The Influence of Urbanization on Natural Overland Flow Paths by Al-Sayed, Amna Mohammed

Get full text
Get full text

Caffeine use or napping to enhance repeated sprint performance after partial sleep deprivation: Why not both? by Romdhani, Mohamed

“…Purpose: To compare the effect of a 20-minute nap opportunity (N20), a moderate dose of caffeine (CAF; 5 mg·kg-1), or a moderate dose of caffeine before N20 (CAF+N) as possible countermeasures to the decreased performance and the partial sleep deprivation-induced muscle damage. …”
Get full text
Get full text
Get full text

Experimental study on effective placement of PCM packets in cooling vest to improve performance in warm environment by Itani, Mariam

“…The used PCM melting temperature is 28 °C with a coverage area of 642 cm2 and total weight of the vest of 1.19 kg including 8 PCM packets (87.5 grams each). …”
Get full text
Get full text

Tailoring of the thermal, mechanical and dielectric properties of the polypropylene foams using gamma-irradiation by Mrl�k, Miroslav

Get full text
Get full text

Perinatal outcomes following Helping Babies Breathe training and regular peer-peer skills practice among village midwives in Sudan. by Arabi, Ame

“…Excluding 11 macerated fetuses, there were 55 perinatal deaths: 14 FSB/18 ENND (6 months pre-HBBT(+RPPSP)) and 10 FSB/13 ENND (18 months post-HBBT(+RPPSP)). FSB rates decreased from 10.5 to 3.3 per 1000 births ((χ(2))=8.6209, p=0.003), while ENND rates decreased from 13.5 to 4.3 per 1000 live births ((χ(2))=10.9369, p=0.001) pre-HBBT(+RPPSP) and post-HBBT(+RPPSP), respectively. …”
Get full text
Get full text

Assessment of SnO2 nanoparticles' impact on local Pichoclorum atomus growth performance, cell morphology and metabolites content by Bounnit, Touria

“…The current study investigates the ecotoxicity of SnO2 nanoparticles on a local marine algae isolate. Five different concentrations (1, 5, 25, 50 and 100mg/L) were tested and the culture was followed for 72h. …”
Get full text
Get full text

Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

“…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
Get full text

Novel fluorinated surfactants for enhanced oil recovery in carbonate reservoirs by Al-Amodi, Adel O.

“…A decrease in oil/water interfacial tension (IFT) of almost one order of magnitude was observed when adding surfactant‐A. …”
Get full text
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

SIRT1 may play a crucial role in overload-induced hypertrophy of skeletal muscle by Koltai, Erika

Get full text
Get full text

Superior photocatalytic activity of Cu doped NiWO4 for efficient degradation of benzene in air even under visible radiation by Tri N.L.M.

“…This was because Cu effectively acted as novel dopant, which not only affected valence band (VB) top and conduction band (CB) bottom of NiWO4 but also formed a medium energy level between CB and VB of the NiWO4 to decrease its energy band gap and electron-hole recombination rate. …”
Get full text
Get full text

Hypospadias Reconstruction Training: Development of an Ex-Vivo Model for Objective Evaluation of Surgical Skills by Abbas, Tariq

“…However, EMG measurements showed significant reductions in average EMG power, total time, dominant frequency, and cumulative muscle workload after training. Additionally, the mean power spectral density of the EMG signal decreased notably post-training. …”
Get full text
Get full text
Get full text

Roadmap toward energy-positive upfront nitrogen removal process in baseload LNG plant by Mkacher, Hajer

“…The results show that UNrem of 87.5% from the NG feed can reduce the total power requirements by 0.24%, increase the production flow rate by 4.4%, and decrease the exergy losses by 0.23% compared with the base case. …”
Get full text
Get full text

Improvement of both lipid and biomass productivities of Qatar Chlorocystis isolate for biodiesel production and food security by Saadaoui, Imen

“…Most previous research evidenced that the increase of the lipid content is accompanied by a decrease of the biomass production, which increases the cost of the downstream processing. …”
Get full text
Get full text

Recycled Polypropylene Fibres for Reinforcing Cement Mortar under Arid Conditions by Bendjillali, Khadra

Get full text
Get full text

Short-term greenhouse emission lowering effect of biochars from solid organic municipal wastes by Rehrah D.

“…A significant decrease in CO2 emission was observed in vials with soil–biochar mixtures, especially for biochars produced at 500 °C compared the corresponding raw materials which exhibited an exponential increase in the CO2 emission. …”
Get full text
Get full text

Trends in prevalence of depression and anxiety symptoms and effects of sociodemographic variables before and after the first wave of COVID-19 in Qatar by Khaled, Salma M.

“…The data for 2020/21 showed a 35.1% and 29.2% decrease in depression and anxiety symptoms scores compared to pre-pandemic years (2017/2018) after adjusting for sociodemographic factors. …”
Get full text
Get full text

Influence of shelf-life duration on mechanical, thermal and shape recovery motion derivatives of shape memory polyurethane by Vasavi, Boggarapu

“…In addition, Differential scanning calorimetry (DSC)exhibited a decrease in glass transition temperature (Tg) from S1 to S10, resulting in a corresponding reduction in the rate of shape restoration. …”
Get full text
Get full text
Get full text

Modeling of dual-metal Schottky contacts based silicon micro and nano wire solar cells by Rabbani, M. Golam

Get full text
Get full text

Hydrogen Production via Ethanol Decomposition over Bimetallic Catalyst by Ashok, Anchu

“…At higher value of φ, the reactive medium generates H2 rich reducing environment to convert metal oxide to metallic form Bimetallic CuCo were synthesized from the aqueous solution of cobalt nitrate (Co(NO3)2·6H2O), copper nitrate (Cu(NO3)2·6H2O) and glycine (C2H5NO2) in solution combustion synthesis (SCS) method using a fuel to oxidizer ratio of φ 0.5, 1, 1.75 and 2.5. …”
Get full text
Get full text