Search alternatives:
10 decrease » _ decrease (Expand Search)
nn decrease » _ decrease (Expand Search)
5 10 » _ 10 (Expand Search), a 10 (Expand Search), 9 10 (Expand Search)
10 decrease » _ decrease (Expand Search)
nn decrease » _ decrease (Expand Search)
5 10 » _ 10 (Expand Search), a 10 (Expand Search), 9 10 (Expand Search)
-
421
-
422
-
423
Effect Of Sand Blasting On Soda Lime Glass Properties
Published 2003“…The average strength remains almost constant while the dispersion becomes much reduced for the glass sand blasted during 60 minutes (m = 10.4 and smoy = 64 MPa). The variation of the relative efficiency of glass protected solar panels versus sand blasting duration (seen up to 300 min) shows a slow regular decrease until 0.91 for a 90° impact angle and until 0.95 for 30°. …”
Get full text
-
424
-
425
-
426
-
427
Mental health, burnout and resilience in community pharmacists during the COVID-19 pandemic: A cross-sectional study
Published 2022“…Resilience was assessed using the Connor-Davidson Resilience Scale-10 (CD-RISC-10). Depression, anxiety, and stress were measured by the Depression, Anxiety, and Stress Scale (DASS-21). …”
Get full text
Get full text
Get full text
-
428
Advanced Hard Ctings: Towards A Whole New World
Published 2014“…The main problem with steel, is that it exhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K. …”
Get full text
Get full text
-
429
Simulation and Optimization of an LNG Plant Cold Section
Published 2018“…Using the short cut method, optimization revealed that optimized MR composition resulted in almost 10% MR compression power and 6% plant operating cost savings, whereas new intermediate propane evaporation pressures, identified using detailed simulation, and flowrates decreased the propane compression power and operating costs by around 3.6%, and 2%, respectively. …”
Get full text
Get full text
-
430
-
431
Morphology and property changes in PLA/PHBV blends as function of blend composition
Published 2018“…Both the tensile strength and Young?s modulus decreased with increasing PHBV content for the sequence of blends, and both parameters exhibited maximum values for 10?…”
Get full text
Get full text
-
432
-
433
High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling
Published 2014“…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
Get full text
Get full text
-
434
-
435
-
436
-
437
-
438
-
439
-
440