Showing 381 - 400 results of 917 for search '(( 45 c decrease ) OR ( 5 ((steel decrease) OR (((nn decrease) OR (a decrease)))) ))', query time: 0.20s Refine Results
  1. 381

    Development of pH-Controlled Aluminum-Based Polymeric Gel for Conformance Control in Sour Gas Reservoirs by Shamlooh M.

    Published 2020
    “…The results reveal that aluminum acetate, among the screened salts, has a controllable gelation time at pH conditions between 3.5 and 8.5 and is the most stable in the temperature range 25–100 °C. …”
    Get full text
    Get full text
    Get full text
  2. 382

    Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

    Published 2015
    “…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
    Get full text
  3. 383

    Analysis of dopant diffusion in molten germanium induced by pulsed nd : yag laser by Mousa, Ali M. [علي مطشر موسى]

    Published 1995
    “…Doped sample Tann = 200- 500 C for time t mn = 45 subjected to subsequent thermal annealing (at the temperature and to plused leacr annealing (en<5rgy density in a min) pluse E=5.2 - 9.5 J/cm2) in order to establish optimal condition. …”
    Get full text
  4. 384

    Structural and electrochemical properties of electrodeposited Ni-P nanocomposite coatings containing mixed ceramic oxide particles by Zadeh, K.M.

    Published 2016
    “…The coatings were electrodeposited on mild steel substrate and were then characterized using various techniques. …”
    Get full text
    Get full text
  5. 385

    Assessment of Urban Heat Islands Based on the Relationship Between Land Surface Temperature and Land Use/Land Cover in Greater Doha by Siddiqui, Simil Amir

    Published 2020
    “…The overall LST of greater Doha has increased by 0.7°C from 2000 to 2019. Furthermore %LULC of built up, vegetation, barren land, marsh land and water body were 29%, 4.5%, 58.6%, 2.8% and 5% in 2000 and 56.5 %, 8.2%, 33.2 %, 0% and 2.1% in 2019 respectively. …”
    Get full text
    Get full text
  6. 386

    Recycled Polypropylene Fibres for Reinforcing Cement Mortar under Arid Conditions by Bendjillali, Khadra

    Published 2023
    “…The present experimental work is conducted to investigate the physical and the mechanical behaviour of cement mortar reinforced by recycled polypropylene fibres under arid conditions, at 45 °C and 30% RH. The used polypropylene fibres are recycled from a domestic plastic waste. …”
    Get full text
    Get full text
  7. 387

    High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling by Cabibbo, Marcello

    Published 2014
    “…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
    Get full text
    Get full text
  8. 388

    Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings by Ubaid F.

    Published 2019
    “…Various contents of the encapsulated TiO2 nanotubes (1, 3 and 5 wt%) were thoroughly dispersed into the epoxy matrix and the resulting composites were then applied on a cleaned steel substrate using doctor blade technique to develop smart coatings. …”
    Get full text
    Get full text
  9. 389

    Cultivating microalgae in desert conditions: Evaluation of the effect of light‐temperature summer conditions on the growth and metabolism of nannochloropsis qu130 by Jabri, Hareb Al

    Published 2021
    “…In the Qatar desert the temperature varies widely, typically between 10° and 45 °C There are also wide variations in light intensity, with values of over 1500 μmolhν.m−2s−1 in summer. …”
    Get full text
    Get full text
    Get full text
  10. 390

    Shear Behavior of Green Concrete Beams Reinforced with Basalt FRP Bars and Stirrups. by Elahtem, Ayman Ahmed

    Published 2020
    “…The parameters investigated in this study are span to depth ratio (i.e. a/d =2.5 and 3.5), reinforcement ratio , stirrups spacing effect (i.e. 250 mm and 350 mm) and stirrups type (Steel and Basalt). …”
    Get full text
  11. 391
  12. 392
  13. 393

    Development of an Air-Cooled Induction Manifold for Diesel Engines in Hot and Humid Climate by Elrentisy, Mohamed H.

    Published 2022
    “…Furthermore, the smoke emission has decreased by 40% at the engine full load. It was also proved that using the air-conditioning system of a vehicle to cool the intake air temperature is visible, as the net gained the power of the engine has increased by 14.5% when running at 20 °C compared with 45 °C.…”
    Get full text
    Get full text
    Get full text
  14. 394

    Comparative Investigation of the Physicochemical Properties of Chars Produced by Hydrothermal Carbonization, Pyrolysis, and Microwave-Induced Pyrolysis of Food Waste by Khan, Moonis Ali

    Published 2022
    “…A similar decreasing trend in the mass yield was also observed after PY (28.45 to 26.67%) and MW (56.45 to 22.44%) of the food waste mixture from 500 to 700 °C and 300 to 600 W, respectively. …”
    Get full text
    Get full text
  15. 395

    Modeling the influence of daily temperature and precipitation extreme indices on vegetation dynamics in Katsina State using statistical downscaling model (SDM) by Mohammad, Hadi Ahmad

    Published 2023
    “…Tmax and Tmin were projected under low emissions at 20.1 0C and 14.25 0C (RCP2.6), 20.13 °C and 14.26 0C (RCP4.5), and 20.15 0C and 14.27 0C (RCP8.5) respectively. …”
    Get full text
    Get full text
    Get full text
  16. 396

    Modeling the influence of daily temperature and precipitation extreme indices on vegetation dynamics in Katsina State using statistical downscaling model (SDM) by Mohammad, Hadi Ahmad

    Published 2023
    “…Tmax and Tmin were projected under low emissions at 20.1 0C and 14.25 0C (RCP2.6), 20.13 °C and 14.26 0C (RCP4.5), and 20.15 0C and 14.27 0C (RCP8.5) respectively. …”
    Get full text
    Get full text
    Get full text
    article
  17. 397

    Specific Bioactive Compounds from Ginger, Tea, and Apple Prevent Diabetes-Related Cataract Via Inhibition of Aldose Reducatse by Ahmedna, Mohamed

    Published 2016
    “…Results show that cell viability decreased to 93 ± 3%, 83 ± 6%, 65 ± 4% and 39 ± 3% at 10, 25, 50 and 100 mM of glucose on day 1 with further drastic decrease in cell viability to 73 ± 5%, 61 ± 3%, 35 ± 2%, and 11 ± 6%, respectively, on day 4 compared to the untreated cell. …”
    Get full text
    Get full text
  18. 398

    Novel, selective EPO receptor ligands lacking erythropoietic activity reduce infarct size in acute myocardial infarction in rats by Kiss, K.

    Published 2016
    “…In study 4, AF43136 at 10 mg/kg decreased infarct size, similarly to the positive control CsA compared to the appropriate vehicle (39.4 ± 5.9% vs. 58.1 ± 5.4% and 45.9 ± 2.4% vs. 63.8 ± 4.1%, p < 0.05, respectively). …”
    Get full text
    Get full text
  19. 399

    Self-healing performance of smart coatings modified with different corrosion inhibitors. by Habib, Sehrish

    Published 2020
    “…EIS measurements revealed the decent corrosion inhibition efficiency of these inhibitors in order of DDA>NMTU. As a result, they are a favorable solution for longer endurance of coated piping steel and decreased operation expense contributing to economic saves, materials reliability and safety…”
    Get full text
    Get full text
  20. 400

    Inhibitory effect of sodium nitrite on corrosion of lead in 0.1 M sodium hydroxide solution by Mourad, M.Y.

    Published 1988
    “…The maximum inhibition efficiency is found to be 49.4% at 35°C and 45.9% at 50°C.…”
    Get full text