Modification of Pd/CeO2 catalyst by Atomic Layer Deposition of ZrO2 by Onn, Tzia Ming

“…Methane-oxidation rates in 0.5% CH4 and 5% O2 were slightly lower on the ZrO2-covered catalyst when both materials were calcined at 673 K but the activity of the ZrO2-modified catalyst did not decrease with catalyst calcination temperature. …”
Get full text
Get full text

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles by Chamakh, Mariem

“…The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 �C for 4 h to form the ruthenium oxide nanoparticles. …”
Get full text
Get full text

Correlating the rheological and magneto-optical properties of cobalt substituted magnetite ferrofluids (CoxFe1?xFe2O4) with theoretical studies by Babukutty, B.

Get full text
Get full text

Molecular dynamics of CH4/CO2 on calcite for enhancing gas recovery by Carchini, Giuliano

“…Radial distribution function (RDF) analysis reveals two distinct peaks for CO2 (0.36 and 0.47 nm) and two for methane (0.87 and 0.57 nm) and the intensities of these peaks tend to decrease with increasing temperature. …”
Get full text
Get full text

ASSOCIATION BETWEEN INSULIN RESISTANCE AND NITRIC OXIDE IN HUMAN RETINAL MICROVASCULAR ENDOTHELIAL CELLS IN VITRO by Bushra, Sumbul

“…In the current study in order to examine the effect of insulin on NO production, HRECs cells were cultured and grown in high glucose (30mM) and normal (5mM) glucose for 24 hours. Subsequently, the cells were treated with 100nM insulin for 10 minutes, 1, 2, and 4 hours. …”
Get full text

Acidity's Impact on Yield, Morphological Structure, and Surface Functionalities of Polyaniline Synthesised via Oxidative Polymerisation by Ahmat, Dounia Ousmane

“…The findings revealed that reducing the medium pH from 2.35 (in distilled water) to 0.80 (in 10 M HCl) resulted in a colour change from light brownish to dark green, indicating the formation of emeraldine PANI. …”
Get full text
Get full text

The Structure of the Free Volume in Poly(styrene-co-acrylonitrile) from Positron Lifetime and Pressure Volume Temperature (PVT) Experiments by Dlubek, Gunter

“…The specific number of holes, equation image, estimated from a comparison of PVT and PALS results, is independent on the temperature and the composition of SAN, equation image = (0.56 ± 0.02) × 1021 g−1 which corresponds to Nh(Tg) = equation image/V(Tg) = 0.59 nm−3 and 1/Nh(Tg) = 1.7 nm3 for the volume which contains one hole. …”
Get full text
Get full text

Reinforcement of polyacrylamide-co-tert-butyl acrylate base gel using nanosilica for conformance control at low and high reservoir temperatures by Shamlooh M.

“…The investigation reveals that PatBA:CrAc3 of 9:0.5 is the optimum ratio producing the most strong gel. …”
Get full text
Get full text

In vitro effects of hydrogen peroxide on rat uterine contraction before and during pregnancy by AlanaziR.

“…M H 2 O 2 on spontaneous uterine contractions and contractions induced by oxytocin (5 nM), high calcium (Ca +2 ) solution (6 mmol/L), and high potassium chloride (KCl) solution (60 mmol/L). …”
Get full text
Get full text

Effect of anions on the structural, morphological and dielectric properties of hydrothermally synthesized hydroxyapatite nanoparticles by Sundarabharathi L.

“…For the particles obtained from nitrate, acetate, chloride and egg shell precursors respectively give dielectric constant (εʹ) values of 9.96, 13.22, 9.92 and 10.86 at 5 MHz. The εʹ and dielectric loss (εʹʹ) values for the HA nanoparticles decrease with increase in the applied frequency as well. …”
Get full text
Get full text

Trends in prevalence of depression and anxiety symptoms and effects of sociodemographic variables before and after the first wave of COVID-19 in Qatar by Khaled, Salma M.

“…The data for 2020/21 showed a 35.1% and 29.2% decrease in depression and anxiety symptoms scores compared to pre-pandemic years (2017/2018) after adjusting for sociodemographic factors. …”
Get full text
Get full text

Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings by Ubaid F.

“…Towards this direction, TiO2 nanotubes with an average size of ⁓10–15 nm (as confirmed by scanning electron microscope (SEM) and transmission electron microscope (TEM) analysis) were synthesized through a hydrothermal process and were then impregnated with DOC. …”
Get full text
Get full text

Tailoring electrocatalytic properties of Pt nanoparticles grown on Ti3C2Tx MXene surface by Filip, Jaroslav

“…Composites containing 14 wt% Pt showed HER with an onset potential of −75.9 mV and a current density of −10 mA cm−2 achieved at −226 mV. …”
Get full text
Get full text
Get full text

Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

“…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
Get full text

Fabrication and characterization of flexible ruthenium oxide-loaded polyaniline/poly(vinyl alcohol) nanofibers by Chamakh, M.

“…The tests revealed the decrease of electrical resistivity and activation energy with increasing RuO2 concentration for the as-prepared samples, while the annealed samples showed lower activation energy values of ~0.1 eV with increasing the concentration of RuO2. …”
Get full text
Get full text
Get full text

High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling by Cabibbo, Marcello

“…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
Get full text
Get full text

Pd nanocrystals encapsulated in MOF-derived Ni/N-doped hollow carbon nanosheets for efficient thermal CO oxidation: unveiling the effect of porosity by Ipadeola, Adewale K.

“…The obtained Pd/Ni-MOF-HNC possesses hollow carbon sheets with a great surface area (153.05 m2 g−1), pore volume (0.12 cm3 g−1), rich Pd/Ni-Nx active sites, Ni-metal defects, rich N-content (7.53 at%), mixed Pd/Ni-oxide phases, and uniformly distributed ultra-small Pd nanocrystals (7.03 ± 1.10 nm); meanwhile, Pd/Ni-MOF-NC formed without etching had no porosity and less Ni-metal defects. …”
Get full text
Get full text
Get full text

Functionalization of silica-coated magnetic nanoparticles as powerful demulsifier to recover oil from oil-in-water emulsion by Elmobarak W.F.

“…The %Soil slightly decreased to ∼92% with an alkaline pH or when the thickness of the silica layer increased to ≥10 nm. …”
Get full text
Get full text

Association between Insulin and Nitric Oxide in Human Retinal Microvascular Endothelial Cells in vitro by Rizk, Nasser Moustafa

“…In the current study in order to examine the effect of insulin on NO production, HRECs cells were cultured and grown in high glucose (30 mM) and normal (5 mM) glucose for 24 hours. Subsequently, the cells were treated with 100 nM insulin for 10 minutes, 1, 2, and 4 hours. …”
Get full text
Get full text

Foamed phase change materials based on recycled polyethylene/paraffin wax blends by Sobolčiak, Patrik

“…Differential Scanning Calorimetry was used to determine the specific enthalpies of melting (22.4–25.1 J/g) what is the latent heat of materials utilized during a heat absorption. A stability of samples during 10 heating/cooling cycles was demonstrated. …”
Get full text
Get full text