Novel fluorinated surfactants for enhanced oil recovery in carbonate reservoirs by Al-Amodi, Adel O.

“…A decrease in oil/water interfacial tension (IFT) of almost one order of magnitude was observed when adding surfactant‐A. …”
Get full text
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Prevalence of vincristine induced-peripheral neuropathy among Sudanese cancer patients by Imam, Ethar Abdelmageed

“…Healthcare professionals need some understanding regarding medical management that may decrease occurrence of neuropathy and a better planning and implementing special care for patients at risk.…”
Get full text
Get full text

Superior photocatalytic activity of Cu doped NiWO4 for efficient degradation of benzene in air even under visible radiation by Tri N.L.M.

“…This was because Cu effectively acted as novel dopant, which not only affected valence band (VB) top and conduction band (CB) bottom of NiWO4 but also formed a medium energy level between CB and VB of the NiWO4 to decrease its energy band gap and electron-hole recombination rate. …”
Get full text
Get full text

Roadmap toward energy-positive upfront nitrogen removal process in baseload LNG plant by Mkacher, Hajer

“…The results show that UNrem of 87.5% from the NG feed can reduce the total power requirements by 0.24%, increase the production flow rate by 4.4%, and decrease the exergy losses by 0.23% compared with the base case. …”
Get full text
Get full text

Improvement of both lipid and biomass productivities of Qatar Chlorocystis isolate for biodiesel production and food security by Saadaoui, Imen

“…Most previous research evidenced that the increase of the lipid content is accompanied by a decrease of the biomass production, which increases the cost of the downstream processing. …”
Get full text
Get full text

Recycled Polypropylene Fibres for Reinforcing Cement Mortar under Arid Conditions by Bendjillali, Khadra

Get full text
Get full text

Influence of shelf-life duration on mechanical, thermal and shape recovery motion derivatives of shape memory polyurethane by Vasavi, Boggarapu

“…In addition, Differential scanning calorimetry (DSC)exhibited a decrease in glass transition temperature (Tg) from S1 to S10, resulting in a corresponding reduction in the rate of shape restoration. …”
Get full text
Get full text
Get full text

Burden and trend of diet-related non-communicable diseases in Australia and comparison with 34 OECD countries, 1990-2015: findings from the Global Burden of Disease Study 2015. by Melaku, Yohannes Adama

“…In 2015, the estimated number of deaths attributable to dietary risks was 29,414 deaths [95% uncertainty interval (UI) 24,697 - 34,058 or 19.7% of NCD deaths] and 443,385 DALYs (95% UI 377,680-511,388 or 9.5% of NCD DALYs) in Australia. Young (25-49 years) and middle-age (50-69 years) male adults had a higher PAF of diet-related NCD deaths and DALYs than their female counterparts. …”
Get full text
Get full text

Modeling of dual-metal Schottky contacts based silicon micro and nano wire solar cells by Rabbani, M. Golam

Get full text
Get full text

Electrospun polylactic acid/date palm polyphenol extract nanofibres for tissue engineering applications by Khadija M., Zadeh

“…Increasing the polyphenol concentration caused the tensile strength and Young’s modulus to decrease. The SEM graphs indicated a decrease in fibre diameter with increasing DP content. …”
Get full text
Get full text

Undrained interface shear strength of fine-grained soils for near-shore marine pipelines by Eid, Hisham T.

“…The peak and residual interface shear strengths for a variety of normally consolidated soils were measured using a torsional ring shear apparatus modified to suit soil and interface testing under the undrained condition, which is usually prevalent at soil-marine pipeline interfaces. …”
Get full text
Get full text

Novel voltage balancing algorithm for single-phase cascaded multilevel inverter for post-module failure operation in solar photovoltaic applications by Rahman S.

Get full text
Get full text

Structural and electrochemical properties of electrodeposited Ni-P nanocomposite coatings containing mixed ceramic oxide particles by Zadeh, K.M.

Get full text
Get full text

Unlocking the application potential of electrocoagulation process through hybrid processes by Almukdad, Abdulkarim

Get full text
Get full text

An Overview of Solid Waste Management and Plastic Recycling in Qatar by Al-Maaded, M.

“…The analysis showed that Qatar produced around 2,000,000 tons of solid municipal waste annually, corresponding to a daily generation rate per capita of about 2. 5 kg. …”
Get full text
Get full text

Interface modification of compatibilized polyethylene terephthalate/polypropylene blends: Effect of compatibilization on thermomechanical properties and thermal stability by Inuwa, Ibrahim M.

“…PET, PP, and SEBS-g-MAH were melt-blended in a single stLGusing the counter rotating twin screw extruder with compatibilizer concentrations of 0, 5, 10, and 15 phr, respectively. …”
Get full text
Get full text

Enhanced quality factor of polyvinyl formal (PVF) based nanocomposites filled with zinc oxide and carbon black nanoparticles for wireless sensing applications by Mohanapriya, M.K.

“…The incorporation of ZnO at 10% decreases Q-factor to 36.1. Incorporation of CBNP at 5% and ZnO at 5% further reduces the Q-factor to 13.7. …”
Get full text
Get full text

Correlating the rheological and magneto-optical properties of cobalt substituted magnetite ferrofluids (CoxFe1?xFe2O4) with theoretical studies by Babukutty, B.

Get full text
Get full text

Development of pH-Controlled Aluminum-Based Polymeric Gel for Conformance Control in Sour Gas Reservoirs by Shamlooh M.

“…The results reveal that aluminum acetate, among the screened salts, has a controllable gelation time at pH conditions between 3.5 and 8.5 and is the most stable in the temperature range 25–100 °C. …”
Get full text
Get full text
Get full text