Showing 1,341 - 1,360 results of 1,898 for search '(( 5 ((greater decrease) OR (nn decrease)) ) OR ( a ((mean decrease) OR (a decrease)) ))', query time: 0.30s Refine Results
  1. 1341

    Development of an Air-Cooled Induction Manifold for Diesel Engines in Hot and Humid Climate by Elrentisy, Mohamed H.

    Published 2022
    “…Furthermore, the smoke emission has decreased by 40% at the engine full load. It was also proved that using the air-conditioning system of a vehicle to cool the intake air temperature is visible, as the net gained the power of the engine has increased by 14.5% when running at 20 °C compared with 45 °C.…”
    Get full text
    Get full text
    Get full text
  2. 1342

    Recycled Waste Tires Management in Constructions by Hamid, Salma Mohamed

    Published 2020
    “…The reuse of rubber is therefore inevitable. This study conducts a life cycle cost analysis (LCCA) to compare the cost-effectiveness of a conventional concrete mix (RC1) with a rubberized concrete mix (RC2). …”
    Get full text
  3. 1343

    Algal-algal bioflocculation enhances the recovery efficiency of Picochlorum sp. QUCCCM130 with low auto-settling capacity by Saadaoui, I.

    Published 2023
    “…Results showed that self-settlement capacity increased with cell size and can be indirectly related to a decreased zeta potential of larger cells which enhances the Van der Waals attractive forces. …”
    Get full text
    Get full text
  4. 1344

    Emerging clay-aryl-gold nanohybrids for efficient electrocatalytic proton reduction by Jlassi, Khouloud

    Published 2018
    “…Both nanohybrids showed efficient electrochemical activity for HER in acidic condition (0.1 M H2SO4) with high current density up to −25 mA.cm−2 at −1 V and 0.148 mV onset. Negligible decreasing in current density and slight shift in onset was observed after 1000 cycles. …”
    Get full text
    Get full text
  5. 1345

    The Separation of Emulsified Water/Oil Mixtures through Adsorption on Plasma-Treated Polyethylene Powder by Abdulkareem, Asma

    Published 2021
    “…Powdered low-density polyethylene (LDPE) was modified by radio-frequency plasma discharge and then used as a medium for the treatment of emulsified diesel oil/water mixtures in the concentration range from 75 ppm to 200 ppm. …”
    Get full text
    Get full text
  6. 1346

    Conjugated Linoleic Acid (CLA) co-treatment alleviates antidiabetic drug, rosiglitazone associated deterioration of bone remodeling by Ibrahim, Khadega

    Published 2021
    “…Diabetes mellitus (DM) is a chronic metabolic disease characterized by hyperglycemia due to decreased insulin secretion, defective action or both. …”
    Get full text
    Get full text
  7. 1347

    Electrocatalytic cogeneration of reactive oxygen species for synergistic water treatment by Yang S.Y.

    Published 2019
    “…Regardless of the purging gas, a stepwise increase in ESS enhances the OH generation and phenol decomposition, yet inversely decreases the current efficiency of OH (max. ∼30%), owing to competitive O2 evolution. …”
    Get full text
    Get full text
  8. 1348

    Numerical and wind tunnel investigation of Hot Air Recirculation across Liquefied Natural Gas Air Cooled Heat Exchangers by Ghani S.

    Published 2018
    “…Three dimensional Computational Fluid Dynamics (CFD) studies were utilized to simulate the airflow around a full scale LNG plant. The simulations clearly captured HAR between parallel ACHE banks (Cross-HAR) and within a single ACHE unit (Self-HAR). …”
    Get full text
    Get full text
  9. 1349

    Magneto-Mechanical and Thermal Properties of Nd-Fe-B-Epoxy-Bonded Composite Materials by Grujić, Aleksandar

    Published 2023
    “…Polymer-bonded magnets are a class of composite material that combines the magnetic properties of metal particles and the molding possibility of a polymeric matrix. …”
    Get full text
    Get full text
    Get full text
  10. 1350

    Why Construction Projects are delayed in PWA: Problems and Solutions by Al Marri, Dana Ahmad

    Published 2023
    “…Changes and variations are inherently part of many construction projects, which require serious efforts to overcome. Project delay is a construction problem resulting in contractual claims, increased project cost, and decreased end-user satisfaction. …”
    Get full text
    Get full text
  11. 1351

    VANET-Based smart navigation for vehicle crowds: FIFA world cup 2022 case study by Elbery, Ahmed

    Published 2019
    “…This paper utilizes VANETs to build a vehicular crowd management system that utilizes system-optimum stochastic routing. …”
    Get full text
    Get full text
    Get full text
  12. 1352

    Enhancing compressive, tensile, thermal and damping response of pure Al using BN nanoparticles by Penchal Reddy M.

    Published 2018
    “…Mechanical analysis indicates that the compression, hardness and tensile strength of Al-BN nanocomposites increases with increasing amount of BN content. Particularly, a significant improvement in the tensile strength (?…”
    Get full text
    Get full text
  13. 1353

    Experimental Investigation on the Flexural Capacity of Reinforced Concrete Beams with Treated Wastewater and Recycled Concrete Aggregates by Abushanab, Abdelrahman

    Published 2023
    “…In addition, the utilization of FA at a 20% replacement ratio enhanced the flexural strength by 5% to 7%.…”
    Get full text
    Get full text
  14. 1354

    Electrochemical and thermodynamic study on the corrosion performance of API X120 steel in 3.5% NaCl solution by Shahzad, Khuram

    Published 2020
    “…The overall results revealed that PEI significantly decreases the corrosion rate of API X120 steel with inhibition efficiency of 94% at a concentration of 100 μmol L−1. …”
    Get full text
    Get full text
    Get full text
  15. 1355

    Event-Triggered fault detection, isolation and control design of linear systems by Davoodi, M.R.

    Published 2015
    “…It is shown that by using an event-Triggered technique applied to both the sensor and filter nodes, the amount of data that is sent through the sensor-To-filter and filter-To-Actuator channels are dramatically decreased. A set of linear matrix inequality (LMI) feasibility conditions are derived to ensure the solvability of the problem as well as to simultaneously obtain the filter parameters and the event-Triggered conditions. …”
    Get full text
    Get full text
  16. 1356
  17. 1357

    Microwave-Assisted Solvothermal Synthesis of Mo-Doped TiO2 with Exceptional Textural Properties and Superior Adsorption Kinetics by Ahmad, Yahia H.

    Published 2022
    “…The average particle size ranged between 9.7 and 27.5 nm and it decreased with increasing the Mo content. Furthermore, Mo-TiO2 revealed mesoporous architectures with a high surface area ranging between 170 and 260 m2 g−1, which is superior compared to previously reported Mo-doped TiO2. …”
    Get full text
    Get full text
    Get full text
  18. 1358

    Pore-scale simulation of fine particles migration in porous media using coupled CFD-DEM by Elrahmani, Ahmed

    Published 2022
    “…The time required to develop bridging and subsequent clogging of the pore space that lead to permeability reduction decreases as the flow velocity increases. The size of the fine particles has a significant impact on permeability reduction where the reduction in permeability increases as the size of particles increases. …”
    Get full text
    Get full text
  19. 1359

    Locations of Temporary Distribution Facilities for Emergency Response Planning by Pradhananga, Rojee

    Published 2016
    “…However, prepositioned facilities may be small in numbers and distribution of resources to the affected area may require additional funds for transportation and other overhead costs. In such a case, distribution of resources through a number of temporary facilities, located near the demand centers can significantly improve the distribution process thereby decreasing the supply response time. …”
    Get full text
    Get full text
  20. 1360

    Combined influence of temperature and flow rate of feeds on the performance of forward osmosis by Hawari, Alaa H.

    Published 2016
    “…It was also found that when increasing the draw solution (DS) temperature from 20 °C to 26 °C the flux increased linearly and then started decreasing when temperature increased over 26 °C due to the development of a temperature gradient. …”
    Get full text
    Get full text