Preterm birth in low-middle income Countries by Alim, Swarray-Deen

Get full text
Get full text
Get full text

Gamma irradiation effects on polymethyl methacrylate by Al-Qaradawi, I. Y.

Get full text
Get full text

INVESTIGATION OF SPATIOTEMPORAL VARIABILITY AND CONTAMINATION OF PLASTIC MARINE DEBRIS IN QATAR’S COASTAL WATERS by Abayomi, Oyebamiji Abib

“…There has been a tremendous proliferation in plastic production in the last five decades due to its low cost and versatile applications. …”
Get full text

Microstructure and compressive behavior of Al-Y2O3 nanocomposites prepared by microwave-assisted mechanical alloying by Mattli M.R.

“…The Al–1.5 vol. % Y2O3 nanocomposite exhibited the best ultimate compressive strength and yielded a strength of 359 ± 7 and 111 ± 5 MPa, respectively. …”
Get full text
Get full text

Functionalization of silica-coated magnetic nanoparticles as powerful demulsifier to recover oil from oil-in-water emulsion by Elmobarak W.F.

“…The Fe–Si-MNP exhibited excellent %Soil, reliable stability, and high magnetization values ranging between 46.1 and 80.2 emu/g. adding a 5 nm silica layer on the surface of the Fe–Si-MNP (i.e., Fe–Si-1) protected them from oxidation conditions, extended their service life, and achieved a %Soil of ∼96.3%. …”
Get full text
Get full text

Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites by Ahamad, N.

Get full text
Get full text

Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites by Ahamad, N.

Get full text
Get full text

Occurrence, origin and potential ecological risk of dissolved polycyclic aromatic hydrocarbons and organochlorines in surface waters of the Gulf of Gabès (Tunisia, Southern Mediter... by Hatem, Zaghden

Get full text
Get full text
Get full text

Plasticization and co-crystallization in LLDPE/wax blends. by Gumede, Thandi P.

Get full text
Get full text

Enhancing compressive, tensile, thermal and damping response of pure Al using BN nanoparticles by Penchal Reddy M.

“…The addition of BN nanoparticulates enhanced the damping characteristics of pure Al with Al-1.5 vol.% BN nanocomposite exhibiting the maximum damping capacity and damping loss rate with a minimum change in elastic modulus. …”
Get full text
Get full text

Tribological studies of nanomodified mineral based multi-grade engine oil by Laad, M.

“…Wear rate for lubrication oil without nanoadditives was also found to be decreased with increase in sliding speed. Experimental results prove that nanoparticles can be used as a multifunctional additive in lubricating oil to enhance its tribological properties.…”
Get full text
Get full text

Impact of composition and salinity on swelling and gel strength of poly (acrylamide-co-acrylic acid) preformed particle gel by Ben Ali, Ahmed

“…On the contrary, PPG5, with the lowest acrylic acid and highest crosslinker content, has a swelling capacity of 239 g/g and more than 17 g/g in distilled and brine 1, respectively. …”
Get full text
Get full text

Enhanced performance of nano-sized SiC reinforced Al metal matrix nanocomposites synthesized through microwave sintering and hot extrusion techniques by Reddy, M. Penchal

“…In the present study, nano-sized SiC (0, 0.3, 0.5, 1.0 and 1.5 vol%) reinforced aluminum (Al) metal matrix composites were fabricated by microwave sintering and hot extrusion techniques. …”
Get full text
Get full text

Assessment of morphological changes due to oxidative stress: leukodepleted packed red blood cells stored in SAGM by Mustafa, Ibrahim

“…Methods: In this study, the effect of prolonged storage was assessed through investigating morphological alteration and evaluating oxidative stress.Samples from leukodepleted pRBC in SAGM stored at 4◦C for 42 days were withdrawn aseptically on day 0, day 14, day 28 and day 42. …”
Get full text
Get full text

Application of Green Polymeric Nanocomposites for Enhanced Oil Recovery by Spontaneous Imbibition from Carbonate Reservoirs by Ahmadi, Yaser

“…It was found that both ENC and WNC nanocomposites decreased CA and IFT, but ENC performed better than WNC under different salinities, namely, seawater (SW), double diluted salted (2 SW), ten times diluted seawater (10 SW), formation water (FW), and distilled water (DIW), which were applied at 70 °C, 2000 psi, and 0.05 wt.% nanocomposites concentration. …”
Get full text
Get full text
Get full text

Efficacy of FRCM systems in flexural strengthening of RC T-beams by Wakjira T.G.

“…Three different test parameters have been considered: (a) FRCM type (carbon and glass), (b) FRCM strengthening scheme (side bonded versus U-shaped scheme), and (c) internal flexural reinforcement ratio. The strengthening system increased the ultimate load carrying capacity by 16.52 - 46.73% in carbon FRCM strengthened beams and 4.84 - 29.41% for glass fRcM strengthened beams relative to the reference beams. …”
Get full text
Get full text

Evaluation of antidiabetic and nephroprotective effects of Origanum majorana (Marjoram) Leaf Extract and its Nanoparticles on Streptozotocin-Induced diabetes in Rats by Ratib, Mohamed Osama

“…Methods: 25 Diabetic Rats were separated into 5gps: Group I: (n = 5) untreated (Non-diabetic Control), Group II: (n = 5) injected with Streptozotocin (STZ) untreated diabetic group, Group III: (n = 5) diabetic rats treated with the glibenclamide drug, Group IV: (n = 5) diabetic rats administration of OM leaf extract, Group V: (n = 5) diabetic rats administration of OM leaf extract nanoparticles. …”
Get full text
Get full text

Improving mechanical, thermal and damping properties of niti (Nitinol) reinforced aluminum nanocomposites by Matli, Penchal R.

Get full text
Get full text

Osteogenesis imperfecta tooth level phenotype analysis: Cross-sectional study by Doaa, Taqi

“…Patients with Helical α1 and α2 glycine substitutions presented the highest prevalence of tooth discoloration, while those with α1 Haploinsufficiency had the lowest (<10%). C-propeptide variants did not cause discoloration but resulted in the highest pulp obliteration prevalence (~%20). …”
Get full text
Get full text
Get full text

Nitrogen Transformations as affected by some factors at cultivated soils in Saudi Arabia by Al Falih, Abdullah M. [عبد الله مساعد خلف الفالح]

“…Ammonium sulphate (5 mg N g-1 soil) was added and the soil samples were incubated at 25°C for 4 weeks. Increased salinity delayed or inhibited nitrification. …”
Get full text