), and dynamic single stance balance using the Y-balance test (YBT), were collected over 4 weeks. …”
    Get full text
    Get full text
  19. 1099
  20. 1100

    Pd nanocrystals encapsulated in MOF-derived Ni/N-doped hollow carbon nanosheets for efficient thermal CO oxidation: unveiling the effect of porosity by Ipadeola, Adewale K.

    Published 2023
    “…The obtained Pd/Ni-MOF-HNC possesses hollow carbon sheets with a great surface area (153.05 m2 g−1), pore volume (0.12 cm3 g−1), rich Pd/Ni-Nx active sites, Ni-metal defects, rich N-content (7.53 at%), mixed Pd/Ni-oxide phases, and uniformly distributed ultra-small Pd nanocrystals (7.03 ± 1.10 nm); meanwhile, Pd/Ni-MOF-NC formed without etching had no porosity and less Ni-metal defects. …”
    Get full text
    Get full text
    Get full text